diff options
Diffstat (limited to 'drivers/net/dsa/bcm_sf2.c')
| -rw-r--r-- | drivers/net/dsa/bcm_sf2.c | 214 |
1 files changed, 206 insertions, 8 deletions
diff --git a/drivers/net/dsa/bcm_sf2.c b/drivers/net/dsa/bcm_sf2.c index 97236cfcbae4..a20608b0329e 100644 --- a/drivers/net/dsa/bcm_sf2.c +++ b/drivers/net/dsa/bcm_sf2.c @@ -16,6 +16,7 @@ #include <linux/platform_device.h> #include <linux/phy.h> #include <linux/phy_fixed.h> +#include <linux/phylink.h> #include <linux/mii.h> #include <linux/of.h> #include <linux/of_irq.h> @@ -306,7 +307,8 @@ static int bcm_sf2_sw_mdio_write(struct mii_bus *bus, int addr, int regnum, static irqreturn_t bcm_sf2_switch_0_isr(int irq, void *dev_id) { - struct bcm_sf2_priv *priv = dev_id; + struct dsa_switch *ds = dev_id; + struct bcm_sf2_priv *priv = bcm_sf2_to_priv(ds); priv->irq0_stat = intrl2_0_readl(priv, INTRL2_CPU_STATUS) & ~priv->irq0_mask; @@ -317,16 +319,21 @@ static irqreturn_t bcm_sf2_switch_0_isr(int irq, void *dev_id) static irqreturn_t bcm_sf2_switch_1_isr(int irq, void *dev_id) { - struct bcm_sf2_priv *priv = dev_id; + struct dsa_switch *ds = dev_id; + struct bcm_sf2_priv *priv = bcm_sf2_to_priv(ds); priv->irq1_stat = intrl2_1_readl(priv, INTRL2_CPU_STATUS) & ~priv->irq1_mask; intrl2_1_writel(priv, priv->irq1_stat, INTRL2_CPU_CLEAR); - if (priv->irq1_stat & P_LINK_UP_IRQ(P7_IRQ_OFF)) - priv->port_sts[7].link = 1; - if (priv->irq1_stat & P_LINK_DOWN_IRQ(P7_IRQ_OFF)) - priv->port_sts[7].link = 0; + if (priv->irq1_stat & P_LINK_UP_IRQ(P7_IRQ_OFF)) { + priv->port_sts[7].link = true; + dsa_port_phylink_mac_change(ds, 7, true); + } + if (priv->irq1_stat & P_LINK_DOWN_IRQ(P7_IRQ_OFF)) { + priv->port_sts[7].link = false; + dsa_port_phylink_mac_change(ds, 7, false); + } return IRQ_HANDLED; } @@ -620,6 +627,192 @@ static void bcm_sf2_sw_fixed_link_update(struct dsa_switch *ds, int port, status->pause = 1; } +static void bcm_sf2_sw_validate(struct dsa_switch *ds, int port, + unsigned long *supported, + struct phylink_link_state *state) +{ + __ETHTOOL_DECLARE_LINK_MODE_MASK(mask) = { 0, }; + + if (!phy_interface_mode_is_rgmii(state->interface) && + state->interface != PHY_INTERFACE_MODE_MII && + state->interface != PHY_INTERFACE_MODE_REVMII && + state->interface != PHY_INTERFACE_MODE_GMII && + state->interface != PHY_INTERFACE_MODE_INTERNAL && + state->interface != PHY_INTERFACE_MODE_MOCA) { + bitmap_zero(supported, __ETHTOOL_LINK_MODE_MASK_NBITS); + dev_err(ds->dev, + "Unsupported interface: %d\n", state->interface); + return; + } + + /* Allow all the expected bits */ + phylink_set(mask, Autoneg); + phylink_set_port_modes(mask); + phylink_set(mask, Pause); + phylink_set(mask, Asym_Pause); + + /* With the exclusion of MII and Reverse MII, we support Gigabit, + * including Half duplex + */ + if (state->interface != PHY_INTERFACE_MODE_MII && + state->interface != PHY_INTERFACE_MODE_REVMII) { + phylink_set(mask, 1000baseT_Full); + phylink_set(mask, 1000baseT_Half); + } + + phylink_set(mask, 10baseT_Half); + phylink_set(mask, 10baseT_Full); + phylink_set(mask, 100baseT_Half); + phylink_set(mask, 100baseT_Full); + + bitmap_and(supported, supported, mask, + __ETHTOOL_LINK_MODE_MASK_NBITS); + bitmap_and(state->advertising, state->advertising, mask, + __ETHTOOL_LINK_MODE_MASK_NBITS); +} + +static void bcm_sf2_sw_mac_config(struct dsa_switch *ds, int port, + unsigned int mode, + const struct phylink_link_state *state) +{ + struct bcm_sf2_priv *priv = bcm_sf2_to_priv(ds); + u32 id_mode_dis = 0, port_mode; + u32 reg, offset; + + if (priv->type == BCM7445_DEVICE_ID) + offset = CORE_STS_OVERRIDE_GMIIP_PORT(port); + else + offset = CORE_STS_OVERRIDE_GMIIP2_PORT(port); + + switch (state->interface) { + case PHY_INTERFACE_MODE_RGMII: + id_mode_dis = 1; + /* fallthrough */ + case PHY_INTERFACE_MODE_RGMII_TXID: + port_mode = EXT_GPHY; + break; + case PHY_INTERFACE_MODE_MII: + port_mode = EXT_EPHY; + break; + case PHY_INTERFACE_MODE_REVMII: + port_mode = EXT_REVMII; + break; + default: + /* all other PHYs: internal and MoCA */ + goto force_link; + } + + /* Clear id_mode_dis bit, and the existing port mode, let + * RGMII_MODE_EN bet set by mac_link_{up,down} + */ + reg = reg_readl(priv, REG_RGMII_CNTRL_P(port)); + reg &= ~ID_MODE_DIS; + reg &= ~(PORT_MODE_MASK << PORT_MODE_SHIFT); + reg &= ~(RX_PAUSE_EN | TX_PAUSE_EN); + + reg |= port_mode; + if (id_mode_dis) + reg |= ID_MODE_DIS; + + if (state->pause & MLO_PAUSE_TXRX_MASK) { + if (state->pause & MLO_PAUSE_TX) + reg |= TX_PAUSE_EN; + reg |= RX_PAUSE_EN; + } + + reg_writel(priv, reg, REG_RGMII_CNTRL_P(port)); + +force_link: + /* Force link settings detected from the PHY */ + reg = SW_OVERRIDE; + switch (state->speed) { + case SPEED_1000: + reg |= SPDSTS_1000 << SPEED_SHIFT; + break; + case SPEED_100: + reg |= SPDSTS_100 << SPEED_SHIFT; + break; + } + + if (state->link) + reg |= LINK_STS; + if (state->duplex == DUPLEX_FULL) + reg |= DUPLX_MODE; + + core_writel(priv, reg, offset); +} + +static void bcm_sf2_sw_mac_link_set(struct dsa_switch *ds, int port, + phy_interface_t interface, bool link) +{ + struct bcm_sf2_priv *priv = bcm_sf2_to_priv(ds); + u32 reg; + + if (!phy_interface_mode_is_rgmii(interface) && + interface != PHY_INTERFACE_MODE_MII && + interface != PHY_INTERFACE_MODE_REVMII) + return; + + /* If the link is down, just disable the interface to conserve power */ + reg = reg_readl(priv, REG_RGMII_CNTRL_P(port)); + if (link) + reg |= RGMII_MODE_EN; + else + reg &= ~RGMII_MODE_EN; + reg_writel(priv, reg, REG_RGMII_CNTRL_P(port)); +} + +static void bcm_sf2_sw_mac_link_down(struct dsa_switch *ds, int port, + unsigned int mode, + phy_interface_t interface) +{ + bcm_sf2_sw_mac_link_set(ds, port, interface, false); +} + +static void bcm_sf2_sw_mac_link_up(struct dsa_switch *ds, int port, + unsigned int mode, + phy_interface_t interface, + struct phy_device *phydev) +{ + struct bcm_sf2_priv *priv = bcm_sf2_to_priv(ds); + struct ethtool_eee *p = &priv->dev->ports[port].eee; + + bcm_sf2_sw_mac_link_set(ds, port, interface, true); + + if (mode == MLO_AN_PHY && phydev) + p->eee_enabled = b53_eee_init(ds, port, phydev); +} + +static void bcm_sf2_sw_fixed_state(struct dsa_switch *ds, int port, + struct phylink_link_state *status) +{ + struct bcm_sf2_priv *priv = bcm_sf2_to_priv(ds); + + status->link = false; + + /* MoCA port is special as we do not get link status from CORE_LNKSTS, + * which means that we need to force the link at the port override + * level to get the data to flow. We do use what the interrupt handler + * did determine before. + * + * For the other ports, we just force the link status, since this is + * a fixed PHY device. + */ + if (port == priv->moca_port) { + status->link = priv->port_sts[port].link; + /* For MoCA interfaces, also force a link down notification + * since some version of the user-space daemon (mocad) use + * cmd->autoneg to force the link, which messes up the PHY + * state machine and make it go in PHY_FORCING state instead. + */ + if (!status->link) + netif_carrier_off(ds->ports[port].slave); + status->duplex = DUPLEX_FULL; + } else { + status->link = true; + } +} + static void bcm_sf2_enable_acb(struct dsa_switch *ds) { struct bcm_sf2_priv *priv = bcm_sf2_to_priv(ds); @@ -863,6 +1056,11 @@ static const struct dsa_switch_ops bcm_sf2_ops = { .get_phy_flags = bcm_sf2_sw_get_phy_flags, .adjust_link = bcm_sf2_sw_adjust_link, .fixed_link_update = bcm_sf2_sw_fixed_link_update, + .phylink_validate = bcm_sf2_sw_validate, + .phylink_mac_config = bcm_sf2_sw_mac_config, + .phylink_mac_link_down = bcm_sf2_sw_mac_link_down, + .phylink_mac_link_up = bcm_sf2_sw_mac_link_up, + .phylink_fixed_state = bcm_sf2_sw_fixed_state, .suspend = bcm_sf2_sw_suspend, .resume = bcm_sf2_sw_resume, .get_wol = bcm_sf2_sw_get_wol, @@ -1065,14 +1263,14 @@ static int bcm_sf2_sw_probe(struct platform_device *pdev) bcm_sf2_intr_disable(priv); ret = devm_request_irq(&pdev->dev, priv->irq0, bcm_sf2_switch_0_isr, 0, - "switch_0", priv); + "switch_0", ds); if (ret < 0) { pr_err("failed to request switch_0 IRQ\n"); goto out_mdio; } ret = devm_request_irq(&pdev->dev, priv->irq1, bcm_sf2_switch_1_isr, 0, - "switch_1", priv); + "switch_1", ds); if (ret < 0) { pr_err("failed to request switch_1 IRQ\n"); goto out_mdio; |