diff options
Diffstat (limited to '')
| -rw-r--r-- | Documentation/firmware-guide/acpi/enumeration.rst | 16 |
1 files changed, 8 insertions, 8 deletions
diff --git a/Documentation/firmware-guide/acpi/enumeration.rst b/Documentation/firmware-guide/acpi/enumeration.rst index dbb03022b127..b9dc0c603f36 100644 --- a/Documentation/firmware-guide/acpi/enumeration.rst +++ b/Documentation/firmware-guide/acpi/enumeration.rst @@ -21,7 +21,7 @@ possible we decided to do following: - Devices behind real busses where there is a connector resource are represented as struct spi_device or struct i2c_device. Note that standard UARTs are not busses so there is no struct uart_device, - although some of them may be represented by sturct serdev_device. + although some of them may be represented by struct serdev_device. As both ACPI and Device Tree represent a tree of devices (and their resources) this implementation follows the Device Tree way as much as @@ -205,7 +205,7 @@ Here is what the ACPI namespace for a SPI slave might look like:: } ... -The SPI device drivers only need to add ACPI IDs in a similar way than with +The SPI device drivers only need to add ACPI IDs in a similar way to the platform device drivers. Below is an example where we add ACPI support to at25 SPI eeprom driver (this is meant for the above ACPI snippet):: @@ -362,7 +362,7 @@ These GPIO numbers are controller relative and path "\\_SB.PCI0.GPI0" specifies the path to the controller. In order to use these GPIOs in Linux we need to translate them to the corresponding Linux GPIO descriptors. -There is a standard GPIO API for that and is documented in +There is a standard GPIO API for that and it is documented in Documentation/admin-guide/gpio/. In the above example we can get the corresponding two GPIO descriptors with @@ -538,8 +538,8 @@ information. PCI hierarchy representation ============================ -Sometimes could be useful to enumerate a PCI device, knowing its position on the -PCI bus. +Sometimes it could be useful to enumerate a PCI device, knowing its position on +the PCI bus. For example, some systems use PCI devices soldered directly on the mother board, in a fixed position (ethernet, Wi-Fi, serial ports, etc.). In this conditions it @@ -550,7 +550,7 @@ To identify a PCI device, a complete hierarchical description is required, from the chipset root port to the final device, through all the intermediate bridges/switches of the board. -For example, let us assume to have a system with a PCIe serial port, an +For example, let's assume we have a system with a PCIe serial port, an Exar XR17V3521, soldered on the main board. This UART chip also includes 16 GPIOs and we want to add the property ``gpio-line-names`` [1] to these pins. In this case, the ``lspci`` output for this component is:: @@ -593,8 +593,8 @@ of the chipset bridge (also called "root port") with address:: Bus: 0 - Device: 14 - Function: 1 -To find this information is necessary disassemble the BIOS ACPI tables, in -particular the DSDT (see also [2]):: +To find this information, it is necessary to disassemble the BIOS ACPI tables, +in particular the DSDT (see also [2]):: mkdir ~/tables/ cd ~/tables/ |