diff options
Diffstat (limited to 'drivers/spi/Kconfig')
| -rw-r--r-- | drivers/spi/Kconfig | 34 |
1 files changed, 33 insertions, 1 deletions
diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig index c3008e423f59..d2c976e55b8b 100644 --- a/drivers/spi/Kconfig +++ b/drivers/spi/Kconfig @@ -235,6 +235,7 @@ config SPI_DAVINCI config SPI_DESIGNWARE tristate "DesignWare SPI controller core support" + imply SPI_MEM help general driver for SPI controller core from DesignWare @@ -251,6 +252,34 @@ config SPI_DW_MMIO tristate "Memory-mapped io interface driver for DW SPI core" depends on HAS_IOMEM +config SPI_DW_BT1 + tristate "Baikal-T1 SPI driver for DW SPI core" + depends on MIPS_BAIKAL_T1 || COMPILE_TEST + help + Baikal-T1 SoC is equipped with three DW APB SSI-based MMIO SPI + controllers. Two of them are pretty much normal: with IRQ, DMA, + FIFOs of 64 words depth, 4x CSs, but the third one as being a + part of the Baikal-T1 System Boot Controller has got a very + limited resources: no IRQ, no DMA, only a single native + chip-select and Tx/Rx FIFO with just 8 words depth available. + The later one is normally connected to an external SPI-nor flash + of 128Mb (in general can be of bigger size). + +config SPI_DW_BT1_DIRMAP + bool "Directly mapped Baikal-T1 Boot SPI flash support" + depends on SPI_DW_BT1 + select MULTIPLEXER + select MUX_MMIO + help + Directly mapped SPI flash memory is an interface specific to the + Baikal-T1 System Boot Controller. It is a 16MB MMIO region, which + can be used to access a peripheral memory device just by + reading/writing data from/to it. Note that the system APB bus + will stall during each IO from/to the dirmap region until the + operation is finished. So try not to use it concurrently with + time-critical tasks (like the SPI memory operations implemented + in this driver). + endif config SPI_DLN2 @@ -637,7 +666,7 @@ config SPI_QCOM_QSPI config SPI_QUP tristate "Qualcomm SPI controller with QUP interface" - depends on ARCH_QCOM || (ARM && COMPILE_TEST) + depends on ARCH_QCOM || COMPILE_TEST help Qualcomm Universal Peripheral (QUP) core is an AHB slave that provides a common data path (an output FIFO and an input FIFO) @@ -1017,4 +1046,7 @@ config SPI_SLAVE_SYSTEM_CONTROL endif # SPI_SLAVE +config SPI_DYNAMIC + def_bool ACPI || OF_DYNAMIC || SPI_SLAVE + endif # SPI |