diff options
Diffstat (limited to 'drivers/thermal/imx_thermal.c')
| -rw-r--r-- | drivers/thermal/imx_thermal.c | 145 |
1 files changed, 91 insertions, 54 deletions
diff --git a/drivers/thermal/imx_thermal.c b/drivers/thermal/imx_thermal.c index 2c7473d86a59..16663373b682 100644 --- a/drivers/thermal/imx_thermal.c +++ b/drivers/thermal/imx_thermal.c @@ -15,6 +15,7 @@ #include <linux/regmap.h> #include <linux/thermal.h> #include <linux/nvmem-consumer.h> +#include <linux/pm_runtime.h> #define REG_SET 0x4 #define REG_CLR 0x8 @@ -194,6 +195,7 @@ static struct thermal_soc_data thermal_imx7d_data = { }; struct imx_thermal_data { + struct device *dev; struct cpufreq_policy *policy; struct thermal_zone_device *tz; struct thermal_cooling_device *cdev; @@ -252,44 +254,15 @@ static int imx_get_temp(struct thermal_zone_device *tz, int *temp) const struct thermal_soc_data *soc_data = data->socdata; struct regmap *map = data->tempmon; unsigned int n_meas; - bool wait, run_measurement; u32 val; + int ret; - run_measurement = !data->irq_enabled; - if (!run_measurement) { - /* Check if a measurement is currently in progress */ - regmap_read(map, soc_data->temp_data, &val); - wait = !(val & soc_data->temp_valid_mask); - } else { - /* - * Every time we measure the temperature, we will power on the - * temperature sensor, enable measurements, take a reading, - * disable measurements, power off the temperature sensor. - */ - regmap_write(map, soc_data->sensor_ctrl + REG_CLR, - soc_data->power_down_mask); - regmap_write(map, soc_data->sensor_ctrl + REG_SET, - soc_data->measure_temp_mask); - - wait = true; - } - - /* - * According to the temp sensor designers, it may require up to ~17us - * to complete a measurement. - */ - if (wait) - usleep_range(20, 50); + ret = pm_runtime_resume_and_get(data->dev); + if (ret < 0) + return ret; regmap_read(map, soc_data->temp_data, &val); - if (run_measurement) { - regmap_write(map, soc_data->sensor_ctrl + REG_CLR, - soc_data->measure_temp_mask); - regmap_write(map, soc_data->sensor_ctrl + REG_SET, - soc_data->power_down_mask); - } - if ((val & soc_data->temp_valid_mask) == 0) { dev_dbg(&tz->device, "temp measurement never finished\n"); return -EAGAIN; @@ -328,6 +301,8 @@ static int imx_get_temp(struct thermal_zone_device *tz, int *temp) enable_irq(data->irq); } + pm_runtime_put(data->dev); + return 0; } @@ -335,24 +310,16 @@ static int imx_change_mode(struct thermal_zone_device *tz, enum thermal_device_mode mode) { struct imx_thermal_data *data = tz->devdata; - struct regmap *map = data->tempmon; - const struct thermal_soc_data *soc_data = data->socdata; if (mode == THERMAL_DEVICE_ENABLED) { - regmap_write(map, soc_data->sensor_ctrl + REG_CLR, - soc_data->power_down_mask); - regmap_write(map, soc_data->sensor_ctrl + REG_SET, - soc_data->measure_temp_mask); + pm_runtime_get(data->dev); if (!data->irq_enabled) { data->irq_enabled = true; enable_irq(data->irq); } } else { - regmap_write(map, soc_data->sensor_ctrl + REG_CLR, - soc_data->measure_temp_mask); - regmap_write(map, soc_data->sensor_ctrl + REG_SET, - soc_data->power_down_mask); + pm_runtime_put(data->dev); if (data->irq_enabled) { disable_irq(data->irq); @@ -393,6 +360,11 @@ static int imx_set_trip_temp(struct thermal_zone_device *tz, int trip, int temp) { struct imx_thermal_data *data = tz->devdata; + int ret; + + ret = pm_runtime_resume_and_get(data->dev); + if (ret < 0) + return ret; /* do not allow changing critical threshold */ if (trip == IMX_TRIP_CRITICAL) @@ -406,6 +378,8 @@ static int imx_set_trip_temp(struct thermal_zone_device *tz, int trip, imx_set_alarm_temp(data, temp); + pm_runtime_put(data->dev); + return 0; } @@ -681,6 +655,8 @@ static int imx_thermal_probe(struct platform_device *pdev) if (!data) return -ENOMEM; + data->dev = &pdev->dev; + map = syscon_regmap_lookup_by_phandle(pdev->dev.of_node, "fsl,tempmon"); if (IS_ERR(map)) { ret = PTR_ERR(map); @@ -800,6 +776,16 @@ static int imx_thermal_probe(struct platform_device *pdev) data->socdata->power_down_mask); regmap_write(map, data->socdata->sensor_ctrl + REG_SET, data->socdata->measure_temp_mask); + /* After power up, we need a delay before first access can be done. */ + usleep_range(20, 50); + + /* the core was configured and enabled just before */ + pm_runtime_set_active(&pdev->dev); + pm_runtime_enable(data->dev); + + ret = pm_runtime_resume_and_get(data->dev); + if (ret < 0) + goto disable_runtime_pm; data->irq_enabled = true; ret = thermal_zone_device_enable(data->tz); @@ -814,10 +800,15 @@ static int imx_thermal_probe(struct platform_device *pdev) goto thermal_zone_unregister; } + pm_runtime_put(data->dev); + return 0; thermal_zone_unregister: thermal_zone_device_unregister(data->tz); +disable_runtime_pm: + pm_runtime_put_noidle(data->dev); + pm_runtime_disable(data->dev); clk_disable: clk_disable_unprepare(data->thermal_clk); legacy_cleanup: @@ -829,13 +820,9 @@ legacy_cleanup: static int imx_thermal_remove(struct platform_device *pdev) { struct imx_thermal_data *data = platform_get_drvdata(pdev); - struct regmap *map = data->tempmon; - /* Disable measurements */ - regmap_write(map, data->socdata->sensor_ctrl + REG_SET, - data->socdata->power_down_mask); - if (!IS_ERR(data->thermal_clk)) - clk_disable_unprepare(data->thermal_clk); + pm_runtime_put_noidle(data->dev); + pm_runtime_disable(data->dev); thermal_zone_device_unregister(data->tz); imx_thermal_unregister_legacy_cooling(data); @@ -858,29 +845,79 @@ static int __maybe_unused imx_thermal_suspend(struct device *dev) ret = thermal_zone_device_disable(data->tz); if (ret) return ret; + + return pm_runtime_force_suspend(data->dev); +} + +static int __maybe_unused imx_thermal_resume(struct device *dev) +{ + struct imx_thermal_data *data = dev_get_drvdata(dev); + int ret; + + ret = pm_runtime_force_resume(data->dev); + if (ret) + return ret; + /* Enabled thermal sensor after resume */ + return thermal_zone_device_enable(data->tz); +} + +static int __maybe_unused imx_thermal_runtime_suspend(struct device *dev) +{ + struct imx_thermal_data *data = dev_get_drvdata(dev); + const struct thermal_soc_data *socdata = data->socdata; + struct regmap *map = data->tempmon; + int ret; + + ret = regmap_write(map, socdata->sensor_ctrl + REG_CLR, + socdata->measure_temp_mask); + if (ret) + return ret; + + ret = regmap_write(map, socdata->sensor_ctrl + REG_SET, + socdata->power_down_mask); + if (ret) + return ret; + clk_disable_unprepare(data->thermal_clk); return 0; } -static int __maybe_unused imx_thermal_resume(struct device *dev) +static int __maybe_unused imx_thermal_runtime_resume(struct device *dev) { struct imx_thermal_data *data = dev_get_drvdata(dev); + const struct thermal_soc_data *socdata = data->socdata; + struct regmap *map = data->tempmon; int ret; ret = clk_prepare_enable(data->thermal_clk); if (ret) return ret; - /* Enabled thermal sensor after resume */ - ret = thermal_zone_device_enable(data->tz); + + ret = regmap_write(map, socdata->sensor_ctrl + REG_CLR, + socdata->power_down_mask); + if (ret) + return ret; + + ret = regmap_write(map, socdata->sensor_ctrl + REG_SET, + socdata->measure_temp_mask); if (ret) return ret; + /* + * According to the temp sensor designers, it may require up to ~17us + * to complete a measurement. + */ + usleep_range(20, 50); + return 0; } -static SIMPLE_DEV_PM_OPS(imx_thermal_pm_ops, - imx_thermal_suspend, imx_thermal_resume); +static const struct dev_pm_ops imx_thermal_pm_ops = { + SET_SYSTEM_SLEEP_PM_OPS(imx_thermal_suspend, imx_thermal_resume) + SET_RUNTIME_PM_OPS(imx_thermal_runtime_suspend, + imx_thermal_runtime_resume, NULL) +}; static struct platform_driver imx_thermal = { .driver = { |