diff options
Diffstat (limited to 'arch/arm/boot/dts/omap4.dtsi')
| -rw-r--r-- | arch/arm/boot/dts/omap4.dtsi | 183 |
1 files changed, 176 insertions, 7 deletions
diff --git a/arch/arm/boot/dts/omap4.dtsi b/arch/arm/boot/dts/omap4.dtsi index d3f8a6e8ca20..7e26d222bfe3 100644 --- a/arch/arm/boot/dts/omap4.dtsi +++ b/arch/arm/boot/dts/omap4.dtsi @@ -36,6 +36,11 @@ device_type = "cpu"; next-level-cache = <&L2>; reg = <0x0>; + + clocks = <&dpll_mpu_ck>; + clock-names = "cpu"; + + clock-latency = <300000>; /* From omap-cpufreq driver */ }; cpu@1 { compatible = "arm,cortex-a9"; @@ -62,12 +67,13 @@ local-timer@48240600 { compatible = "arm,cortex-a9-twd-timer"; + clocks = <&mpu_periphclk>; reg = <0x48240600 0x20>; interrupts = <GIC_PPI 13 (GIC_CPU_MASK_RAW(3) | IRQ_TYPE_LEVEL_HIGH)>; }; /* - * The soc node represents the soc top level view. It is uses for IPs + * The soc node represents the soc top level view. It is used for IPs * that are not memory mapped in the MPU view or for the MPU itself. */ soc { @@ -91,7 +97,7 @@ /* * XXX: Use a flat representation of the OMAP4 interconnect. * The real OMAP interconnect network is quite complex. - * Since that will not bring real advantage to represent that in DT for + * Since it will not bring real advantage to represent that in DT for * the moment, just use a fake OCP bus entry to represent the whole bus * hierarchy. */ @@ -186,6 +192,22 @@ pinctrl-single,function-mask = <0x7fff>; }; + omap4_padconf_global: tisyscon@4a1005a0 { + compatible = "syscon"; + reg = <0x4a1005a0 0x170>; + }; + + pbias_regulator: pbias_regulator { + compatible = "ti,pbias-omap"; + reg = <0x60 0x4>; + syscon = <&omap4_padconf_global>; + pbias_mmc_reg: pbias_mmc_omap4 { + regulator-name = "pbias_mmc_omap4"; + regulator-min-microvolt = <1800000>; + regulator-max-microvolt = <3000000>; + }; + }; + sdma: dma-controller@4a056000 { compatible = "ti,omap4430-sdma"; reg = <0x4a056000 0x1000>; @@ -275,6 +297,8 @@ gpmc,num-waitpins = <4>; ti,hwmods = "gpmc"; ti,no-idle-on-init; + clocks = <&l3_div_ck>; + clock-names = "fck"; }; uart1: serial@4806a000 { @@ -288,7 +312,7 @@ uart2: serial@4806c000 { compatible = "ti,omap4-uart"; reg = <0x4806c000 0x100>; - interrupts = <GIC_SPI 73 IRQ_TYPE_LEVEL_HIGH>; + interrupts-extended = <&gic GIC_SPI 73 IRQ_TYPE_LEVEL_HIGH>; ti,hwmods = "uart2"; clock-frequency = <48000000>; }; @@ -296,7 +320,7 @@ uart3: serial@48020000 { compatible = "ti,omap4-uart"; reg = <0x48020000 0x100>; - interrupts = <GIC_SPI 74 IRQ_TYPE_LEVEL_HIGH>; + interrupts-extended = <&gic GIC_SPI 74 IRQ_TYPE_LEVEL_HIGH>; ti,hwmods = "uart3"; clock-frequency = <48000000>; }; @@ -304,7 +328,7 @@ uart4: serial@4806e000 { compatible = "ti,omap4-uart"; reg = <0x4806e000 0x100>; - interrupts = <GIC_SPI 70 IRQ_TYPE_LEVEL_HIGH>; + interrupts-extended = <&gic GIC_SPI 70 IRQ_TYPE_LEVEL_HIGH>; ti,hwmods = "uart4"; clock-frequency = <48000000>; }; @@ -313,6 +337,7 @@ compatible = "ti,omap4-hwspinlock"; reg = <0x4a0f6000 0x1000>; ti,hwmods = "spinlock"; + #hwlock-cells = <1>; }; i2c1: i2c@48070000 { @@ -419,6 +444,7 @@ ti,needs-special-reset; dmas = <&sdma 61>, <&sdma 62>; dma-names = "tx", "rx"; + pbias-supply = <&pbias_mmc_reg>; }; mmc2: mmc@480b4000 { @@ -461,6 +487,21 @@ dma-names = "tx", "rx"; }; + mmu_dsp: mmu@4a066000 { + compatible = "ti,omap4-iommu"; + reg = <0x4a066000 0x100>; + interrupts = <GIC_SPI 28 IRQ_TYPE_LEVEL_HIGH>; + ti,hwmods = "mmu_dsp"; + }; + + mmu_ipu: mmu@55082000 { + compatible = "ti,omap4-iommu"; + reg = <0x55082000 0x100>; + interrupts = <GIC_SPI 100 IRQ_TYPE_LEVEL_HIGH>; + ti,hwmods = "mmu_ipu"; + ti,iommu-bus-err-back; + }; + wdt2: wdt@4a314000 { compatible = "ti,omap4-wdt", "ti,omap3-wdt"; reg = <0x4a314000 0x80>; @@ -478,6 +519,7 @@ dmas = <&sdma 65>, <&sdma 66>; dma-names = "up_link", "dn_link"; + status = "disabled"; }; dmic: dmic@4012e000 { @@ -489,6 +531,7 @@ ti,hwmods = "dmic"; dmas = <&sdma 67>; dma-names = "up_link"; + status = "disabled"; }; mcbsp1: mcbsp@40122000 { @@ -503,6 +546,7 @@ dmas = <&sdma 33>, <&sdma 34>; dma-names = "tx", "rx"; + status = "disabled"; }; mcbsp2: mcbsp@40124000 { @@ -517,6 +561,7 @@ dmas = <&sdma 17>, <&sdma 18>; dma-names = "tx", "rx"; + status = "disabled"; }; mcbsp3: mcbsp@40126000 { @@ -531,6 +576,7 @@ dmas = <&sdma 19>, <&sdma 20>; dma-names = "tx", "rx"; + status = "disabled"; }; mcbsp4: mcbsp@48096000 { @@ -544,6 +590,7 @@ dmas = <&sdma 31>, <&sdma 32>; dma-names = "tx", "rx"; + status = "disabled"; }; keypad: keypad@4a31c000 { @@ -554,6 +601,13 @@ ti,hwmods = "kbd"; }; + dmm@4e000000 { + compatible = "ti,omap4-dmm"; + reg = <0x4e000000 0x800>; + interrupts = <0 113 0x4>; + ti,hwmods = "dmm"; + }; + emif1: emif@4c000000 { compatible = "ti,emif-4d"; reg = <0x4c000000 0x100>; @@ -589,6 +643,8 @@ compatible = "ti,omap-usb2"; reg = <0x4a0ad080 0x58>; ctrl-module = <&omap_control_usb2phy>; + clocks = <&usb_phy_cm_clk32k>; + clock-names = "wkupclk"; #phy-cells = <0>; }; }; @@ -697,16 +753,22 @@ #address-cells = <1>; #size-cells = <1>; ranges; + clocks = <&init_60m_fclk>, + <&xclk60mhsp1_ck>, + <&xclk60mhsp2_ck>; + clock-names = "refclk_60m_int", + "refclk_60m_ext_p1", + "refclk_60m_ext_p2"; usbhsohci: ohci@4a064800 { - compatible = "ti,ohci-omap3", "usb-ohci"; + compatible = "ti,ohci-omap3"; reg = <0x4a064800 0x400>; interrupt-parent = <&gic>; interrupts = <GIC_SPI 76 IRQ_TYPE_LEVEL_HIGH>; }; usbhsehci: ehci@4a064c00 { - compatible = "ti,ehci-omap", "usb-ehci"; + compatible = "ti,ehci-omap"; reg = <0x4a064c00 