diff options
Diffstat (limited to '')
-rw-r--r-- | Documentation/devicetree/bindings/power/reset/gpio-poweroff.txt | 41 |
1 files changed, 0 insertions, 41 deletions
diff --git a/Documentation/devicetree/bindings/power/reset/gpio-poweroff.txt b/Documentation/devicetree/bindings/power/reset/gpio-poweroff.txt deleted file mode 100644 index 3e56c1b34a4c..000000000000 --- a/Documentation/devicetree/bindings/power/reset/gpio-poweroff.txt +++ /dev/null @@ -1,41 +0,0 @@ -Driver a GPIO line that can be used to turn the power off. - -The driver supports both level triggered and edge triggered power off. -At driver load time, the driver will request the given gpio line and -install a handler to power off the system. If the optional properties -'input' is not found, the GPIO line will be driven in the inactive -state. Otherwise its configured as an input. - -When the power-off handler is called, the gpio is configured as an -output, and drive active, so triggering a level triggered power off -condition. This will also cause an inactive->active edge condition, so -triggering positive edge triggered power off. After a delay of 100ms, -the GPIO is set to inactive, thus causing an active->inactive edge, -triggering negative edge triggered power off. After another 100ms -delay the GPIO is driver active again. If the power is still on and -the CPU still running after a 3000ms delay, a WARN_ON(1) is emitted. - -Required properties: -- compatible : should be "gpio-poweroff". -- gpios : The GPIO to set high/low, see "gpios property" in - Documentation/devicetree/bindings/gpio/gpio.txt. If the pin should be - low to power down the board set it to "Active Low", otherwise set - gpio to "Active High". - -Optional properties: -- input : Initially configure the GPIO line as an input. Only reconfigure - it to an output when the power-off handler is called. If this optional - property is not specified, the GPIO is initialized as an output in its - inactive state. -- active-delay-ms: Delay (default 100) to wait after driving gpio active -- inactive-delay-ms: Delay (default 100) to wait after driving gpio inactive -- timeout-ms: Time to wait before asserting a WARN_ON(1). If nothing is - specified, 3000 ms is used. - -Examples: - -gpio-poweroff { - compatible = "gpio-poweroff"; - gpios = <&gpio 4 0>; - timeout-ms = <3000>; -}; |