diff options
Diffstat (limited to 'Documentation/arm/Samsung-S3C24XX/USB-Host.txt')
| -rw-r--r-- | Documentation/arm/Samsung-S3C24XX/USB-Host.txt | 93 |
1 files changed, 0 insertions, 93 deletions
diff --git a/Documentation/arm/Samsung-S3C24XX/USB-Host.txt b/Documentation/arm/Samsung-S3C24XX/USB-Host.txt deleted file mode 100644 index f82b1faefad5..000000000000 --- a/Documentation/arm/Samsung-S3C24XX/USB-Host.txt +++ /dev/null @@ -1,93 +0,0 @@ - S3C24XX USB Host support - ======================== - - - -Introduction ------------- - - This document details the S3C2410/S3C2440 in-built OHCI USB host support. - -Configuration -------------- - - Enable at least the following kernel options: - - menuconfig: - - Device Drivers ---> - USB support ---> - <*> Support for Host-side USB - <*> OHCI HCD support - - - .config: - CONFIG_USB - CONFIG_USB_OHCI_HCD - - - Once these options are configured, the standard set of USB device - drivers can be configured and used. - - -Board Support -------------- - - The driver attaches to a platform device, which will need to be - added by the board specific support file in linux/arch/arm/mach-s3c2410, - such as mach-bast.c or mach-smdk2410.c - - The platform device's platform_data field is only needed if the - board implements extra power control or over-current monitoring. - - The OHCI driver does not ensure the state of the S3C2410's MISCCTRL - register, so if both ports are to be used for the host, then it is - the board support file's responsibility to ensure that the second - port is configured to be connected to the OHCI core. - - -Platform Data -------------- - - See arch/arm/mach-s3c2410/include/mach/usb-control.h for the - descriptions of the platform device data. An implementation - can be found in linux/arch/arm/mach-s3c2410/usb-simtec.c . - - The `struct s3c2410_hcd_info` contains a pair of functions - that get called to enable over-current detection, and to - control the port power status. - - The ports are numbered 0 and 1. - - power_control: - - Called to enable or disable the power on the port. - - enable_oc: - - Called to enable or disable the over-current monitoring. - This should claim or release the resources being used to - check the power condition on the port, such as an IRQ. - - report_oc: - - The OHCI driver fills this field in for the over-current code - to call when there is a change to the over-current state on - an port. The ports argument is a bitmask of 1 bit per port, - with bit X being 1 for an over-current on port X. - - The function s3c2410_usb_report_oc() has been provided to - ensure this is called correctly. - - port[x]: - - This is struct describes each port, 0 or 1. The platform driver - should set the flags field of each port to S3C_HCDFLG_USED if - the port is enabled. - - - -Document Author ---------------- - -Ben Dooks, Copyright 2005 Simtec Electronics |