0x400>; interrupt-parent = <&gic>; interrupts = <GIC_SPI 77 IRQ_TYPE_LEVEL_HIGH>; @@ -757,6 +819,113 @@ dmas = <&sdma 117>, <&sdma 116>; dma-names = "tx", "rx"; }; + + abb_mpu: regulator-abb-mpu { + compatible = "ti,abb-v2"; + regulator-name = "abb_mpu"; + #address-cells = <0>; + #size-cells = <0>; + ti,tranxdone-status-mask = <0x80>; + clocks = <&sys_clkin_ck>; + ti,settling-time = <50>; + ti,clock-cycles = <16>; + + status = "disabled"; + }; + + abb_iva: regulator-abb-iva { + compatible = "ti,abb-v2"; + regulator-name = "abb_iva"; + #address-cells = <0>; + #size-cells = <0>; + ti,tranxdone-status-mask = <0x80000000>; + clocks = <&sys_clkin_ck>; + ti,settling-time = <50>; + ti,clock-cycles = <16>; + + status = "disabled"; + }; + + dss: dss@58000000 { + compatible = "ti,omap4-dss"; + reg = <0x58000000 0x80>; + status = "disabled"; + ti,hwmods = "dss_core"; + clocks = <&dss_dss_clk>; + clock-names = "fck"; + #address-cells = <1>; + #size-cells = <1>; + ranges; + + dispc@58001000 { + compatible = "ti,omap4-dispc"; + reg = <0x58001000 0x1000>; + interrupts = <GIC_SPI 25 IRQ_TYPE_LEVEL_HIGH>; + ti,hwmods = "dss_dispc"; + clocks = <&dss_dss_clk>; + clock-names = "fck"; + }; + + rfbi: encoder@58002000 { + compatible = "ti,omap4-rfbi"; + reg = <0x58002000 0x1000>; + status = "disabled"; + ti,hwmods = "dss_rfbi"; + clocks = <&dss_dss_clk>, <&dss_fck>; + clock-names = "fck", "ick"; + }; + + venc: encoder@58003000 { + compatible = "ti,omap4-venc"; + reg = <0x58003000 0x1000>; + status = "disabled"; + ti,hwmods = "dss_venc"; + clocks = <&dss_tv_clk>; + clock-names = "fck"; + }; + + dsi1: encoder@58004000 { + compatible = "ti,omap4-dsi"; + reg = <0x58004000 0x200>, + <0x58004200 0x40>, + <0x58004300 0x20>; + reg-names = "proto", "phy", "pll"; + interrupts = <GIC_SPI 53 IRQ_TYPE_LEVEL_HIGH>; + status = "disabled"; + ti,hwmods = "dss_dsi1"; + clocks = <&dss_dss_clk>, <&dss_sys_clk>; + clock-names = "fck", "sys_clk"; + }; + + dsi2: encoder@58005000 { + compatible = "ti,omap4-dsi"; + reg = <0x58005000 0x200>, + <0x58005200 0x40>, + <0x58005300 0x20>; + reg-names = "proto", "phy", "pll"; + interrupts = <GIC_SPI 84 IRQ_TYPE_LEVEL_HIGH>; + status = "disabled"; + ti,hwmods = "dss_dsi2"; + clocks = <&dss_dss_clk>, <&dss_sys_clk>; + clock-names = "fck", "sys_clk"; + }; + + hdmi: encoder@58006000 { + compatible = "ti,omap4-hdmi"; + reg = <0x58006000 0x200>, + <0x58006200 0x100>, + <0x58006300 0x100>, + <0x58006400 0x1000>; + reg-names = "wp", "pll", "phy", "core"; + interrupts = <GIC_SPI 101 IRQ_TYPE_LEVEL_HIGH>; + status = "disabled"; + ti,hwmods = "dss_hdmi"; + clocks = <&dss_48mhz_clk>, <&dss_sys_clk>; + clock-names = "fck", "sys_clk"; + dmas = <&sdma 76>; + dma-names = "audio_tx"; + }; + }; }; }; |