diff options
Diffstat (limited to 'arch/arm/boot/dts/ste-ux500-samsung-skomer.dts')
| -rw-r--r-- | arch/arm/boot/dts/ste-ux500-samsung-skomer.dts | 69 |
1 files changed, 62 insertions, 7 deletions
diff --git a/arch/arm/boot/dts/ste-ux500-samsung-skomer.dts b/arch/arm/boot/dts/ste-ux500-samsung-skomer.dts index 580ca497f312..93e5f5ed888d 100644 --- a/arch/arm/boot/dts/ste-ux500-samsung-skomer.dts +++ b/arch/arm/boot/dts/ste-ux500-samsung-skomer.dts @@ -24,6 +24,32 @@ compatible = "samsung,eb485159lu"; }; + thermal-zones { + battery-thermal { + /* This zone will be polled by the battery temperature code */ + polling-delay = <0>; + polling-delay-passive = <0>; + thermal-sensors = <&bat_therm>; + + trips { + battery-crit-hi { + temperature = <70000>; + hysteresis = <2000>; + type = "critical"; + }; + }; + }; + }; + + bat_therm: thermistor { + compatible = "samsung,1404-001221"; + io-channels = <&gpadc 0x02>; /* BatTemp */ + pullup-uv = <1800000>; + pullup-ohm = <230000>; + pulldown-ohm = <0>; + #thermal-sensor-cells = <0>; + }; + /* TI TXS0206 level translator for 2.9 V */ sd_level_translator: regulator-gpio { compatible = "regulator-fixed"; @@ -185,10 +211,6 @@ cap-sd-highspeed; cap-mmc-highspeed; /* All direction control is used */ - st,sig-dir-cmd; - st,sig-dir-dat0; - st,sig-dir-dat2; - st,sig-dir-dat31; st,sig-pin-fbclk; full-pwr-cycle; vmmc-supply = <&ab8500_ldo_aux3_reg>; @@ -267,12 +289,27 @@ }; }; - /* GPF UART */ + /* GPS UART */ uart@80121000 { status = "okay"; pinctrl-names = "default", "sleep"; pinctrl-0 = <&u1rxtx_a_1_default &u1ctsrts_a_1_default>; pinctrl-1 = <&u1rxtx_a_1_sleep &u1ctsrts_a_1_sleep>; + + gnss { + /* The CSRG05TA03-ICJE-R is a SirfStarV 5t chip */ + compatible = "csr,csrg05ta03-icje-r"; + /* GPS_RSTN on GPIO209 */ + reset-gpios = <&gpio6 17 GPIO_ACTIVE_LOW>; + /* GPS_ON_OFF on GPIO86 */ + sirf,onoff-gpios = <&gpio2 22 GPIO_ACTIVE_HIGH>; + /* GPS_1V8 (VSMPS2) */ + vcc-supply = <&db8500_vsmps2_reg>; + pinctrl-names = "default"; + pinctrl-0 = <&g05ta03_skomer_default>; + /* According to /etc/sirfgps.conf */ + current-speed = <460800>; + }; }; /* Debugging console UART connected to AB8505 USB */ @@ -285,13 +322,17 @@ prcmu@80157000 { ab8505 { - ab8500_usb { + phy { pinctrl-names = "default", "sleep"; pinctrl-0 = <&usb_a_1_default>; pinctrl-1 = <&usb_a_1_sleep>; }; - ab8505-regulators { + ab8500_fg { + line-impedance-micro-ohms = <16000>; + }; + + regulator { ab8500_ldo_aux1 { /* Used for VDD for sensors */ regulator-name = "AUX1"; @@ -635,6 +676,20 @@ }; }; }; + g05ta03 { + g05ta03_skomer_default: g05ta03 { + /* Reset line, start out de-asserted */ + skomer_cfg1 { + pins = "GPIO209_AG15"; + ste,config = <&gpio_out_hi>; + }; + /* GPS_ON_OFF, start out deasserted (off) */ + skomer_cfg2 { + pins = "GPIO86_C6"; + ste,config = <&gpio_out_lo>; + }; + }; + }; }; &ab8505_gpio { |