diff options
Diffstat (limited to '')
-rw-r--r-- | Documentation/devicetree/bindings/mfd/bd9571mwv.txt | 69 |
1 files changed, 0 insertions, 69 deletions
diff --git a/Documentation/devicetree/bindings/mfd/bd9571mwv.txt b/Documentation/devicetree/bindings/mfd/bd9571mwv.txt deleted file mode 100644 index 1d6413e96c37..000000000000 --- a/Documentation/devicetree/bindings/mfd/bd9571mwv.txt +++ /dev/null @@ -1,69 +0,0 @@ -* ROHM BD9571MWV/BD9574MWF Power Management Integrated Circuit (PMIC) bindings - -Required properties: - - compatible : Should be "rohm,bd9571mwv" or "rohm,bd9574mwf". - - reg : I2C slave address. - - interrupts : The interrupt line the device is connected to. - - interrupt-controller : Marks the device node as an interrupt controller. - - #interrupt-cells : The number of cells to describe an IRQ, should be 2. - The first cell is the IRQ number. - The second cell is the flags, encoded as trigger - masks from ../interrupt-controller/interrupts.txt. - - gpio-controller : Marks the device node as a GPIO Controller. - - #gpio-cells : Should be two. The first cell is the pin number and - the second cell is used to specify flags. - See ../gpio/gpio.txt for more information. - - regulators: : List of child nodes that specify the regulator - initialization data. Child nodes must be named - after their hardware counterparts: - - vd09 - - vd18 - - vd25 - - vd33 - - dvfs - Each child node is defined using the standard - binding for regulators. - -Optional properties: - - rohm,ddr-backup-power : Value to use for DDR-Backup Power (default 0). - This is a bitmask that specifies which DDR power - rails need to be kept powered when backup mode is - entered, for system suspend: - - bit 0: DDR0 - - bit 1: DDR1 - - bit 2: DDR0C - - bit 3: DDR1C - These bits match the KEEPON_DDR* bits in the - documentation for the "BKUP Mode Cnt" register. - - rohm,rstbmode-level: The RSTB signal is configured for level mode, to - accommodate a toggle power switch (the RSTBMODE pin is - strapped low). - - rohm,rstbmode-pulse: The RSTB signal is configured for pulse mode, to - accommodate a momentary power switch (the RSTBMODE pin - is strapped high). - The two properties above are mutually exclusive. - -Example: - - pmic: pmic@30 { - compatible = "rohm,bd9571mwv"; - reg = <0x30>; - interrupt-parent = <&gpio2>; - interrupts = <0 IRQ_TYPE_LEVEL_LOW>; - interrupt-controller; - #interrupt-cells = <2>; - gpio-controller; - #gpio-cells = <2>; - rohm,ddr-backup-power = <0xf>; - rohm,rstbmode-pulse; - - regulators { - dvfs: dvfs { - regulator-name = "dvfs"; - regulator-min-microvolt = <750000>; - regulator-max-microvolt = <1030000>; - regulator-boot-on; - regulator-always-on; - }; - }; - }; |