diff options
Diffstat (limited to 'drivers/misc/habanalabs/common/habanalabs.h')
| -rw-r--r-- | drivers/misc/habanalabs/common/habanalabs.h | 64 |
1 files changed, 61 insertions, 3 deletions
diff --git a/drivers/misc/habanalabs/common/habanalabs.h b/drivers/misc/habanalabs/common/habanalabs.h index bebebcb163ee..a2002cbf794b 100644 --- a/drivers/misc/habanalabs/common/habanalabs.h +++ b/drivers/misc/habanalabs/common/habanalabs.h @@ -26,6 +26,7 @@ #include <linux/sched/signal.h> #include <linux/io-64-nonatomic-lo-hi.h> #include <linux/coresight.h> +#include <linux/dma-buf.h> #define HL_NAME "habanalabs" @@ -68,6 +69,9 @@ #define HL_STATE_DUMP_HIST_LEN 5 +/* Default value for device reset trigger , an invalid value */ +#define HL_RESET_TRIGGER_DEFAULT 0xFF + #define OBJ_NAMES_HASH_TABLE_BITS 7 /* 1 << 7 buckets */ #define SYNC_TO_ENGINE_HASH_TABLE_BITS 7 /* 1 << 7 buckets */ @@ -132,13 +136,18 @@ enum hl_mmu_page_table_location { * - HL_RESET_FW * F/W will perform the reset. No need to ask it to reset the device. This is relevant * only when running with secured f/w + * + * - HL_RESET_FW_FATAL_ERR + * Set if reset is due to a fatal error from FW */ + #define HL_RESET_HARD (1 << 0) #define HL_RESET_FROM_RESET_THREAD (1 << 1) #define HL_RESET_HEARTBEAT (1 << 2) #define HL_RESET_TDR (1 << 3) #define HL_RESET_DEVICE_RELEASE (1 << 4) #define HL_RESET_FW (1 << 5) +#define HL_RESET_FW_FATAL_ERR (1 << 6) #define HL_MAX_SOBS_PER_MONITOR 8 @@ -447,6 +456,9 @@ struct hl_hints_range { * for hints validity check. * device_dma_offset_for_host_access: the offset to add to host DMA addresses * to enable the device to access them. + * @max_freq_value: current max clk frequency. + * @clk_pll_index: clock PLL index that specify which PLL determines the clock + * we display to the user * @mmu_pgt_size: MMU page tables total size. * @mmu_pte_size: PTE size in MMU page tables. * @mmu_hop_table_size: MMU hop table size. @@ -543,6 +555,8 @@ struct asic_fixed_properties { u64 cb_va_end_addr; u64 dram_hints_align_mask; u64 device_dma_offset_for_host_access; + u64 max_freq_value; + u32 clk_pll_index; u32 mmu_pgt_size; u32 mmu_pte_size; u32 mmu_hop_table_size; @@ -601,6 +615,9 @@ struct asic_fixed_properties { * masters QIDs that multi cs is waiting on * @error: mark this fence with error * @timestamp: timestamp upon completion + * @mcs_handling_done: indicates that corresponding command submission has + * finished msc handling, this does not mean it was part + * of the mcs */ struct hl_fence { struct completion completion; @@ -609,6 +626,7 @@ struct hl_fence { u32 stream_master_qid_map; int error; ktime_t timestamp; + u8 mcs_handling_done; }; /** @@ -1353,6 +1371,23 @@ struct hl_cs_counters_atomic { }; /** + * struct hl_dmabuf_priv - a dma-buf private object. + * @dmabuf: pointer to dma-buf object. + * @ctx: pointer to the dma-buf owner's context. + * @phys_pg_pack: pointer to physical page pack if the dma-buf was exported for + * memory allocation handle. + * @device_address: physical address of the device's memory. Relevant only + * if phys_pg_pack is NULL (dma-buf was exported from address). + * The total size can be taken from the dmabuf object. + */ +struct hl_dmabuf_priv { + struct dma_buf *dmabuf; + struct hl_ctx *ctx; + struct hl_vm_phys_pg_pack *phys_pg_pack; + uint64_t device_address; +}; + +/** * struct hl_ctx - user/kernel context. * @mem_hash: holds mapping from virtual address to virtual memory area * descriptor (hl_vm_phys_pg_list or hl_userptr). @@ -1662,6 +1697,7 @@ struct hl_vm_hw_block_list_node { * @npages: num physical pages in the pack. * @total_size: total size of