linux-dev/drivers/bus/mhi/host, branch master

Merge tag 'char-misc-6.1-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/char-misc

2022-10-08T15:56:37Z

Pull char/misc and other driver updates from Greg KH: "Here is the large set of char/misc and other small driver subsystem changes for 6.1-rc1. Loads of different things in here: - IIO driver updates, additions, and changes. Probably the largest part of the diffstat - habanalabs driver update with support for new hardware and features, the second largest part of the diff. - fpga subsystem driver updates and additions - mhi subsystem updates - Coresight driver updates - gnss subsystem updates - extcon driver updates - icc subsystem updates - fsi subsystem updates - nvmem subsystem and driver updates - misc driver updates - speakup driver additions for new features - lots of tiny driver updates and cleanups All of these have been in the linux-next tree for a while with no reported issues" * tag 'char-misc-6.1-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/char-misc: (411 commits) w1: Split memcpy() of struct cn_msg flexible array spmi: pmic-arb: increase SPMI transaction timeout delay spmi: pmic-arb: block access for invalid PMIC arbiter v5 SPMI writes spmi: pmic-arb: correct duplicate APID to PPID mapping logic spmi: pmic-arb: add support to dispatch interrupt based on IRQ status spmi: pmic-arb: check apid against limits before calling irq handler spmi: pmic-arb: do not ack and clear peripheral interrupts in cleanup_irq spmi: pmic-arb: handle spurious interrupt spmi: pmic-arb: add a print in cleanup_irq drivers: spmi: Directly use ida_alloc()/free() MAINTAINERS: add TI ECAP driver info counter: ti-ecap-capture: capture driver support for ECAP Documentation: ABI: sysfs-bus-counter: add frequency & num_overflows items dt-bindings: counter: add ti,am62-ecap-capture.yaml counter: Introduce the COUNTER_COMP_ARRAY component type counter: Consolidate Counter extension sysfs attribute creation counter: Introduce the Count capture component counter: 104-quad-8: Add Signal polarity component counter: Introduce the Signal polarity component counter: interrupt-cnt: Implement watch_validate callback ...

Merge tag 'mhi-for-v6.1' of git://git.kernel.org/pub/scm/linux/kernel/git/mani/mhi into char-misc-next

2022-09-21T13:43:35Z

Manivannan writes: "MHI Host -------- - Print the modem name while probing the MHI host pci-generic driver. This has been exposed as a debug information so far but on a low storate embedded devices such as OpenWRT based products, this helps in identifying the attached modem without enabling the debug logs." * tag 'mhi-for-v6.1' of git://git.kernel.org/pub/scm/linux/kernel/git/mani/mhi: bus: mhi: host: always print detected modem name

bus: mhi: host: pci_generic: Add a secondary AT port to Telit FN990

2022-09-20T23:07:12Z

Add a secondary AT port using one of OEM reserved channel. Signed-off-by: Fabio Porcedda Reviewed-by: Loic Poulain Signed-off-by: Jakub Kicinski

bus: mhi: host: always print detected modem name

2022-09-16T08:08:25Z

This harmless print provides a very easy way of knowing if the modem is detected properly during probing. Promote it to an informational print so no hassle is required enabling kernel debugging info to obtain it. The rationale here is that: On a lot of low-storage embedded devices, extensive kernel debugging info is not always present as this would increase it's size to much causing partition size issues. Signed-off-by: Koen Vandeputte Reviewed-by: Manivannan Sadhasivam Reviewed-by: Loic Poulain Link: https://lore.kernel.org/r/20220831100349.1488762-1-koen.vandeputte@citymesh.com [mani: added missing review tags] Signed-off-by: Manivannan Sadhasivam

bus: mhi: host: Fix up null pointer access in mhi_irq_handler

2022-08-29T17:03:46Z

The irq handler for a shared IRQ ought to be prepared for running even now it's being freed. So let's check the pointer used by mhi_irq_handler to avoid null pointer access since it is probably released before freeing IRQ. Fixes: 1227d2a20cd7 ("bus: mhi: host: Move IRQ allocation to controller registration phase") Signed-off-by: Qiang Yu Reviewed-by: Manivannan Sadhasivam Tested-by: Kalle Valo Link: https://lore.kernel.org/r/1658459838-30802-1-git-send-email-quic_qianyu@quicinc.com [mani: added fixes tag] Signed-off-by: Manivannan Sadhasivam

bus: mhi: host: pci_generic: Add another Foxconn T99W175

2022-06-29T10:37:25Z

The Foxconn e0c3 device identifies itself as a T99W175 X55, add support for this to the pci_generic driver. Signed-off-by: Bjorn Andersson Reviewed-by: Manivannan Sadhasivam Link: https://lore.kernel.org/r/20220627170717.2252335-1-bjorn.andersson@linaro.org Signed-off-by: Manivannan Sadhasivam

