ARM: OMAP1: Use generic map_io, init_early and init_irq

This allows removing omap hacks for map_io allowing generic
map_io.

Note that in the future we can't do cpu_is_omapxxxx detection
until in init_early. This means that board-innovator.c now
assumes 15xx only, and board-generic.c assumes 16xx only.
This is best fixed later on by passing the SoC type from
device tree.

Signed-off-by: Tony Lindgren <tony@atomide.com>

1 files changed, 25 insertions, 31 deletions

diff --git a/arch/arm/mach-omap1/io.c b/arch/arm/mach-omap1/io.c
index 870886a29594..a16aab71922c 100644
--- a/arch/arm/mach-omap1/io.c
+++ b/arch/arm/mach-omap1/io.c
@@ -85,50 +85,44 @@ static struct map_desc omap16xx_io_desc[] __initdata = {
 #endif
 
 /*
- * Maps common IO regions for omap1. This should only get called from
- * board specific init.
+ * Maps common IO regions for omap1
  */
-void __init omap1_map_common_io(void)
+static void __init omap1_map_common_io(void)
 {
 	iotable_init(omap_io_desc, ARRAY_SIZE(omap_io_desc));
-
-	/* Normally devicemaps_init() would flush caches and tlb after
-	 * mdesc->map_io(), but we must also do it here because of the CPU
-	 * revision check below.
-	 */
-	local_flush_tlb_all();
-	flush_cache_all();
-
-	/* We want to check CPU revision early for cpu_is_omapxxxx() macros.
-	 * IO space mapping must be initialized before we can do that.
-	 */
-	omap_check_revision();
+}
 
 #if defined (CONFIG_ARCH_OMAP730) || defined (CONFIG_ARCH_OMAP850)
-	if (cpu_is_omap7xx()) {
-		iotable_init(omap7xx_io_desc, ARRAY_SIZE(omap7xx_io_desc));
-	}
+void __init omap7xx_map_io(void)
+{
+	omap1_map_common_io();
+	iotable_init(omap7xx_io_desc, ARRAY_SIZE(omap7xx_io_desc));
+}
 #endif
+
 #ifdef CONFIG_ARCH_OMAP15XX
-	if (cpu_is_omap15xx()) {
-		iotable_init(omap1510_io_desc, ARRAY_SIZE(omap1510_io_desc));
-	}
-#endif
-#if defined(CONFIG_ARCH_OMAP16XX)
-	if (cpu_is_omap16xx()) {
-		iotable_init(omap16xx_io_desc, ARRAY_SIZE(omap16xx_io_desc));
-	}
+void __init omap15xx_map_io(void)
+{
+	omap1_map_common_io();
+	iotable_init(omap1510_io_desc, ARRAY_SIZE(omap1510_io_desc));
+}
 #endif
 
-	omap_sram_init();
+#if defined(CONFIG_ARCH_OMAP16XX)
+void __init omap16xx_map_io(void)
+{
+	omap1_map_common_io();
+	iotable_init(omap16xx_io_desc, ARRAY_SIZE(omap16xx_io_desc));
 }
+#endif
 
 /*
- * Common low-level hardware init for omap1. This should only get called from
- * board specific init.
+ * Common low-level hardware init for omap1.
  */
-void __init omap1_init_common_hw(void)
+void omap1_init_early(void)
 {
+	omap_check_revision();
+
 	/* REVISIT: Refer to OMAP5910 Errata, Advisory SYS_1: "Timeout Abort
 	 * on a Posted Write in the TIPB Bridge".
 	 */
@@ -138,8 +132,8 @@ void __init omap1_init_common_hw(void)
 	/* Must init clocks early to assure that timer interrupt works
 	 */
 	omap1_clk_init();
-
 	omap1_mux_init();
+	omap_sram_init();
 }
 
 /*