diff options
Diffstat (limited to '')
| -rw-r--r-- | Documentation/devicetree/bindings/display/panel/olimex,lcd-olinuxino.txt | 42 |
1 files changed, 0 insertions, 42 deletions
diff --git a/Documentation/devicetree/bindings/display/panel/olimex,lcd-olinuxino.txt b/Documentation/devicetree/bindings/display/panel/olimex,lcd-olinuxino.txt deleted file mode 100644 index a89f9c830a85..000000000000 --- a/Documentation/devicetree/bindings/display/panel/olimex,lcd-olinuxino.txt +++ /dev/null @@ -1,42 +0,0 @@ -Binding for Olimex Ltd. LCD-OLinuXino bridge panel. - -This device can be used as bridge between a host controller and LCD panels. -Currently supported LCDs are: - - LCD-OLinuXino-4.3TS - - LCD-OLinuXino-5 - - LCD-OLinuXino-7 - - LCD-OLinuXino-10 - -The panel itself contains: - - AT24C16C EEPROM holding panel identification and timing requirements - - AR1021 resistive touch screen controller (optional) - - FT5x6 capacitive touch screnn controller (optional) - - GT911/GT928 capacitive touch screen controller (optional) - -The above chips share same I2C bus. The EEPROM is factory preprogrammed with -device information (id, serial, etc.) and timing requirements. - -Touchscreen bingings can be found in these files: - - input/touchscreen/goodix.txt - - input/touchscreen/edt-ft5x06.txt - - input/touchscreen/ar1021.txt - -Required properties: - - compatible: should be "olimex,lcd-olinuxino" - - reg: address of the configuration EEPROM, should be <0x50> - - power-supply: phandle of the regulator that provides the supply voltage - -Optional properties: - - enable-gpios: GPIO pin to enable or disable the panel - - backlight: phandle of the backlight device attacked to the panel - -Example: -&i2c2 { - panel@50 { - compatible = "olimex,lcd-olinuxino"; - reg = <0x50>; - power-supply = <®_vcc5v0>; - enable-gpios = <&pio 7 8 GPIO_ACTIVE_HIGH>; - backlight = <&backlight>; - }; -}; |