diff options
Diffstat (limited to 'Documentation/devicetree/bindings/net/mediatek-bluetooth.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/net/mediatek-bluetooth.txt | 17 |
1 files changed, 17 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/net/mediatek-bluetooth.txt b/Documentation/devicetree/bindings/net/mediatek-bluetooth.txt index 41a7dcc80f5b..112011c51d5e 100644 --- a/Documentation/devicetree/bindings/net/mediatek-bluetooth.txt +++ b/Documentation/devicetree/bindings/net/mediatek-bluetooth.txt @@ -50,16 +50,33 @@ Required properties: "mediatek,mt7663u-bluetooth": for MT7663U device "mediatek,mt7668u-bluetooth": for MT7668U device - vcc-supply: Main voltage regulator + +If the pin controller on the platform can support both pinmux and GPIO +control such as the most of MediaTek platform. Please use below properties. + - pinctrl-names: Should be "default", "runtime" - pinctrl-0: Should contain UART RXD low when the device is powered up to enter proper bootstrap mode. - pinctrl-1: Should contain UART mode pin ctrl +Else, the pin controller on the platform only can support pinmux control and +the GPIO control still has to rely on the dedicated GPIO controller such as +a legacy MediaTek SoC, MT7621. Please use the below properties. + +- boot-gpios: GPIO same to the pin as UART RXD and used to keep LOW when + the device is powered up to enter proper bootstrap mode when +- pinctrl-names: Should be "default" +- pinctrl-0: Should contain UART mode pin ctrl + Optional properties: - reset-gpios: GPIO used to reset the device whose initial state keeps low, if the GPIO is missing, then board-level design should be guaranteed. +- clocks: Should be the clock specifiers corresponding to the entry in + clock-names property. If the clock is missing, then board-level + design should be guaranteed. +- clock-names: Should contain "osc" entry for the external oscillator. - current-speed: Current baud rate of the device whose defaults to 921600 Example: |