linux-dev/arch/arm64/boot/dts/rockchip/Makefile, branch master

arm64: dts: rockchip: Add RK3399 NanoPi R4S Enterprise Edition

2022-09-16T10:53:44Z

The only diffrence against the standrard edition is that the enterprise one has a built-in EEPROM chip which stores a globally unique MAC address. Signed-off-by: Tianling Shen Link: https://lore.kernel.org/r/20220915022511.4267-2-cnsztl@gmail.com Signed-off-by: Heiko Stuebner

arm64: dts: rockchip: add Anbernic RG353P and RG503

2022-09-09T17:39:22Z

Anbernic RG353P and RG503 are both RK3566 based handheld gaming devices from Anbernic. Both devices have: - 2 SDMMC slots. - A Realtek rtl8821cs WiFi/Bluetooth adapter. - A mini HDMI port. - A USB C host port and a USB C otg port (currently only working as device). - Multiple GPIO buttons and a single ADC button. - Dual analog joysticks controlled via a GPIO mux. - A headphone jack with amplified stereo speakers via a SGM4865 amp. - A PWM based vibrator for force feedback. The RG353P has: - 2GB LPDDR4 RAM. - A 32GB eMMC. - A 3.5 inch 640x480 4-lane DSI panel of unknown origin with an i2c controlled touchscreen (touchscreen is a Hynitron CST340). The RG503 has: - 1GB LPDDR4 RAM. - A 5 inch 960x544 AMOLED 2-lane DSI/DBI panel manufactured by Samsung with part number ams495qa04. Data for this panel is provided via the DSI interface, however commands are sent via a 9-bit 3-wire SPI interface. The MISO pin of SPI3 of the SOC is wired to the input of the panel, so it must be bitbanged. This devicetree enables the following hardware: - HDMI (plus audio). - Analog audio, including speakers. - All buttons. - All SDMMC/eMMC/SDIO controllers. - The ADC joysticks (note a pending patch is required to use them). - WiFi/Bluetooth (note out of tree drivers are required). - The PWM based vibrator motor. The following hardware is not enabled: - The display panels (drivers are being written and there are issues with the upstream DSI and VOP2 subsystems). - Battery (driver pending). - Touchscreen on the RG353P (note the i2c2 bus is enabled for it). Signed-off-by: Chris Morgan Link: https://lore.kernel.org/r/20220906210324.28986-4-macroalpha82@gmail.com Signed-off-by: Heiko Stuebner

arm64: dts: rockchip: rk3399: Radxa ROCK 4C+

2022-09-05T10:10:21Z

Add support for Radxa ROCK 4C+ SBC. Key differences of 4C+ compared to previous ROCK Pi 4. - Rockchip RK3399-T SoC - DP from 4C replaced with micro HDMI 2K@60fps - 4-lane MIPI DSI with 1920*1080 - RK817 Audio codec Also, an official naming convention from Radxa mention to remove Pi from board name, so this 4C+ is named as Radxa ROCK 4C+ not Radxa ROCK Pi 4C+. Signed-off-by: Stephen Chen Signed-off-by: Manoj Sai Signed-off-by: Jagan Teki Link: https://lore.kernel.org/r/20220902065057.97425-3-jagan@amarulasolutions.com Signed-off-by: Heiko Stuebner

arm64: dts: rockchip: Add initial support for Pine64 PinePhone Pro

2022-09-04T16:23:36Z

This is a basic DT containing regulators and UART, intended to be a base that myself and others can add additional nodes in future patches. Tested to work: booting from eMMC/SD, output over UART. https://wiki.pine64.org/wiki/PinePhone_Pro This is derived from the community pine64-org repo[0] with fixes from https://megous.com/git/linux. 0. https://gitlab.com/pine64-org/linux/-/commit/261d3b5f8ac503f97da810986d1d6422430c8531 Signed-off-by: Martijn Braam Co-developed-by: Kamil Trzciński [no SoB, but Kamil is happy for this patch to be submitted] Co-developed-by: Ondrej Jirman Signed-off-by: Ondrej Jirman Co-developed-by: Tom Fitzhenry Signed-off-by: Tom Fitzhenry Reviewed-by: Caleb Connolly Reviewed-by: Nícolas F. R. A. Prado Tested-by: Nícolas F. R. A. Prado Link: https://lore.kernel.org/r/20220829050040.17330-2-tom@tom-fitzhenry.me.uk Signed-off-by: Heiko Stuebner

