enetc: Add mdio bus driver for the PCIe MDIO endpoint

ENETC ports can manage the MDIO bus via local register
interface.  However there's also a centralized way
to manage the MDIO bus, via the MDIO PCIe endpoint
device integrated by the same root complex that also
integrates the ENETC ports (eth controllers).

Depending on board design and use case, centralized
access to MDIO may be better than using local ENETC
port registers.  For instance, on the LS1028A QDS board
where MDIO muxing is required.  Also, the LS1028A on-chip
switch doesn't have a local MDIO register interface.

The current patch registers the above PCIe endpoint as a
separate MDIO bus and provides a driver for it by re-using
the code used for local MDIO access.  It also allows the
ENETC port PHYs to be managed by this driver if the local
"mdio" node is missing from the ENETC port node.

Signed-off-by: Claudiu Manoil <claudiu.manoil@nxp.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 4 insertions, 1 deletions

diff --git a/drivers/net/ethernet/freescale/enetc/enetc_pf.c b/drivers/net/ethernet/freescale/enetc/enetc_pf.c
index 258b3cb38a6f..7d6513ff8507 100644
--- a/drivers/net/ethernet/freescale/enetc/enetc_pf.c
+++ b/drivers/net/ethernet/freescale/enetc/enetc_pf.c
@@ -750,6 +750,7 @@ static int enetc_of_get_phy(struct enetc_ndev_priv *priv)
 {
 	struct enetc_pf *pf = enetc_si_priv(priv->si);
 	struct device_node *np = priv->dev->of_node;
+	struct device_node *mdio_np;
 	int err;
 
 	if (!np) {
@@ -773,7 +774,9 @@ static int enetc_of_get_phy(struct enetc_ndev_priv *priv)
 		priv->phy_node = of_node_get(np);
 	}
 
-	if (!of_phy_is_fixed_link(np)) {
+	mdio_np = of_get_child_by_name(np, "mdio");
+	if (mdio_np) {
+		of_node_put(mdio_np);
 		err = enetc_mdio_probe(pf);
 		if (err) {
 			of_node_put(priv->phy_node);