linux-dev/drivers/bus/Kconfig, branch master

bus: add driver for initializing the SSC bus on (some) qcom SoCs

2022-04-19T18:03:57Z

Add bindings for the AHB bus which exposes the SSC (Snapdragon Sensor Core) block in the global address space. This bus (and the SSC block itself) is present on certain qcom SoCs. In typical configuration, this bus (as some of the clocks and registers that we need to manipulate) is not accessible to Linux, and the resources on this bus are indirectly accessed by communicating with a hexagon CPU core residing in the SSC block. In this configuration, the hypervisor is the one performing the bus initialization for the purposes of bringing the hexagon CPU core out of reset. However, it is possible to change the configuration, in which case this driver will initialize the bus. In combination with drivers for resources on the SSC bus, this driver can aid in debugging, and for example with a TLMM driver can be used to directly access SSC-dedicated GPIO pins, removing the need to commit to a particular usecase during hw design. Finally, until open firmware for the hexagon core is available, this approach allows for using sensors hooked up to SSC-dedicated GPIO pins on mainline Linux simply by utilizing the existing in-tree drivers for these sensors. Signed-off-by: Michael Srba Reviewed-by: Jeffrey Hugo Signed-off-by: Bjorn Andersson Link: https://lore.kernel.org/r/20220411072156.24451-5-michael.srba@seznam.cz

Merge tag 'drivers-5.16' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

2021-11-04T00:00:52Z

Pull ARM SoC driver updates from Arnd Bergmann: "These are all the driver updates for SoC specific drivers. There are a couple of subsystems with individual maintainers picking up their patches here: - The reset controller subsystem add support for a few new SoC variants to existing drivers, along with other minor improvements - The OP-TEE subsystem gets a driver for the ARM FF-A transport - The memory controller subsystem has improvements for Tegra, Mediatek, Renesas, Freescale and Broadcom specific drivers. - The tegra cpuidle driver changes get merged through this tree this time. There are only minor changes, but they depend on other tegra driver updates here. - The ep93xx platform finally moves to using the drivers/clk/ subsystem, moving the code out of arch/arm in the process. This depends on a small sound driver change that is included here as well. - There are some minor updates for Qualcomm and Tegra specific firmware drivers. The other driver updates are mainly for drivers/soc, which contains a mixture of vendor specific drivers that don't really fit elsewhere: - Mediatek drivers gain more support for MT8192, with new support for hw-mutex and mmsys routing, plus support for reset lines in the mmsys driver. - Qualcomm gains a new "sleep stats" driver, and support for the "Generic Packet Router" in the APR driver. - There is a new user interface for routing the UARTS on ASpeed BMCs, something that apparently nobody else has needed so far. - More drivers can now be built as loadable modules, in particular for Broadcom and Samsung platforms. - Lots of improvements to the TI sysc driver for better suspend/resume support" Finally, there are lots of minor cleanups and new device IDs for amlogic, renesas, tegra, qualcomm, mediateka, samsung, imx, layerscape, allwinner, broadcom, and omap" * tag 'drivers-5.16' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (179 commits) optee: Fix spelling mistake "reclain" -> "reclaim" Revert "firmware: qcom: scm: Add support for MC boot address API" qcom: spm: allow compile-testing firmware: arm_ffa: Remove unused 'compat_version' variable soc: samsung: exynos-chipid: add exynosautov9 SoC support firmware: qcom: scm: Don't break compile test on non-ARM platforms soc: qcom: smp2p: Add of_node_put() before goto soc: qcom: apr: Add of_node_put() before return soc: qcom: qcom_stats: Fix client votes offset soc: qcom: rpmhpd: fix sm8350_mxc's peer domain dt-bindings: arm: cpus: Document qcom,msm8916-smp enable-method ARM: qcom: Add qcom,msm8916-smp enable-method identical to MSM8226 firmware: qcom: scm: Add support for MC boot address API soc: qcom: spm: Add 8916 SPM register data dt-bindings: soc: qcom: spm: Document qcom,msm8916-saw2-v3.0-cpu soc: qcom: socinfo: Add PM8150C and SMB2351 models firmware: qcom_scm: Fix error retval in __qcom_scm_is_call_available() soc: aspeed: Add UART routing support soc: fsl: dpio: rename the enqueue descriptor variable soc: fsl: dpio: use an explicit NULL instead of 0 ...

drivers: bus: Delete CONFIG_SIMPLE_PM_BUS

2021-10-05T15:47:22Z

The simple-pm-bus driver is mandatory for CONFIG_OF based platforms to work with fw_devlink. So, always compile it in for CONFIG_OF and delete the config since it's no longer necessary. Tested-by: Ulf Hansson Tested-by: Geert Uytterhoeven Tested-by: Damien Le Moal Cc: Rob Herring Signed-off-by: Saravana Kannan Link: https://lore.kernel.org/r/20210929000735.585237-3-saravanak@google.com Signed-off-by: Greg Kroah-Hartman

bus: brcmstb_gisb: Allow building as module

2021-09-27T21:04:08Z

Allow building the Broadcom STB GISB arbiter driver as a module, however similar to interrupt controller drivers, don't allow its unbind/removal since it is not quite prepared for that and we want it to catch bus errors all the time. Signed-off-by: Florian Fainelli

