aboutsummaryrefslogtreecommitdiffstats
path: root/Documentation/sound/oss/Soundblaster
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/sound/oss/Soundblaster')
-rw-r--r--Documentation/sound/oss/Soundblaster53
1 files changed, 0 insertions, 53 deletions
diff --git a/Documentation/sound/oss/Soundblaster b/Documentation/sound/oss/Soundblaster
deleted file mode 100644
index b288d464ba8b..000000000000
--- a/Documentation/sound/oss/Soundblaster
+++ /dev/null
@@ -1,53 +0,0 @@
-modprobe sound
-insmod uart401
-insmod sb ...
-
-This loads the driver for the Sound Blaster and assorted clones. Cards that
-are covered by other drivers should not be using this driver.
-
-The Sound Blaster module takes the following arguments
-
-io I/O address of the Sound Blaster chip (0x220,0x240,0x260,0x280)
-irq IRQ of the Sound Blaster chip (5,7,9,10)
-dma 8-bit DMA channel for the Sound Blaster (0,1,3)
-dma16 16-bit DMA channel for SB16 and equivalent cards (5,6,7)
-mpu_io I/O for MPU chip if present (0x300,0x330)
-
-sm_games=1 Set if you have a Logitech soundman games
-acer=1 Set this to detect cards in some ACER notebooks
-mwave_bug=1 Set if you are trying to use this driver with mwave (see on)
-type Use this to specify a specific card type
-
-The following arguments are taken if ISAPnP support is compiled in
-
-isapnp=0 Set this to disable ISAPnP detection (use io=0xXXX etc. above)
-multiple=0 Set to disable detection of multiple Soundblaster cards.
- Consider it a bug if this option is needed, and send in a
- report.
-pnplegacy=1 Set this to be able to use a PnP card(s) along with a single
- non-PnP (legacy) card. Above options for io, irq, etc. are
- needed, and will apply only to the legacy card.
-reverse=1 Reverses the order of the search in the PnP table.
-uart401=1 Set to enable detection of mpu devices on some clones.
-isapnpjump=n Jumps to slot n in the driver's PnP table. Use the source,
- Luke.
-
-You may well want to load the opl3 driver for synth music on most SB and
-clone SB devices
-
-insmod opl3 io=0x388
-
-Using Mwave
-
-To make this driver work with Mwave you must set mwave_bug. You also need
-to warm boot from DOS/Windows with the required firmware loaded under this
-OS. IBM are being difficult about documenting how to load this firmware.
-
-Avance Logic ALS007
-
-This card is supported; see the separate file ALS007 for full details.
-
-Avance Logic ALS100
-
-This card is supported; setup should be as for a standard Sound Blaster 16.
-The driver will identify the audio device as a "Sound Blaster 16 (ALS-100)".