diff options
Diffstat (limited to 'drivers/net/ethernet/intel/i40e/i40e_txrx.c')
| -rw-r--r-- | drivers/net/ethernet/intel/i40e/i40e_txrx.c | 53 |
1 files changed, 13 insertions, 40 deletions
diff --git a/drivers/net/ethernet/intel/i40e/i40e_txrx.c b/drivers/net/ethernet/intel/i40e/i40e_txrx.c index 120c68f78951..d6d352a6e6ea 100644 --- a/drivers/net/ethernet/intel/i40e/i40e_txrx.c +++ b/drivers/net/ethernet/intel/i40e/i40e_txrx.c @@ -960,14 +960,14 @@ static bool i40e_set_new_dynamic_itr(struct i40e_ring_container *rc) { enum i40e_latency_range new_latency_range = rc->latency_range; u32 new_itr = rc->itr; - int bytes_per_int; + int bytes_per_usec; unsigned int usecs, estimated_usecs; if (rc->total_packets == 0 || !rc->itr) return false; usecs = (rc->itr << 1) * ITR_COUNTDOWN_START; - bytes_per_int = rc->total_bytes / usecs; + bytes_per_usec = rc->total_bytes / usecs; /* The calculations in this algorithm depend on interrupts actually * firing at the ITR rate. This may not happen if the packet rate is @@ -993,18 +993,18 @@ static bool i40e_set_new_dynamic_itr(struct i40e_ring_container *rc) */ switch (new_latency_range) { case I40E_LOWEST_LATENCY: - if (bytes_per_int > 10) + if (bytes_per_usec > 10) new_latency_range = I40E_LOW_LATENCY; break; case I40E_LOW_LATENCY: - if (bytes_per_int > 20) + if (bytes_per_usec > 20) new_latency_range = I40E_BULK_LATENCY; - else if (bytes_per_int <= 10) + else if (bytes_per_usec <= 10) new_latency_range = I40E_LOWEST_LATENCY; break; case I40E_BULK_LATENCY: default: - if (bytes_per_int <= 20) + if (bytes_per_usec <= 20) new_latency_range = I40E_LOW_LATENCY; break; } @@ -2117,6 +2117,7 @@ static int i40e_clean_rx_irq(struct i40e_ring *rx_ring, int budget) if (!skb) { xdp.data = page_address(rx_buffer->page) + rx_buffer->page_offset; + xdp_set_data_meta_invalid(&xdp); xdp.data_hard_start = xdp.data - i40e_rx_offset(rx_ring); xdp.data_end = xdp.data + size; @@ -2211,9 +2212,7 @@ static u32 i40e_buildreg_itr(const int type, const u16 itr) u32 val; val = I40E_PFINT_DYN_CTLN_INTENA_MASK | - /* Don't clear PBA because that can cause lost interrupts that - * came in while we were cleaning/polling - */ + I40E_PFINT_DYN_CTLN_CLEARPBA_MASK | (type << I40E_PFINT_DYN_CTLN_ITR_INDX_SHIFT) | (itr << I40E_PFINT_DYN_CTLN_INTERVAL_SHIFT); @@ -2250,7 +2249,7 @@ static inline void i40e_update_enable_itr(struct i40e_vsi *vsi, /* If we don't have MSIX, then we only need to re-enable icr0 */ if (!(vsi->back->flags & I40E_FLAG_MSIX_ENABLED)) { - i40e_irq_dynamic_enable_icr0(vsi->back, false); + i40e_irq_dynamic_enable_icr0(vsi->back); return; } @@ -3176,38 +3175,12 @@ static inline int i40e_tx_map(struct i40e_ring *tx_ring, struct sk_buff *skb, /* write last descriptor with EOP bit */ td_cmd |= I40E_TX_DESC_CMD_EOP; - /* We can OR these values together as they both are checked against - * 4 below and at this point desc_count will be used as a boolean value - * after this if/else block. + /* We OR these values together to check both against 4 (WB_STRIDE) + * below. This is safe since we don't re-use desc_count afterwards. */ desc_count |= ++tx_ring->packet_stride; - /* Algorithm to optimize tail and RS bit setting: - * if queue is stopped - * mark RS bit - * reset packet counter - * else if xmit_more is supported and is true - * advance packet counter to 4 - * reset desc_count to 0 - * - * if desc_count >= 4 - * mark RS bit - * reset packet counter - * if desc_count > 0 - * update tail - * - * Note: If there are less than 4 descriptors - * pending and interrupts were disabled the service task will - * trigger a force WB. - */ - if (netif_xmit_stopped(txring_txq(tx_ring))) { - goto do_rs; - } else if (skb->xmit_more) { - /* set stride to arm on next packet and reset desc_count */ - tx_ring->packet_stride = WB_STRIDE; - desc_count = 0; - } else if (desc_count >= WB_STRIDE) { -do_rs: + if (desc_count >= WB_STRIDE) { /* write last descriptor with RS bit set */ td_cmd |= I40E_TX_DESC_CMD_RS; tx_ring->packet_stride = 0; @@ -3228,7 +3201,7 @@ do_rs: first->next_to_watch = tx_desc; /* notify HW of packet */ - if (desc_count) { + if (netif_xmit_stopped(txring_txq(tx_ring)) || !skb->xmit_more) { writel(i, tx_ring->tail); /* we need this if more than one processor can write to our tail |