diff options
Diffstat (limited to 'drivers/staging/comedi/drivers/ni_labpc_common.c')
| -rw-r--r-- | drivers/staging/comedi/drivers/ni_labpc_common.c | 65 |
1 files changed, 40 insertions, 25 deletions
diff --git a/drivers/staging/comedi/drivers/ni_labpc_common.c b/drivers/staging/comedi/drivers/ni_labpc_common.c index 863afb28ee28..b0dfb8eed16d 100644 --- a/drivers/staging/comedi/drivers/ni_labpc_common.c +++ b/drivers/staging/comedi/drivers/ni_labpc_common.c @@ -84,8 +84,10 @@ static const struct comedi_lrange range_labpc_ao = { } }; -/* functions that do inb/outb and readb/writeb so we can use - * function pointers to decide which to use */ +/* + * functions that do inb/outb and readb/writeb so we can use + * function pointers to decide which to use + */ static unsigned int labpc_inb(struct comedi_device *dev, unsigned long reg) { return inb(dev->iobase + reg); @@ -656,19 +658,24 @@ static int labpc_ai_cmd(struct comedi_device *dev, struct comedi_subdevice *s) /* figure out what method we will use to transfer data */ if (devpriv->dma && - /* dma unsafe at RT priority, - * and too much setup time for CMDF_WAKE_EOS */ - (cmd->flags & (CMDF_WAKE_EOS | CMDF_PRIORITY)) == 0) + (cmd->flags & (CMDF_WAKE_EOS | CMDF_PRIORITY)) == 0) { + /* + * dma unsafe at RT priority, + * and too much setup time for CMDF_WAKE_EOS + */ xfer = isa_dma_transfer; - else if (/* pc-plus has no fifo-half full interrupt */ - board->is_labpc1200 && - /* wake-end-of-scan should interrupt on fifo not empty */ - (cmd->flags & CMDF_WAKE_EOS) == 0 && - /* make sure we are taking more than just a few points */ - (cmd->stop_src != TRIG_COUNT || devpriv->count > 256)) + } else if (board->is_labpc1200 && + (cmd->flags & CMDF_WAKE_EOS) == 0 && + (cmd->stop_src != TRIG_COUNT || devpriv->count > 256)) { + /* + * pc-plus has no fifo-half full interrupt + * wake-end-of-scan should interrupt on fifo not empty + * make sure we are taking more than just a few points + */ xfer = fifo_half_full_transfer; - else + } else { xfer = fifo_not_empty_transfer; + } devpriv->current_transfer = xfer; labpc_ai_set_chan_and_gain(dev, mode, chan, range, aref); @@ -679,9 +686,11 @@ static int labpc_ai_cmd(struct comedi_device *dev, struct comedi_subdevice *s) /* manual says to set scan enable bit on second pass */ if (mode == MODE_MULT_CHAN_UP || mode == MODE_MULT_CHAN_DOWN) { devpriv->cmd1 |= CMD1_SCANEN; - /* need a brief delay before enabling scan, or scan - * list will get screwed when you switch - * between scan up to scan down mode - dunno why */ + /* + * Need a brief delay before enabling scan, or scan + * list will get screwed when you switch between + * scan up to scan down mode - dunno why. + */ udelay(1); devpriv->write_byte(dev, devpriv->cmd1, CMD1_REG); } @@ -728,8 +737,10 @@ static int labpc_ai_cmd(struct comedi_device *dev, struct comedi_subdevice *s) devpriv->cmd4 = 0; if (cmd->convert_src != TRIG_EXT) devpriv->cmd4 |= CMD4_ECLKRCV; - /* XXX should discard first scan when using interval scanning - * since manual says it is not synced with scan clock */ + /* + * XXX should discard first scan when using interval scanning + * since manual says it is not synced with scan clock. + */ if (!labpc_use_continuous_mode(cmd, mode)) { devpriv->cmd4 |= CMD4_INTSCAN; if (cmd->scan_begin_src == TRIG_EXT) @@ -795,8 +806,10 @@ static int labpc_drain_fifo(struct comedi_device *dev) return 0; } -/* makes sure all data acquired by board is transferred to comedi (used - * when acquisition is terminated by stop_src == TRIG_EXT). */ +/* + * Makes sure all data acquired by board is transferred to comedi (used + * when acquisition is terminated by stop_src == TRIG_EXT). + */ static void labpc_drain_dregs(struct comedi_device *dev) { struct labpc_private *devpriv = dev->private; @@ -907,9 +920,11 @@ static int labpc_ao_insn_write(struct comedi_device *dev, channel = CR_CHAN(insn->chanspec); - /* turn off pacing of analog output channel */ - /* note: hardware bug in daqcard-1200 means pacing cannot - * be independently enabled/disabled for its the two channels */ + /* + * Turn off pacing of analog output channel. + * NOTE: hardware bug in daqcard-1200 means pacing cannot + * be independently enabled/disabled for its the two channels. + */ spin_lock_irqsave(&dev->spinlock, flags); devpriv->cmd2 &= ~CMD2_LDAC(channel); devpriv->write_byte(dev, devpriv->cmd2, CMD2_REG); @@ -1261,7 +1276,7 @@ int labpc_common_attach(struct comedi_device *dev, if (board->has_ao) { s->type = COMEDI_SUBD_AO; s->subdev_flags = SDF_READABLE | SDF_WRITABLE | SDF_GROUND; - s->n_chan = NUM_AO_CHAN; + s->n_chan = 2; s->maxdata = 0x0fff; s->range_table = &range_labpc_ao; s->insn_write = labpc_ao_insn_write; @@ -1307,12 +1322,12 @@ int labpc_common_attach(struct comedi_device *dev, s->type = COMEDI_SUBD_UNUSED; } - /* EEPROM */ + /* EEPROM (256 bytes) */ s = &dev->subdevices[4]; if (board->is_labpc1200) { s->type = COMEDI_SUBD_MEMORY; s->subdev_flags = SDF_READABLE | SDF_WRITABLE | SDF_INTERNAL; - s->n_chan = EEPROM_SIZE; + s->n_chan = 256; s->maxdata = 0xff; s->insn_write = labpc_eeprom_insn_write; |