1 files changed, 51 insertions, 0 deletions
diff --git a/Documentation/admin-guide/gpio/gpio-mockup.rst b/Documentation/admin-guide/gpio/gpio-mockup.rst
new file mode 100644
index 000000000000..493071da1738
--- /dev/null
+++ b/Documentation/admin-guide/gpio/gpio-mockup.rst
@@ -0,0 +1,51 @@
+.. SPDX-License-Identifier: GPL-2.0-only
+
+GPIO Testing Driver
+===================
+
+The GPIO Testing Driver (gpio-mockup) provides a way to create simulated GPIO
+chips for testing purposes. The lines exposed by these chips can be accessed
+using the standard GPIO character device interface as well as manipulated
+using the dedicated debugfs directory structure.
+
+Creating simulated chips using module params
+--------------------------------------------
+
+When loading the gpio-mockup driver a number of parameters can be passed to the
+module.
+
+    gpio_mockup_ranges
+
+        This parameter takes an argument in the form of an array of integer
+        pairs. Each pair defines the base GPIO number (non-negative integer)
+        and the first number after the last of this chip. If the base GPIO
+        is -1, the gpiolib will assign it automatically. while the following
+        parameter is the number of lines exposed by the chip.
+
+        Example: gpio_mockup_ranges=-1,8,-1,16,405,409
+
+        The line above creates three chips. The first one will expose 8 lines,
+        the second 16 and the third 4. The base GPIO for the third chip is set
+        to 405 while for two first chips it will be assigned automatically.
+
+    gpio_mockup_named_lines
+
+        This parameter doesn't take any arguments. It lets the driver know that
+        GPIO lines exposed by it should be named.
+
+        The name format is: gpio-mockup-X-Y where X is mockup chip's ID
+        and Y is the line offset.
+
+Manipulating simulated lines
+----------------------------
+
+Each mockup chip creates its own subdirectory in /sys/kernel/debug/gpio-mockup/.
+The directory is named after the chip's label. A symlink is also created, named
+after the chip's name, which points to the label directory.
+
+Inside each subdirectory, there's a separate attribute for each GPIO line. The
+name of the attribute represents the line's offset in the chip.
+
+Reading from a line attribute returns the current value. Writing to it (0 or 1)
+changes the configuration of the simulated pull-up/pull-down resistor
+(1 - pull-up, 0 - pull-down).