diff options
Diffstat (limited to 'arch/arc/plat-axs10x/axs10x.c')
| -rw-r--r-- | arch/arc/plat-axs10x/axs10x.c | 27 |
1 files changed, 18 insertions, 9 deletions
diff --git a/arch/arc/plat-axs10x/axs10x.c b/arch/arc/plat-axs10x/axs10x.c index 99f7da513a48..1b0f0f458a2b 100644 --- a/arch/arc/plat-axs10x/axs10x.c +++ b/arch/arc/plat-axs10x/axs10x.c @@ -46,7 +46,7 @@ static void __init axs10x_enable_gpio_intc_wire(void) * ------------------- ------------------- * | snps,dw-apb-gpio | | snps,dw-apb-gpio | * ------------------- ------------------- - * | | + * | #12 | * | [ Debug UART on cpu card ] * | * ------------------------ @@ -389,6 +389,23 @@ axs103_set_freq(unsigned int id, unsigned int fd, unsigned int od) static void __init axs103_early_init(void) { + /* + * AXS103 configurations for SMP/QUAD configurations share device tree + * which defaults to 90 MHz. However recent failures of Quad config + * revealed P&R timing violations so clamp it down to safe 50 MHz + * Instead of duplicating defconfig/DT for SMP/QUAD, add a small hack + * + * This hack is really hacky as of now. Fix it properly by getting the + * number of cores as return value of platform's early SMP callback + */ +#ifdef CONFIG_ARC_MCIP + unsigned int num_cores = (read_aux_reg(ARC_REG_MCIP_BCR) >> 16) & 0x3F; + if (num_cores > 2) + arc_set_core_freq(50 * 1000000); + else if (num_cores == 2) + arc_set_core_freq(75 * 1000000); +#endif + switch (arc_get_core_freq()/1000000) { case 33: axs103_set_freq(1, 1, 1); @@ -438,11 +455,6 @@ static void __init axs103_early_init(void) axs10x_print_board_ver(AXC003_CREG + 4088, "AXC003 CPU Card"); axs10x_early_init(); - -#ifdef CONFIG_ARC_MCIP - /* No Hardware init, but filling the smp ops callbacks */ - mcip_init_early_smp(); -#endif } #endif @@ -470,9 +482,6 @@ static const char *axs103_compat[] __initconst = { MACHINE_START(AXS103, "axs103") .dt_compat = axs103_compat, .init_early = axs103_early_init, -#ifdef CONFIG_ARC_MCIP - .init_smp = mcip_init_smp, -#endif MACHINE_END /* |