diff options
Diffstat (limited to 'drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c')
| -rw-r--r-- | drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c | 40 |
1 files changed, 36 insertions, 4 deletions
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c index 91e2a7560b48..74fc9af4aadb 100644 --- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c +++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c @@ -9578,6 +9578,15 @@ static int bnx2x_init_shmem(struct bnx2x *bp) do { bp->common.shmem_base = REG_RD(bp, MISC_REG_SHARED_MEM_ADDR); + + /* If we read all 0xFFs, means we are in PCI error state and + * should bail out to avoid crashes on adapter's FW reads. + */ + if (bp->common.shmem_base == 0xFFFFFFFF) { + bp->flags |= NO_MCP_FLAG; + return -ENODEV; + } + if (bp->common.shmem_base) { val = SHMEM_RD(bp, validity_map[BP_PORT(bp)]); if (val & SHR_MEM_VALIDITY_MB) @@ -12400,8 +12409,8 @@ static int bnx2x_init_bp(struct bnx2x *bp) /* Set TPA flags */ if (bp->disable_tpa) { - bp->dev->hw_features &= ~NETIF_F_LRO; - bp->dev->features &= ~NETIF_F_LRO; + bp->dev->hw_features &= ~(NETIF_F_LRO | NETIF_F_GRO_HW); + bp->dev->features &= ~(NETIF_F_LRO | NETIF_F_GRO_HW); } if (CHIP_IS_E1(bp)) @@ -12925,6 +12934,24 @@ static netdev_features_t bnx2x_features_check(struct sk_buff *skb, struct net_device *dev, netdev_features_t features) { + /* + * A skb with gso_size + header length > 9700 will cause a + * firmware panic. Drop GSO support. + * + * Eventually the upper layer should not pass these packets down. + * + * For speed, if the gso_size is <= 9000, assume there will + * not be 700 bytes of headers and pass it through. Only do a + * full (slow) validation if the gso_size is > 9000. + * + * (Due to the way SKB_BY_FRAGS works this will also do a full + * validation in that case.) + */ + if (unlikely(skb_is_gso(skb) && + (skb_shinfo(skb)->gso_size > 9000) && + !skb_gso_validate_mac_len(skb, 9700))) + features &= ~NETIF_F_GSO_MASK; + features = vlan_features_check(skb, features); return vxlan_features_check(skb, features); } @@ -13273,7 +13300,7 @@ static int bnx2x_init_dev(struct bnx2x *bp, struct pci_dev *pdev, dev->hw_features = NETIF_F_SG | NETIF_F_IP_CSUM | NETIF_F_IPV6_CSUM | NETIF_F_TSO | NETIF_F_TSO_ECN | NETIF_F_TSO6 | - NETIF_F_RXCSUM | NETIF_F_LRO | NETIF_F_GRO | + NETIF_F_RXCSUM | NETIF_F_LRO | NETIF_F_GRO | NETIF_F_GRO_HW | NETIF_F_RXHASH | NETIF_F_HW_VLAN_CTAG_TX; if (!chip_is_e1x) { dev->hw_features |= NETIF_F_GSO_GRE | NETIF_F_GSO_GRE_CSUM | @@ -13309,6 +13336,8 @@ static int bnx2x_init_dev(struct bnx2x *bp, struct pci_dev *pdev, dev->features |= dev->hw_features | NETIF_F_HW_VLAN_CTAG_RX; dev->features |= NETIF_F_HIGHDMA; + if (dev->features & NETIF_F_LRO) + dev->features &= ~NETIF_F_GRO_HW; /* Add Loopback capability to the device */ dev->hw_features |= NETIF_F_LOOPBACK; @@ -14320,7 +14349,10 @@ static pci_ers_result_t bnx2x_io_slot_reset(struct pci_dev *pdev) BNX2X_ERR("IO slot reset --> driver unload\n"); /* MCP should have been reset; Need to wait for validity */ - bnx2x_init_shmem(bp); + if (bnx2x_init_shmem(bp)) { + rtnl_unlock(); + return PCI_ERS_RESULT_DISCONNECT; + } if (IS_PF(bp) && SHMEM2_HAS(bp, drv_capabilities_flag)) { u32 v; |