diff options
Diffstat (limited to 'drivers/net/wireless/rtlwifi/rtl8192ce/sw.c')
| -rw-r--r-- | drivers/net/wireless/rtlwifi/rtl8192ce/sw.c | 123 |
1 files changed, 112 insertions, 11 deletions
diff --git a/drivers/net/wireless/rtlwifi/rtl8192ce/sw.c b/drivers/net/wireless/rtlwifi/rtl8192ce/sw.c index b1cc4d44f534..390bbb5ee11d 100644 --- a/drivers/net/wireless/rtlwifi/rtl8192ce/sw.c +++ b/drivers/net/wireless/rtlwifi/rtl8192ce/sw.c @@ -42,10 +42,58 @@ #include "trx.h" #include "led.h" +static void rtl92c_init_aspm_vars(struct ieee80211_hw *hw) +{ + struct rtl_pci *rtlpci = rtl_pcidev(rtl_pcipriv(hw)); + + /*close ASPM for AMD defaultly */ + rtlpci->const_amdpci_aspm = 0; + + /* + * ASPM PS mode. + * 0 - Disable ASPM, + * 1 - Enable ASPM without Clock Req, + * 2 - Enable ASPM with Clock Req, + * 3 - Alwyas Enable ASPM with Clock Req, + * 4 - Always Enable ASPM without Clock Req. + * set defult to RTL8192CE:3 RTL8192E:2 + * */ + rtlpci->const_pci_aspm = 3; + + /*Setting for PCI-E device */ + rtlpci->const_devicepci_aspm_setting = 0x03; + + /*Setting for PCI-E bridge */ + rtlpci->const_hostpci_aspm_setting = 0x02; + + /* + * In Hw/Sw Radio Off situation. + * 0 - Default, + * 1 - From ASPM setting without low Mac Pwr, + * 2 - From ASPM setting with low Mac Pwr, + * 3 - Bus D3 + * set default to RTL8192CE:0 RTL8192SE:2 + */ + rtlpci->const_hwsw_rfoff_d3 = 0; + + /* + * This setting works for those device with + * backdoor ASPM setting such as EPHY setting. + * 0 - Not support ASPM, + * 1 - Support ASPM, + * 2 - According to chipset. + */ + rtlpci->const_support_pciaspm = 1; +} + int rtl92c_init_sw_vars(struct ieee80211_hw *hw) { + int err; struct rtl_priv *rtlpriv = rtl_priv(hw); struct rtl_pci *rtlpci = rtl_pcidev(rtl_pcipriv(hw)); + const struct firmware *firmware; + + rtl8192ce_bt_reg_init(hw); rtlpriv->dm.dm_initialgain_enable = 1; rtlpriv->dm.dm_flag = 0; @@ -53,7 +101,12 @@ int rtl92c_init_sw_vars(struct ieee80211_hw *hw) rtlpriv->dm.thermalvalue = 0; rtlpci->transmit_config = CFENDFORM | BIT(12) | BIT(13); - rtlpci->receive_config = (RCR_APP_FCS | + /* compatible 5G band 88ce just 2.4G band & smsp */ + rtlpriv->rtlhal.current_bandtype = BAND_ON_2_4G; + rtlpriv->rtlhal.bandset = BAND_ON_2_4G; + rtlpriv->rtlhal.macphymode = SINGLEMAC_SINGLEPHY; + + rtlpci->receive_config = (RCR_APPFCS | RCR_AMF | RCR_ADF | RCR_APP_MIC | @@ -76,13 +129,49 @@ int rtl92c_init_sw_vars(struct ieee80211_hw *hw) rtlpci->irq_mask[1] = (u32) (IMR_CPWM | IMR_C2HCMD | 0); - rtlpriv->rtlhal.pfirmware = (u8 *) vmalloc(0x4000); + /* for LPS & IPS */ + rtlpriv->psc.inactiveps = rtlpriv->cfg->mod_params->inactiveps; + rtlpriv->psc.swctrl_lps = rtlpriv->cfg->mod_params->swctrl_lps; + rtlpriv->psc.fwctrl_lps = rtlpriv->cfg->mod_params->fwctrl_lps; + rtlpriv->psc.reg_fwctrl_lps = 3; + rtlpriv->psc.reg_max_lps_awakeintvl = 5; + /* for ASPM, you can close aspm through + * set const_support_pciaspm = 0 */ + rtl92c_init_aspm_vars(hw); + + if (rtlpriv->psc.reg_fwctrl_lps == 1) + rtlpriv->psc.fwctrl_psmode = FW_PS_MIN_MODE; + else if (rtlpriv->psc.reg_fwctrl_lps == 2) + rtlpriv->psc.fwctrl_psmode = FW_PS_MAX_MODE; + else if (rtlpriv->psc.reg_fwctrl_lps == 3) + rtlpriv->psc.fwctrl_psmode = FW_PS_DTIM_MODE; + + /* for firmware buf */ + rtlpriv->rtlhal.pfirmware = vzalloc(0x4000); if (!rtlpriv->rtlhal.pfirmware) { RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG, ("Can't alloc buffer for fw.\n")); return 1; } + /* request fw */ + err = request_firmware(&firmware, rtlpriv->cfg->fw_name, + rtlpriv->io.dev); + if (err) { + RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG, + ("Failed to request firmware!\n")); + return 1; + } + if (firmware->size > 0x4000) { + RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG, + ("Firmware is too big!\n")); + release_firmware(firmware); + return 1; + } + memcpy(rtlpriv->rtlhal.pfirmware, firmware->data, firmware->size); + rtlpriv->rtlhal.fwsize = firmware->size; + release_firmware(firmware); + return 0; } @@ -103,17 +192,19 @@ static struct rtl_hal_ops rtl8192ce_hal_ops = { .interrupt_recognized = rtl92ce_interrupt_recognized, .hw_init = rtl92ce_hw_init, .hw_disable = rtl92ce_card_disable, + .hw_suspend = rtl92ce_suspend, + .hw_resume = rtl92ce_resume, .enable_interrupt = rtl92ce_enable_interrupt, .disable_interrupt = rtl92ce_disable_interrupt, .set_network_type = rtl92ce_set_network_type, + .set_chk_bssid = rtl92ce_set_check_bssid, .set_qos = rtl92ce_set_qos, .set_bcn_reg = rtl92ce_set_beacon_related_registers, .set_bcn_intv = rtl92ce_set_beacon_interval, .update_interrupt_mask = rtl92ce_update_interrupt_mask, .get_hw_reg = rtl92ce_get_hw_reg, .set_hw_reg = rtl92ce_set_hw_reg, - .update_rate_table = rtl92ce_update_hal_rate_table, - .update_rate_mask = rtl92ce_update_hal_rate_mask, + .update_rate_tbl = rtl92ce_update_hal_rate_tbl, .fill_tx_desc = rtl92ce_tx_fill_desc, .fill_tx_cmddesc = rtl92ce_tx_fill_cmddesc, .query_rx_desc = rtl92ce_rx_query_desc, @@ -123,7 +214,7 @@ static struct rtl_hal_ops rtl8192ce_hal_ops = { .switch_channel = rtl92c_phy_sw_chnl, .dm_watchdog = rtl92c_dm_watchdog, .scan_operation_backup = rtl92c_phy_scan_operation_backup, - .set_rf_power_state = rtl92ce_phy_set_rf_power_state, + .set_rf_power_state = rtl92c_phy_set_rf_power_state, .led_control = rtl92ce_led_control, .set_desc = rtl92ce_set_desc, .get_desc = rtl92ce_get_desc, @@ -131,27 +222,29 @@ static struct rtl_hal_ops rtl8192ce_hal_ops = { .enable_hw_sec = rtl92ce_enable_hw_security_config, .set_key = rtl92ce_set_key, .init_sw_leds = rtl92ce_init_sw_leds, - .deinit_sw_leds = rtl92ce_deinit_sw_leds, .get_bbreg = rtl92c_phy_query_bb_reg, .set_bbreg = rtl92c_phy_set_bb_reg, - .get_rfreg = rtl92ce_phy_query_rf_reg, .set_rfreg = rtl92ce_phy_set_rf_reg, - .cmd_send_packet = _rtl92c_cmd_send_packet, + .get_rfreg = rtl92c_phy_query_rf_reg, .phy_rf6052_config = rtl92ce_phy_rf6052_config, .phy_rf6052_set_cck_txpower = rtl92ce_phy_rf6052_set_cck_txpower, .phy_rf6052_set_ofdm_txpower = rtl92ce_phy_rf6052_set_ofdm_txpower, .config_bb_with_headerfile = _rtl92ce_phy_config_bb_with_headerfile, .config_bb_with_pgheaderfile = _rtl92ce_phy_config_bb_with_pgheaderfile, .phy_lc_calibrate = _rtl92ce_phy_lc_calibrate, - .phy_set_bw_mode_callback = rtl92ce_phy_set_bw_mode_callback, .dm_dynamic_txpower = rtl92ce_dm_dynamic_txpower, }; static struct rtl_mod_params rtl92ce_mod_params = { - .sw_crypto = 0, + .sw_crypto = false, + .inactiveps = true, + .swctrl_lps = false, + .fwctrl_lps = true, }; static struct rtl_hal_cfg rtl92ce_hal_cfg = { + .bar_id = 2, + .write_readback = true, .name = "rtl92c_pci", .fw_name = "rtlwifi/rtl8192cfw.bin", .ops = &rtl8192ce_hal_ops, @@ -175,6 +268,8 @@ static struct rtl_hal_cfg rtl92ce_hal_cfg = { .maps[EFUSE_LOADER_CLK_EN] = LOADER_CLK_EN, .maps[EFUSE_ANA8M] = EFUSE_ANA8M, .maps[EFUSE_HWSET_MAX_SIZE] = HWSET_MAX_SIZE, + .maps[EFUSE_MAX_SECTION_MAP] = EFUSE_MAX_SECTION, + .maps[EFUSE_REAL_CONTENT_SIZE] = EFUSE_REAL_CONTENT_LEN, .maps[RWCAM] = REG_CAMCMD, .maps[WCAMI] = REG_CAMWRITE, @@ -239,7 +334,7 @@ static struct rtl_hal_cfg rtl92ce_hal_cfg = { .maps[RTL_RC_HT_RATEMCS15] = DESC92C_RATEMCS15, }; -static struct pci_device_id rtl92ce_pci_ids[] __devinitdata = { +DEFINE_PCI_DEVICE_TABLE(rtl92ce_pci_ids) = { {RTL_PCI_DEVICE(PCI_VENDOR_ID_REALTEK, 0x8191, rtl92ce_hal_cfg)}, {RTL_PCI_DEVICE(PCI_VENDOR_ID_REALTEK, 0x8178, rtl92ce_hal_cfg)}, {RTL_PCI_DEVICE(PCI_VENDOR_ID_REALTEK, 0x8177, rtl92ce_hal_cfg)}, @@ -257,7 +352,13 @@ MODULE_DESCRIPTION("Realtek 8192C/8188C 802.11n PCI wireless"); MODULE_FIRMWARE("rtlwifi/rtl8192cfw.bin"); module_param_named(swenc, rtl92ce_mod_params.sw_crypto, bool, 0444); +module_param_named(ips, rtl92ce_mod_params.inactiveps, bool, 0444); +module_param_named(swlps, rtl92ce_mod_params.swctrl_lps, bool, 0444); +module_param_named(fwlps, rtl92ce_mod_params.fwctrl_lps, bool, 0444); MODULE_PARM_DESC(swenc, "using hardware crypto (default 0 [hardware])\n"); +MODULE_PARM_DESC(ips, "using no link power save (default 1 is open)\n"); +MODULE_PARM_DESC(fwlps, "using linked fw control power save " + "(default 1 is open)\n"); static struct pci_driver rtl92ce_driver = { .name = KBUILD_MODNAME, |