linux-dev/drivers/net/wireless/ath5k, branch master

atheros: put atheros wireless drivers into ath/

2009-04-22T20:54:38Z

Signed-off-by: Luis R. Rodriguez Signed-off-by: John W. Linville

ath5k: use regulatory infrastructure

2009-04-22T20:54:37Z

Make ath5k select the ath module and add in the hooks to make the eeprom regulatory hint and reg notifier take effect. Changes to attach.c Changes-licensed-under: ISC Changes to base.c Changes-licensed-under: 3-Clause-BSD Signed-off-by: Bob Copeland Signed-off-by: John W. Linville

ath5k: reduce exported channel list

2009-04-22T20:54:35Z

Claiming every available 5 ghz channel has a couple of negative side-effects: scanning takes a long time, and the channel list overflows the available buffer space for netlink commands, resulting in: $ iw phy phy0 info command failed: No buffer space available (-105) This patch adds a modparam so people who want to see all the channels can do so by passing all_channels=1. By default users will see a smaller list of channels. This also halves scan time, from 10 seconds down to less than 5 when using world regulatory. Changes-licensed-under: 3-Clause-BSD Signed-off-by: Bob Copeland Reported-by: Simon Farnsworth Tested-By: Simon Farnsworth Signed-off-by: John W. Linville

ath5k: fix scanning in AR2424

2009-04-22T20:54:29Z

AR5K_PHY_PLL_40MHZ_5413 should not be ORed with AR5K_PHY_MODE_RAD_RF5112 for 5 GHz channels. The incorrect PLL value breaks scanning in the countries where 5 GHz channels are allowed. Signed-off-by: Pavel Roskin Acked-by: Nick Kossifidis Signed-off-by: John W. Linville

drivers/net: replace BUG() with BUG_ON() if possible

2009-04-13T22:44:36Z

Signed-off-by: Alexander Beregalov Signed-off-by: David S. Miller

dma-mapping: replace all DMA_32BIT_MASK macro with DMA_BIT_MASK(32)

2009-04-07T15:31:11Z

Replace all DMA_32BIT_MASK macro with DMA_BIT_MASK(32) Signed-off-by: Yang Hongyang Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

ath5k: properly drop packets from ops->tx

2009-03-28T00:13:19Z

We shouldn't return NETDEV_TX_BUSY from the TX callback, especially after we've mucked with the sk_buffs. Drop the packets and return NETDEV_TX_OK. Changes-licensed-under: 3-Clause-BSD Signed-off-by: Bob Copeland Signed-off-by: John W. Linville

ath5k: warn and correct rate for unknown hw rate indexes

2009-03-28T00:13:18Z

ath5k sets up a mapping table from the hardware rate index to the rate index used by mac80211; however, we have seen some received frames with incorrect rate indexes. Such frames normally get dropped with a warning in __ieee80211_rx(), but it doesn't include enough information to track down the error. This patch adds a warning to hw_to_driver_rix for any lookups that result in a rate index of -1, then returns a valid rate so the frame can be processed. Changes-licensed-under: 3-Clause-BSD Signed-off-by: Bob Copeland Cc: stable@kernel.org Signed-off-by: John W. Linville

ath5k: Support LED's on Acer Extensa 5620z

2009-03-28T00:13:10Z

Add vendor ID for Quanta Microsystems and update the led table with the reported device. Reported-by: Scott Barnes Signed-off-by: Tulio Magno Quites Machado Filho Signed-off-by: John W. Linville

ath5k: Add tx power calibration support

2009-03-28T00:12:56Z

* Add tx power calibration support * Add a few tx power limits * Hardcode default power to 12.5dB * Disable TPC for now v2: Address Jiri's comments Signed-off-by: Nick Kossifidis Signed-off-by: John W. Linville