diff options
Diffstat (limited to '')
| -rw-r--r-- | arch/arm/plat-samsung/include/plat/gpio-cfg.h | 22 |
1 files changed, 19 insertions, 3 deletions
diff --git a/arch/arm/plat-samsung/include/plat/gpio-cfg.h b/arch/arm/plat-samsung/include/plat/gpio-cfg.h index e4b5cf126fa9..1762dcb4cb9e 100644 --- a/arch/arm/plat-samsung/include/plat/gpio-cfg.h +++ b/arch/arm/plat-samsung/include/plat/gpio-cfg.h @@ -125,7 +125,7 @@ extern int s3c_gpio_cfgpin_range(unsigned int start, unsigned int nr, * * These values control the state of the weak pull-{up,down} resistors * available on most pins on the S3C series. Not all chips support both - * up or down settings, and it may be dependant on the chip that is being + * up or down settings, and it may be dependent on the chip that is being * used to whether the particular mode is available. */ #define S3C_GPIO_PULL_NONE ((__force s3c_gpio_pull_t)0x00) @@ -138,7 +138,7 @@ extern int s3c_gpio_cfgpin_range(unsigned int start, unsigned int nr, * @pull: The configuration for the pull resistor. * * This function sets the state of the pull-{up,down} resistor for the - * specified pin. It will return 0 if successfull, or a negative error + * specified pin. It will return 0 if successful, or a negative error * code if the pin cannot support the requested pull setting. * * @pull is one of S3C_GPIO_PULL_NONE, S3C_GPIO_PULL_DOWN or S3C_GPIO_PULL_UP. @@ -202,7 +202,7 @@ extern s5p_gpio_drvstr_t s5p_gpio_get_drvstr(unsigned int pin); * @drvstr: The new value of the driver strength * * This function sets the driver strength value for the specified pin. - * It will return 0 if successfull, or a negative error code if the pin + * It will return 0 if successful, or a negative error code if the pin * cannot support the requested setting. */ extern int s5p_gpio_set_drvstr(unsigned int pin, s5p_gpio_drvstr_t drvstr); @@ -225,4 +225,20 @@ extern int s5p_gpio_set_drvstr(unsigned int pin, s5p_gpio_drvstr_t drvstr); */ extern int s5p_register_gpio_interrupt(int pin); +/** s5p_register_gpioint_bank() - add gpio bank for further gpio interrupt + * registration (see s5p_register_gpio_interrupt function) + * @chain_irq: chained irq number for the gpio int handler for this bank + * @start: start gpio group number of this bank + * @nr_groups: number of gpio groups handled by this bank + * + * This functions registers initial information about gpio banks that + * can be later used by the s5p_register_gpio_interrupt() function to + * enable support for gpio interrupt for particular gpio group. + */ +#ifdef CONFIG_S5P_GPIO_INT +extern int s5p_register_gpioint_bank(int chain_irq, int start, int nr_groups); +#else +#define s5p_register_gpioint_bank(chain_irq, start, nr_groups) do { } while (0) +#endif + #endif /* __PLAT_GPIO_CFG_H */ |