diff options
| author |   Sander Vanheule <sander@svanheule.net> | 2021-03-30 19:48:43 +0200 |
|---|---|---|
| committer |   Bartosz Golaszewski <bgolaszewski@baylibre.com> | 2021-05-05 16:07:40 +0200 |
| commit | 0d82fb1127fb7cc8287614eb0992acb0583bc323 (patch) | |
| tree | 49ff43f5c5bb86f1b7cb4a95c9ba6ed690b254cb /drivers/gpio/Makefile | |
| parent | dt-bindings: gpio: Binding for Realtek Otto GPIO (diff) | |
| download | linux-dev-0d82fb1127fb7cc8287614eb0992acb0583bc323.tar.xz linux-dev-0d82fb1127fb7cc8287614eb0992acb0583bc323.zip | |
gpio: Add Realtek Otto GPIO support
Realtek MIPS SoCs (platform name Otto) have GPIO controllers with up to
64 GPIOs, divided over two banks. Each bank has a set of registers for
32 GPIOs, with support for edge-triggered interrupts.
Each GPIO bank consists of four 8-bit GPIO ports (ABCD and EFGH). Most
registers pack one bit per GPIO, except for the IMR register, which
packs two bits per GPIO (AB-CD).
Although the byte order is currently assumed to have port A..D at offset
0x0..0x3, this has been observed to be reversed on other, Lexra-based,
SoCs (e.g. RTL8196E/97D/97F).
Interrupt support is disabled for the fallback devicetree-compatible
'realtek,otto-gpio'. This allows for quick support of GPIO banks in
which the byte order would be unknown. In this case, the port ordering
in the IMR registers may not match the reversed order in the other
registers (DCBA, and BA-DC or DC-BA).
Signed-off-by: Sander Vanheule <sander@svanheule.net>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>
Diffstat (limited to 'drivers/gpio/Makefile')
| -rw-r--r-- | drivers/gpio/Makefile | 1 |
1 files changed, 1 insertions, 0 deletions
diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile index c58a90a3c3b1..8ace5934e3c3 100644 --- a/drivers/gpio/Makefile +++ b/drivers/gpio/Makefile @@ -124,6 +124,7 @@ obj-$(CONFIG_GPIO_RC5T583) += gpio-rc5t583.o obj-$(CONFIG_GPIO_RCAR) += gpio-rcar.o obj-$(CONFIG_GPIO_RDA) += gpio-rda.o obj-$(CONFIG_GPIO_RDC321X) += gpio-rdc321x.o +obj-$(CONFIG_GPIO_REALTEK_OTTO) += gpio-realtek-otto.o obj-$(CONFIG_GPIO_REG) += gpio-reg.o obj-$(CONFIG_ARCH_SA1100) += gpio-sa1100.o obj-$(CONFIG_GPIO_SAMA5D2_PIOBU) += gpio-sama5d2-piobu.o |