all the pages in this list. * @mapping_cnt: number of shared mappings. + * @exporting_cnt: number of dma-buf exporting. * @asid: the context related to this list. * @page_size: size of each page in the pack. * @flags: HL_MEM_* flags related to this list. @@ -1676,6 +1712,7 @@ struct hl_vm_phys_pg_pack { u64 npages; u64 total_size; atomic_t mapping_cnt; + u32 exporting_cnt; u32 asid; u32 page_size; u32 flags; @@ -2396,6 +2433,7 @@ struct multi_cs_data { * the error will be ignored by the driver during * device initialization. Mainly used to debug and * workaround firmware bugs + * @dram_pci_bar_start: start bus address of PCIe bar towards DRAM. * @last_successful_open_jif: timestamp (jiffies) of the last successful * device open. * @last_open_session_duration_jif: duration (jiffies) of the last device open @@ -2440,8 +2478,12 @@ struct multi_cs_data { * @collective_mon_idx: helper index for collective initialization * @supports_coresight: is CoreSight supported. * @supports_soft_reset: is soft reset supported. - * @allow_external_soft_reset: true if soft reset initiated by user or TDR is - * allowed. + * @allow_inference_soft_reset: true if the ASIC supports soft reset that is + * initiated by user or TDR. This is only true + * in inference ASICs, as there is no real-world + * use-case of doing soft-reset in training (due + * to the fact that training runs on multiple + * devices) * @supports_cb_mapping: is mapping a CB to the device's MMU supported. * @needs_reset: true if reset_on_lockup is false and device should be reset * due to lockup. @@ -2452,6 +2494,10 @@ struct multi_cs_data { * @supports_staged_submission: true if staged submissions are supported * @curr_reset_cause: saves an enumerated reset cause when a hard reset is * triggered, and cleared after it is shared with preboot. + * @prev_reset_trigger: saves the previous trigger which caused a reset, overidden + * with a new value on next reset + * @reset_trigger_repeated: set if device reset is triggered more than once with + * same cause. * @skip_reset_on_timeout: Skip device reset if CS has timed out, wait for it to * complete instead. * @device_cpu_is_halted: Flag to indicate whether the device CPU was already @@ -2537,6 +2583,7 @@ struct hl_device { u64 max_power; u64 clock_gating_mask; u64 boot_error_status_mask; + u64 dram_pci_bar_start; u64 last_successful_open_jif; u64 last_open_session_duration_jif; u64 open_counter; @@ -2572,13 +2619,15 @@ struct hl_device { u8 collective_mon_idx; u8 supports_coresight; u8 supports_soft_reset; - u8 allow_external_soft_reset; + u8 allow_inference_soft_reset; u8 supports_cb_mapping; u8 needs_reset; u8 process_kill_trial_cnt; u8 device_fini_pending; u8 supports_staged_submission; u8 curr_reset_cause; + u8 prev_reset_trigger; + u8 reset_trigger_repeated; u8 skip_reset_on_timeout; u8 device_cpu_is_halted; u8 supports_wait_for_multi_cs; @@ -2956,6 +3005,15 @@ int hl_set_voltage(struct hl_device *hdev, int sensor_index, u32 attr, long value); int hl_set_current(struct hl_device *hdev, int sensor_index, u32 attr, long value); +int hl_set_power(struct hl_device *hdev, + int sensor_index, u32 attr, long value); +int hl_get_power(struct hl_device *hdev, + int sensor_index, u32 attr, long *value); +int hl_get_clk_rate(struct hl_device *hdev, + u32 *cur_clk, u32 *max_clk); +void hl_set_pll_profile(struct hl_device *hdev, enum hl_pll_frequency freq); +void hl_add_device_attr(struct hl_device *hdev, + struct attribute_group *dev_attr_grp); void hw_sob_get(struct hl_hw_sob *hw_sob); void hw_sob_put(struct hl_hw_sob *hw_sob); void hl_encaps_handle_do_release(struct kref *ref); |