bus: ixp4xx: Add a driver for IXP4xx expansion bus

2021-08-04T10:20:06Z

The Intel IXP4xx SoCs have an expansion bus that is usually just used for flash memory and configured by the boot loaders and can be accessed using the "simple-bus". However some devices need more elaborate configuration and then we need to provide a proper 3-unit address space indicating chip select for each device and provide timing and similar information. Cc: Marc Zyngier Signed-off-by: Linus Walleij

c6x: remove architecture

2021-01-20T08:30:45Z

The c6x architecture was added to the kernel in 2011 at a time when running Linux on DSPs was widely seen as the logical evolution. It appears the trend has gone back to running Linux on Arm based SoCs with DSP, using a better supported software ecosystem, and having better real-time behavior for the DSP code. An example of this is TI's own Keystone2 platform. The upstream kernel port appears to no longer have any users. Mark Salter remained avaialable to review patches, but mentioned that he no longer has access to working hardware himself. Without any users, it's best to just remove the code completely to reduce the work for cross-architecture code changes. Many thanks to Mark for maintaining the code for the past ten years. Link: https://lore.kernel.org/lkml/41dc7795afda9f776d8cd0d3075f776cf586e97c.camel@redhat.com/ Signed-off-by: Arnd Bergmann

bus: cdmm: Add MIPS R5 arch support

2020-07-21T08:25:42Z

CDMM may be available not only on MIPS R2 architectures, but also on newer MIPS R5 chips. For instance our P5600 chip has one. Let's mark the CDMM bus being supported for that MIPS arch too. Signed-off-by: Serge Semin Reviewed-by: Thomas Bogendoerfer Signed-off-by: Thomas Bogendoerfer

Merge tag 'arm-drivers-5.8' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

2020-06-05T02:56:20Z

Pull ARM/SoC driver updates from Arnd Bergmann: "These are updates to SoC specific drivers that did not have another subsystem maintainer tree to go through for some reason: - Some bus and memory drivers for the MIPS P5600 based Baikal-T1 SoC that is getting added through the MIPS tree. - There are new soc_device identification drivers for TI K3, Qualcomm MSM8939 - New reset controller drivers for NXP i.MX8MP, Renesas RZ/G1H, and Hisilicon hi6220 - The SCMI firmware interface can now work across ARM SMC/HVC as a transport. - Mediatek platforms now use a new driver for their "MMSYS" hardware block that controls clocks and some other aspects in behalf of the media and gpu drivers. - Some Tegra processors have improved power management support, including getting woken up by the PMIC and cluster power down during idle. - A new v4l staging driver for Tegra is added. - Cleanups and minor bugfixes for TI, NXP, Hisilicon, Mediatek, and Tegra" * tag 'arm-drivers-5.8' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (155 commits) clk: sprd: fix compile-testing bus: bt1-axi: Build the driver into the kernel bus: bt1-apb: Build the driver into the kernel bus: bt1-axi: Use sysfs_streq instead of strncmp bus: bt1-axi: Optimize the return points in the driver bus: bt1-apb: Use sysfs_streq instead of strncmp bus: bt1-apb: Use PTR_ERR_OR_ZERO to return from request-regs method bus: bt1-apb: Fix show/store callback identations bus: bt1-apb: Include linux/io.h dt-bindings: memory: Add Baikal-T1 L2-cache Control Block binding memory: Add Baikal-T1 L2-cache Control Block driver bus: Add Baikal-T1 APB-bus driver bus: Add Baikal-T1 AXI-bus driver dt-bindings: bus: Add Baikal-T1 APB-bus binding dt-bindings: bus: Add Baikal-T1 AXI-bus binding staging: tegra-video: fix V4L2 dependency tee: fix crypto select drivers: soc: ti: knav_qmss_queue: Make knav_gp_range_ops static soc: ti: add k3 platforms chipid module driver dt-bindings: soc: ti: add binding for k3 platforms chipid module ...

bus: bt1-axi: Build the driver into the kernel

2020-05-28T20:17:02Z

Alas the method trigger_all_cpu_backtrace() isn't exported by the kernel, but we need to have it called in case of the bus errors detected to get a better description of a possible cause of the error. Let's disable the ability to build the driver as a loadable kernel module then. Note In future the driver will support the AXI-bus interconnect capability, so we'd have to make it built into the kernel anyway. Link: https://lore.kernel.org/r/20200528193113.17372-2-Sergey.Semin@baikalelectronics.ru Signed-off-by: Serge Semin Cc: Alexey Malahov Cc: Olof Johansson Cc: soc@kernel.org Signed-off-by: Arnd Bergmann

bus: bt1-apb: Build the driver into the kernel

2020-05-28T20:16:58Z

Seeing trigger_all_cpu_backtrace() isn't exported from the kernel and since calling it is a very important part of driver, which may provide a better description of a possible cause of the error, let's disable the ability to build the driver as a loadable kernel module. Link: https://lore.kernel.org/r/20200528193113.17372-1-Sergey.Semin@baikalelectronics.ru Signed-off-by: Serge Semin Cc: Alexey Malahov Cc: Olof Johansson Cc: soc@kernel.org Signed-off-by: Arnd Bergmann