diff options
Diffstat (limited to 'drivers/staging/wlags49_h2/README.ubuntu')
-rw-r--r-- | drivers/staging/wlags49_h2/README.ubuntu | 12 |
1 files changed, 6 insertions, 6 deletions
diff --git a/drivers/staging/wlags49_h2/README.ubuntu b/drivers/staging/wlags49_h2/README.ubuntu index 5f1cfb8fd427..bfad7dc7725f 100644 --- a/drivers/staging/wlags49_h2/README.ubuntu +++ b/drivers/staging/wlags49_h2/README.ubuntu @@ -46,12 +46,12 @@ If you have a card using the HERMES II.5 chip you have to make changes to the Makefile and uncomment -DHERMES25. This will build driver wlags49_h25_cs. -Note: You can detemine the type with command "pccardctrl info" +Note: You can determine the type with command "pccardctrl info" MANIFID: 0156,0002 = HERMES - not supported by this driver MANIFID: 0156,0003 = HERMES II (Wireless B) MANIFID: 0156,0004 = HERMES II.5 (Wireless B/G) -After succesfull compile type command +After successful compile type command sudo make install @@ -81,7 +81,7 @@ The linux driver files (wl_xxxx.c) are changed in the following ways: - Addaptations of Andrey Borzenkov applied to 7.22 source - Alterations to avoid most HCF_ASSERTs -- Switching interrupts off and on in the HCF --- Bugfixes, things that were aparently wrong like reporting link status +-- Bugfixes, things that were apparently wrong like reporting link status change which checked a variable that was not changed in HCF anymore. -- Used on WEP but setting keys via SIOCSIWENCODEEXT was not supported -- Recovery actions added @@ -93,7 +93,7 @@ have to "open" the device first to get a handle and after "close" no changed; the former ioctl functions are now called before "open" and after "close", which was not expected. One of the problems was enable/ disable of interrupts in the HCF. Interrupt handling starts at "open" -so if a former "ioctl" routinge is called before "open" or after "close" +so if a former "ioctl" routine is called before "open" or after "close" then nothing should be done with interrupt switching in the HCF. Once this was solved most HCF_ASSERTS went away. @@ -120,8 +120,8 @@ include the man page. Even though setting parameters on the module does not work anymore but it provides some information about all the settings. -I have not have personal contact with Agere, but others have. Agere -agreed to make their software available under the BSD licence. +I have no personal contact with Agere, but others have. Agere +agreed to make their software available under the BSD license. This driver is based on the 7.22 version. The following was mailed by Agere to Andrey Borzenkov about this: |