diff options
Diffstat (limited to 'drivers/bluetooth/btusb.c')
| -rw-r--r-- | drivers/bluetooth/btusb.c | 75 |
1 files changed, 75 insertions, 0 deletions
diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c index 4761499db9ee..ded198328f21 100644 --- a/drivers/bluetooth/btusb.c +++ b/drivers/bluetooth/btusb.c @@ -29,6 +29,7 @@ #include <linux/of_device.h> #include <linux/of_irq.h> #include <linux/suspend.h> +#include <linux/gpio/consumer.h> #include <asm/unaligned.h> #include <net/bluetooth/bluetooth.h> @@ -439,6 +440,7 @@ static const struct dmi_system_id btusb_needs_reset_resume_table[] = { #define BTUSB_BOOTING 9 #define BTUSB_DIAG_RUNNING 10 #define BTUSB_OOB_WAKE_ENABLED 11 +#define BTUSB_HW_RESET_ACTIVE 12 struct btusb_data { struct hci_dev *hdev; @@ -476,6 +478,8 @@ struct btusb_data { struct usb_endpoint_descriptor *diag_tx_ep; struct usb_endpoint_descriptor *diag_rx_ep; + struct gpio_desc *reset_gpio; + __u8 cmdreq_type; __u8 cmdreq; @@ -489,8 +493,41 @@ struct btusb_data { int (*setup_on_usb)(struct hci_dev *hdev); int oob_wake_irq; /* irq for out-of-band wake-on-bt */ + unsigned cmd_timeout_cnt; }; + +static void btusb_intel_cmd_timeout(struct hci_dev *hdev) +{ + struct btusb_data *data = hci_get_drvdata(hdev); + struct gpio_desc *reset_gpio = data->reset_gpio; + + if (++data->cmd_timeout_cnt < 5) + return; + + if (!reset_gpio) { + bt_dev_err(hdev, "No way to reset. Ignoring and continuing"); + return; + } + + /* + * Toggle the hard reset line if the platform provides one. The reset + * is going to yank the device off the USB and then replug. So doing + * once is enough. The cleanup is handled correctly on the way out + * (standard USB disconnect), and the new device is detected cleanly + * and bound to the driver again like it should be. + */ + if (test_and_set_bit(BTUSB_HW_RESET_ACTIVE, &data->flags)) { + bt_dev_err(hdev, "last reset failed? Not resetting again"); + return; + } + + bt_dev_err(hdev, "Initiating HW reset via gpio"); + gpiod_set_value_cansleep(reset_gpio, 1); + msleep(100); + gpiod_set_value_cansleep(reset_gpio, 0); +} + static inline void btusb_free_frags(struct btusb_data *data) { unsigned long flags; @@ -2397,6 +2434,24 @@ static int btusb_shutdown_intel(struct hci_dev *hdev) return 0; } +static int btusb_shutdown_intel_new(struct hci_dev *hdev) +{ + struct sk_buff *skb; + + /* Send HCI Reset to the controller to stop any BT activity which + * were triggered. This will help to save power and maintain the + * sync b/w Host and controller + */ + skb = __hci_cmd_sync(hdev, HCI_OP_RESET, 0, NULL, HCI_INIT_TIMEOUT); + if (IS_ERR(skb)) { + bt_dev_err(hdev, "HCI reset during shutdown failed"); + return PTR_ERR(skb); + } + kfree_skb(skb); + + return 0; +} + #ifdef CONFIG_PM /* Configure an out-of-band gpio as wake-up pin, if specified in device tree */ static int marvell_config_oob_wake(struct hci_dev *hdev) @@ -2862,6 +2917,8 @@ static irqreturn_t btusb_oob_wake_handler(int irq, void *priv) static const struct of_device_id btusb_match_table[] = { { .compatible = "usb1286,204e" }, + { .compatible = "usbcf3,e300" }, /* QCA6174A */ + { .compatible = "usb4ca,301a" }, /* QCA6174A (Lite-On) */ { } }; MODULE_DEVICE_TABLE(of, btusb_match_table); @@ -2915,6 +2972,7 @@ static int btusb_probe(struct usb_interface *intf, const struct usb_device_id *id) { struct usb_endpoint_descriptor *ep_desc; + struct gpio_desc *reset_gpio; struct btusb_data *data; struct hci_dev *hdev; unsigned ifnum_base; @@ -3028,6 +3086,15 @@ static int btusb_probe(struct usb_interface *intf, SET_HCIDEV_DEV(hdev, &intf->dev); + reset_gpio = gpiod_get_optional(&data->udev->dev, "reset", + GPIOD_OUT_LOW); + if (IS_ERR(reset_gpio)) { + err = PTR_ERR(reset_gpio); + goto out_free_dev; + } else if (reset_gpio) { + data->reset_gpio = reset_gpio; + } + hdev->open = btusb_open; hdev->close = btusb_close; hdev->flush = btusb_flush; @@ -3082,6 +3149,7 @@ static int btusb_probe(struct usb_interface *intf, hdev->shutdown = btusb_shutdown_intel; hdev->set_diag = btintel_set_diag_mfg; hdev->set_bdaddr = btintel_set_bdaddr; + hdev->cmd_timeout = btusb_intel_cmd_timeout; set_bit(HCI_QUIRK_STRICT_DUPLICATE_FILTER, &hdev->quirks); set_bit(HCI_QUIRK_SIMULTANEOUS_DISCOVERY, &hdev->quirks); set_bit(HCI_QUIRK_NON_PERSISTENT_DIAG, &hdev->quirks); @@ -3091,9 +3159,11 @@ static int btusb_probe(struct usb_interface *intf, hdev->manufacturer = 2; hdev->send = btusb_send_frame_intel; hdev->setup = btusb_setup_intel_new; + hdev->shutdown = btusb_shutdown_intel_new; hdev->hw_error = btintel_hw_error; hdev->set_diag = btintel_set_diag; hdev->set_bdaddr = btintel_set_bdaddr; + hdev->cmd_timeout = btusb_intel_cmd_timeout; set_bit(HCI_QUIRK_STRICT_DUPLICATE_FILTER, &hdev->quirks); set_bit(HCI_QUIRK_SIMULTANEOUS_DISCOVERY, &hdev->quirks); set_bit(HCI_QUIRK_NON_PERSISTENT_DIAG, &hdev->quirks); @@ -3226,6 +3296,8 @@ static int btusb_probe(struct usb_interface *intf, return 0; out_free_dev: + if (data->reset_gpio) + gpiod_put(data->reset_gpio); hci_free_dev(hdev); return err; } @@ -3269,6 +3341,9 @@ static void btusb_disconnect(struct usb_interface *intf) if (data->oob_wake_irq) device_init_wakeup(&data->udev->dev, false); + if (data->reset_gpio) + gpiod_put(data->reset_gpio); + hci_free_dev(hdev); } |