bus: mhi: host: Move IRQ allocation to controller registration phase

2022-06-24T07:24:19Z

During runtime, the MHI endpoint may be powered up/down several times. So instead of allocating and destroying the IRQs all the time, let's just enable/disable IRQs during power up/down. The IRQs will be allocated during mhi_register_controller() and freed during mhi_unregister_controller(). This works well for things like PCI hotplug also as once the PCI device gets removed, the controller will get unregistered. And once it comes back, it will get registered back and even if the IRQ configuration changes (MSI), that will get accounted. Signed-off-by: Qiang Yu Reviewed-by: Jeffrey Hugo Reviewed-by: Manivannan Sadhasivam Link: https://lore.kernel.org/r/1655952183-66792-1-git-send-email-quic_qianyu@quicinc.com Signed-off-by: Manivannan Sadhasivam

bus: mhi: host: pci_generic: Add Cinterion MV31-W with new baseline

2022-06-22T16:25:00Z

Cinterion MV31-W modem with a new baseline (firmware) is sold as a separate product with different device ID. So add support for the same reusing the config. Signed-off-by: Slark Xiao Reviewed-by: Manivannan Sadhasivam Link: https://lore.kernel.org/r/20220622032544.17713-1-slark_xiao@163.com Signed-off-by: Manivannan Sadhasivam

bus: mhi: host: pci_generic: Add support for Quectel EM120 FCCL modem

2022-06-21T13:01:51Z

The product's enumeration align with previous Quectel EM120R-GL, so the EM120 FCCL would use the same config as Quectel EM120R-GL. Signed-off-by: Yonglin Tan Reviewed-by: Manivannan Sadhasivam Reviewed-by: Loic Poulain Link: https://lore.kernel.org/r/MEYP282MB2374837FFCB18B12BFDEDE80FDCF9@MEYP282MB2374.AUSP282.PROD.OUTLOOK.COM [mani: added pci_generic prefix to subject and aligned the commit message] Signed-off-by: Manivannan Sadhasivam

Merge tag 'mhi-for-v5.19' of git://git.kernel.org/pub/scm/linux/kernel/git/mani/mhi into char-work-next

2022-05-19T14:55:13Z

Manivannan writes: MHI changes for v5.19 MHI Host -------- Support for new modems: - Foxconn Cinterion MV32-WA/MV32-WB based on SDX62/SDX65 - Telit FN980 v1 based on SDX55 - Telit FN990 based on SDX65 - Foxconn T99W373/T99W368 based on SDX62/SDX65 Core changes: - During the recycle of event ring elements, compute the ctxt_wp based on the local cached value instead of reading from shared memory. This is to prevent the possible corruption of the ctxt_wp as some of the endpoint devices could modify the value in shared memory. - Add sysfs support for resetting the endpoint based on the MHI spec. The MHI spec allows the host to hard reset the device in the case of an unrecoverable error and all other reset mechanisms have failed. - During MHI shutdown, wait for the endpoint device to enter the ready state post reset before proceeding. This is to avoid a possible race where host would remove the interrupt handler and device will send ready state interrupt, resulting in IOMMU fault. - Bail out updating the MHI register if the read has failed during read/modify/write. - Use mhi_write_reg() instead of mhi_write_reg_field() for writing the whole register fields in mhi_init_mmio(). MAINTAINERS change: - Since Qualcomm has moved the email domain for its employess from codeaurora domain to quicinc, update the same for Hemant. * tag 'mhi-for-v5.19' of git://git.kernel.org/pub/scm/linux/kernel/git/mani/mhi: (29 commits) bus: mhi: host: Add support for Foxconn T99W373 and T99W368 bus: mhi: host: pci_generic: add Telit FN990 bus: mhi: host: pci_generic: add Telit FN980 v1 hardware revision bus: mhi: host: Add support for Cinterion MV32-WA/MV32-WB bus: mhi: host: Optimize and update MMIO register write method bus: mhi: host: Bail on writing register fields if read fails bus: mhi: host: Wait for ready state after reset bus: mhi: host: Add soc_reset sysfs bus: mhi: host: pci_generic: Sort mhi_pci_id_table based on the PID bus: mhi: host: Use cached values for calculating the shared write pointer MAINTAINERS: Update Hemant's email id bus: mhi: ep: Add uevent support for module autoloading bus: mhi: ep: Add support for suspending and resuming channels bus: mhi: ep: Add support for queueing SKBs to the host bus: mhi: ep: Add support for processing channel rings bus: mhi: ep: Add support for reading from the host bus: mhi: ep: Add support for processing command rings bus: mhi: ep: Add support for handling SYS_ERR condition bus: mhi: ep: Add support for handling MHI_RESET bus: mhi: ep: Add support for powering down the MHI endpoint stack ...