diff options
Diffstat (limited to '')
| -rw-r--r-- | Documentation/networking/batman-adv.txt | 27 |
1 files changed, 14 insertions, 13 deletions
diff --git a/Documentation/networking/batman-adv.txt b/Documentation/networking/batman-adv.txt index 77f0cdd5b0dd..88d4afbdef98 100644 --- a/Documentation/networking/batman-adv.txt +++ b/Documentation/networking/batman-adv.txt @@ -1,4 +1,4 @@ -[state: 21-11-2010] +[state: 17-04-2011] BATMAN-ADV ---------- @@ -19,6 +19,7 @@ duce the overhead to a minimum. It does not depend on any (other) network driver, and can be used on wifi as well as ethernet lan, vpn, etc ... (anything with ethernet-style layer 2). + CONFIGURATION ------------- @@ -67,15 +68,16 @@ All mesh wide settings can be found in batman's own interface folder: # ls /sys/class/net/bat0/mesh/ -# aggregated_ogms bonding fragmentation orig_interval -# vis_mode +# aggregated_ogms gw_bandwidth hop_penalty +# bonding gw_mode orig_interval +# fragmentation gw_sel_class vis_mode -There is a special folder for debugging informations: +There is a special folder for debugging information: # ls /sys/kernel/debug/batman_adv/bat0/ -# originators socket transtable_global transtable_local -# vis_data +# gateways socket transtable_global vis_data +# originators softif_neigh transtable_local Some of the files contain all sort of status information regard- @@ -159,13 +161,13 @@ face. Each entry can/has to have the following values: -> "TQ mac value" - src mac's link quality towards mac address of a neighbor originator's interface which is being used for routing --> "HNA mac" - HNA announced by source mac +-> "TT mac" - TT announced by source mac -> "PRIMARY" - this is a primary interface -> "SEC mac" - secondary mac address of source (requires preceding PRIMARY) The TQ value has a range from 4 to 255 with 255 being the best. -The HNA entries are showing which hosts are connected to the mesh +The TT entries are showing which hosts are connected to the mesh via bat0 or being bridged into the mesh network. The PRIMARY/SEC values are only applied on primary interfaces @@ -198,7 +200,7 @@ abled during run time. Following log_levels are defined: 0 - All debug output disabled 1 - Enable messages related to routing / flooding / broadcasting -2 - Enable route or hna added / changed / deleted +2 - Enable route or tt entry added / changed / deleted 3 - Enable all messages The debug output can be changed at runtime using the file @@ -206,7 +208,7 @@ The debug output can be changed at runtime using the file # echo 2 > /sys/class/net/bat0/mesh/log_level -will enable debug messages for when routes or HNAs change. +will enable debug messages for when routes or TTs change. BATCTL @@ -230,9 +232,8 @@ CONTACT Please send us comments, experiences, questions, anything :) IRC: #batman on irc.freenode.org -Mailing-list: b.a.t.m.a.n@b.a.t.m.a.n@lists.open-mesh.org - (optional subscription at - https://lists.open-mesh.org/mm/listinfo/b.a.t.m.a.n) +Mailing-list: b.a.t.m.a.n@open-mesh.org (optional subscription + at https://lists.open-mesh.org/mm/listinfo/b.a.t.m.a.n) You can also contact the Authors: |