arm64: dts: rockchip: Add dts for a rk3399 based board EAIDK-610

2022-09-04T16:14:06Z

EAIDK-610 is from OPEN AI LAB and popularly used by university students. Specification: - Rockchip RK3399 - LPDDR3 4GB - TF sd scard slot - eMMC - AP6255 for WiFi + BT - Gigabit ethernet - HDMI out - 40 pin header - USB 2.0 x 2 - USB 3.0 x 1 - USB 3.0 Type-C x 1 - 12V DC Power supply This patch is test on Armbain and Glodroid with HDMI/GPU/USB HOST/Type-C ADB/WIFI/BT. Signed-off-by: Andy Yan Link: https://lore.kernel.org/r/20220709103016.2754044-1-andyshrk@163.com Signed-off-by: Heiko Stuebner

arm64: dts: rockchip: add ROCK Pi S DTS support

2022-06-17T17:05:11Z

ROCK Pi S is RK3308 based SBC from radxa.com. ROCK Pi S has a, - 256MB/512MB DDR3 RAM - SD, NAND flash (optional on board 1/2/4/8Gb) - 100MB ethernet, PoE (optional) - Onboard 802.11 b/g/n wifi + Bluetooth 4.0 Module - USB2.0 Type-A HOST x1 - USB3.0 Type-C OTG x1 - 26-pin expansion header - USB Type-C DC 5V Power Supply This patch enables - Console - NAND Flash - SD Card Signed-off-by: Akash Gajjar [sjoerd: Sort dt nodes, drop properties duplicated from dtsi] Signed-off-by: Sjoerd Simons Link: https://lore.kernel.org/r/20220614064858.1445817-3-sjoerd@collabora.com Signed-off-by: Heiko Stuebner

arm64: dts: rockchip: add dts for Firefly Station M2 rk3566

2022-05-01T13:03:05Z

Add dts for Firefly Station M2. Working IO: * UART * LED * LAN * Wifi * SD Card * eMMC * USB2 Signed-off-by: Furkan Kardame Signed-off-by: Peter Geis Link: https://lore.kernel.org/r/20220429115252.2360496-8-pgwipeout@gmail.com Signed-off-by: Heiko Stuebner

arm64: dts: rockchip: add SoQuartz CM4IO dts

2022-05-01T13:03:01Z

This is the initial SoQuartz SoM device tree on a CM4IO carrier board. This board outputs debug on uart2 and supports the following components: Gigabit Ethernet USB2 (OTG/Host shared) PCIe 2.0 x1 HDMI (HDMI Port 0) eDP (HDMI Port 1) DSI (RPi compatible pinout) CSI (RPi compatible pinout) A/B/G/N WiFi Bluetooth SDMMC eMMC SPI NOR Flash (Not placed) PI-40 compatible pin header Signed-off-by: Peter Geis Link: https://lore.kernel.org/r/20220429115252.2360496-7-pgwipeout@gmail.com Signed-off-by: Heiko Stuebner

arm64: dts: rockchip: add Pine64 Quartz64-B device tree

2022-05-01T13:02:58Z

Add a device tree for the Pine64 Quartz64 Model B single board computer. This board ouputs debug on uart2 and supports the following components: Gigabit Ethernet USB2 x2 (one port otg capable) USB3 PCIe/SATA M2 HDMI DSI (RPi compatible pinout) CSI (RPi compatible pinout) A/B/G/N WiFi Bluetooth SDMMC eMMC SPI Flash PI-40 compatible pin header Signed-off-by: Peter Geis Link: https://lore.kernel.org/r/20220429115252.2360496-6-pgwipeout@gmail.com Signed-off-by: Heiko Stuebner

arm64: dts: rockchip: add basic dts for the radxa rock3 model a

2022-04-10T16:35:33Z

Add basic device tree for the Radxa ROCK3 Model A board (with the Rockchip RK3568 SoC) including Ethernet, USB2 and headphone connector. Signed-off-by: Michael Riesch Link: https://lore.kernel.org/r/20220310210352.451136-3-michael.riesch@wolfvision.net Signed-off-by: Heiko Stuebner