diff options
Diffstat (limited to 'arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi')
| -rw-r--r-- | arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi | 133 |
1 files changed, 107 insertions, 26 deletions
diff --git a/arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi b/arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi index db3e2239eee8..83bcf9fe0152 100644 --- a/arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi +++ b/arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi @@ -17,6 +17,10 @@ model = "Microchip SAMA5D27 WLSOM1"; compatible = "microchip,sama5d27-wlsom1", "atmel,sama5d27", "atmel,sama5d2", "atmel,sama5"; + aliases { + i2c0 = &i2c0; + }; + clocks { slow_xtal { clock-frequency = <32768>; @@ -26,24 +30,20 @@ clock-frequency = <24000000>; }; }; + + wifi_pwrseq: wifi_pwrseq { + compatible = "mmc-pwrseq-wilc1000"; + reset-gpios = <&pioA PIN_PA27 GPIO_ACTIVE_HIGH>; + powerdown-gpios = <&pioA PIN_PA29 GPIO_ACTIVE_HIGH>; + pinctrl-0 = <&pinctrl_wilc_pwrseq>; + pinctrl-names = "default"; + }; }; &flx1 { atmel,flexcom-mode = <ATMEL_FLEXCOM_MODE_USART>; uart6: serial@200 { - compatible = "atmel,at91sam9260-usart"; - reg = <0x200 0x200>; - interrupts = <20 IRQ_TYPE_LEVEL_HIGH 7>; - dmas = <&dma0 - (AT91_XDMAC_DT_MEM_IF(0) | AT91_XDMAC_DT_PER_IF(1) | - AT91_XDMAC_DT_PERID(13))>, - <&dma0 - (AT91_XDMAC_DT_MEM_IF(0) | AT91_XDMAC_DT_PER_IF(1) | - AT91_XDMAC_DT_PERID(14))>; - dma-names = "tx", "rx"; - clocks = <&pmc PMC_TYPE_PERIPHERAL 20>; - clock-names = "usart"; pinctrl-0 = <&pinctrl_flx1_default>; pinctrl-names = "default"; }; @@ -51,14 +51,20 @@ &i2c0 { pinctrl-0 = <&pinctrl_i2c0_default>; - pinctrl-names = "default"; + pinctrl-1 = <&pinctrl_i2c0_gpio>; + pinctrl-names = "default", "gpio"; + sda-gpios = <&pioA PIN_PD21 GPIO_ACTIVE_HIGH>; + scl-gpios = <&pioA PIN_PD22 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>; status = "okay"; }; &i2c1 { dmas = <0>, <0>; - pinctrl-names = "default"; + pinctrl-names = "default", "gpio"; pinctrl-0 = <&pinctrl_i2c1_default>; + pinctrl-1 = <&pinctrl_i2c1_gpio>; + sda-gpios = <&pioA PIN_PD19 GPIO_ACTIVE_HIGH>; + scl-gpios = <&pioA PIN_PD20 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>; status = "okay"; mcp16502@5b { @@ -70,8 +76,8 @@ regulators { vdd_3v3: VDD_IO { regulator-name = "VDD_IO"; - regulator-min-microvolt = <1200000>; - regulator-max-microvolt = <3700000>; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; regulator-initial-mode = <2>; regulator-allowed-modes = <2>, <4>; regulator-always-on; @@ -89,8 +95,8 @@ vddio_ddr: VDD_DDR { regulator-name = "VDD_DDR"; - regulator-min-microvolt = <600000>; - regulator-max-microvolt = <1850000>; + regulator-min-microvolt = <1200000>; + regulator-max-microvolt = <1200000>; regulator-initial-mode = <2>; regulator-allowed-modes = <2>, <4>; regulator-always-on; @@ -112,8 +118,8 @@ vdd_core: VDD_CORE { regulator-name = "VDD_CORE"; - regulator-min-microvolt = <600000>; - regulator-max-microvolt = <1850000>; + regulator-min-microvolt = <1250000>; + regulator-max-microvolt = <1250000>; regulator-initial-mode = <2>; regulator-allowed-modes = <2>, <4>; regulator-always-on; @@ -154,8 +160,8 @@ LDO1 { regulator-name = "LDO1"; - regulator-min-microvolt = <1200000>; - regulator-max-microvolt = <3700000>; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; regulator-always-on; regulator-state-standby { @@ -169,9 +175,8 @@ LDO2 { regulator-name = "LDO2"; - regulator-min-microvolt = <1200000>; - regulator-max-microvolt = <3700000>; - regulator-always-on; + regulator-min-microvolt = <1800000>; + regulator-max-microvolt = <3300000>; regulator-state-standby { regulator-on-in-suspend; @@ -188,6 +193,8 @@ &macb0 { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_macb0_default>; + #address-cells = <1>; + #size-cells = <0>; phy-mode = "rmii"; ethernet-phy@0 { @@ -208,7 +215,7 @@ pinctrl-0 = <&pinctrl_qspi1_default>; status = "disabled"; - qspi1_flash: spi_flash@0 { + qspi1_flash: flash@0 { #address-cells = <1>; #size-cells = <1>; compatible = "jedec,spi-nor"; @@ -266,12 +273,24 @@ bias-disable; }; + pinctrl_i2c0_gpio: i2c0_gpio { + pinmux = <PIN_PD21__GPIO>, + <PIN_PD22__GPIO>; + bias-disable; + }; + pinctrl_i2c1_default: i2c1_default { pinmux = <PIN_PD19__TWD1>, <PIN_PD20__TWCK1>; bias-disable; }; + pinctrl_i2c1_gpio: i2c1_gpio { + pinmux = <PIN_PD19__GPIO>, + <PIN_PD20__GPIO>; + bias-disable; + }; + pinctrl_macb0_default: macb0_default { pinmux = <PIN_PB14__GTXCK>, <PIN_PB15__GTXEN>, @@ -300,5 +319,67 @@ <PIN_PB10__QSPI1_IO3>; bias-pull-up; }; + + pinctrl_sdmmc1_default: sdmmc1_default { + cmd-data { + pinmux = <PIN_PA28__SDMMC1_CMD>, + <PIN_PA18__SDMMC1_DAT0>, + <PIN_PA19__SDMMC1_DAT1>, + <PIN_PA20__SDMMC1_DAT2>, + <PIN_PA21__SDMMC1_DAT3>; + bias-disable; + }; + + conf-ck { + pinmux = <PIN_PA22__SDMMC1_CK>; + bias-disable; + }; + }; + + pinctrl_wilc_default: wilc_default { + conf-irq { + pinmux = <PIN_PB25__GPIO>; + bias-disable; + }; + }; + + pinctrl_wilc_pwrseq: wilc_pwrseq { + conf-ce-nrst { + pinmux = <PIN_PA27__GPIO>, + <PIN_PA29__GPIO>; + bias-disable; + }; + + conf-rtcclk { + pinmux = <PIN_PB13__PCK1>; + bias-disable; + }; + }; +}; + +&sdmmc1 { + #address-cells = <1>; + #size-cells = <0>; + bus-width = <4>; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_sdmmc1_default>; + mmc-pwrseq = <&wifi_pwrseq>; + no-1-8-v; + non-removable; + bus-width = <4>; + status = "okay"; + + wilc: wifi@0 { + reg = <0>; + compatible = "microchip,wilc1000"; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_wilc_default>; + clocks = <&pmc PMC_TYPE_SYSTEM 9>; + clock-names = "rtc"; + interrupts = <PIN_PB25 IRQ_TYPE_NONE>; + interrupt-parent = <&pioA>; + assigned-clocks = <&pmc PMC_TYPE_SYSTEM 9>; + assigned-clock-rates = <32768>; + }; }; |