diff options
Diffstat (limited to 'drivers/usb/musb/musb_core.h')
| -rw-r--r-- | drivers/usb/musb/musb_core.h | 87 |
1 files changed, 45 insertions, 42 deletions
diff --git a/drivers/usb/musb/musb_core.h b/drivers/usb/musb/musb_core.h index 414e57a984bb..5e65958f7915 100644 --- a/drivers/usb/musb/musb_core.h +++ b/drivers/usb/musb/musb_core.h @@ -124,41 +124,6 @@ enum musb_g_ep0_state { #define OTG_TIME_A_AIDL_BDIS 200 /* min 200 msec */ #define OTG_TIME_B_ASE0_BRST 100 /* min 3.125 ms */ - -/*************************** REGISTER ACCESS ********************************/ - -/* Endpoint registers (other than dynfifo setup) can be accessed either - * directly with the "flat" model, or after setting up an index register. - */ - -#if defined(CONFIG_ARCH_DAVINCI) || defined(CONFIG_SOC_OMAP2430) \ - || defined(CONFIG_SOC_OMAP3430) || defined(CONFIG_BLACKFIN) \ - || defined(CONFIG_ARCH_OMAP4) -/* REVISIT indexed access seemed to - * misbehave (on DaVinci) for at least peripheral IN ... - */ -#define MUSB_FLAT_REG -#endif - -/* TUSB mapping: "flat" plus ep0 special cases */ -#if defined(CONFIG_USB_MUSB_TUSB6010) || \ - defined(CONFIG_USB_MUSB_TUSB6010_MODULE) -#define musb_ep_select(_mbase, _epnum) \ - musb_writeb((_mbase), MUSB_INDEX, (_epnum)) -#define MUSB_EP_OFFSET MUSB_TUSB_OFFSET - -/* "flat" mapping: each endpoint has its own i/o address */ -#elif defined(MUSB_FLAT_REG) -#define musb_ep_select(_mbase, _epnum) (((void)(_mbase)), ((void)(_epnum))) -#define MUSB_EP_OFFSET MUSB_FLAT_OFFSET - -/* "indexed" mapping: INDEX register controls register bank select */ -#else -#define musb_ep_select(_mbase, _epnum) \ - musb_writeb((_mbase), MUSB_INDEX, (_epnum)) -#define MUSB_EP_OFFSET MUSB_INDEXED_OFFSET -#endif - /****************************** FUNCTIONS ********************************/ #define MUSB_HST_MODE(_musb)\ @@ -173,8 +138,25 @@ enum musb_g_ep0_state { /******************************** TYPES *************************************/ +struct musb_io; + /** * struct musb_platform_ops - Operations passed to musb_core by HW glue layer + * @quirks: flags for platform specific quirks + * @enable: enable device + * @disable: disable device + * @ep_offset: returns the end point offset + * @ep_select: selects the specified end point + * @fifo_mode: sets the fifo mode + * @fifo_offset: returns the fifo offset + * @readb: read 8 bits + * @writeb: write 8 bits + * @readw: read 16 bits + * @writew: write 16 bits + * @readl: read 32 bits + * @writel: write 32 bits + * @read_fifo: reads the fifo + * @write_fifo: writes to fifo * @init: turns on clocks, sets up platform-specific registers, etc * @exit: undoes @init * @set_mode: forcefully changes operating mode @@ -184,12 +166,34 @@ enum musb_g_ep0_state { * @adjust_channel_params: pre check for standard dma channel_program func */ struct musb_platform_ops { + +#define MUSB_DMA_UX500 BIT(6) +#define MUSB_DMA_CPPI41 BIT(5) +#define MUSB_DMA_CPPI BIT(4) +#define MUSB_DMA_TUSB_OMAP BIT(3) +#define MUSB_DMA_INVENTRA BIT(2) +#define MUSB_IN_TUSB BIT(1) +#define MUSB_INDEXED_EP BIT(0) + u32 quirks; + int (*init)(struct musb *musb); int (*exit)(struct musb *musb); void (*enable)(struct musb *musb); void (*disable)(struct musb *musb); + u32 (*ep_offset)(u8 epnum, u16 offset); + void (*ep_select)(void __iomem *mbase, u8 epnum); + u16 fifo_mode; + u32 (*fifo_offset)(u8 epnum); + u8 (*readb)(const void __iomem *addr, unsigned offset); + void (*writeb)(void __iomem *addr, unsigned offset, u8 data); + u16 (*readw)(const void __iomem *addr, unsigned offset); + void (*writew)(void __iomem *addr, unsigned offset, u16 data); + u32 (*readl)(const void __iomem *addr, unsigned offset); + void (*writel)(void __iomem *addr, unsigned offset, u32 data); + void (*read_fifo)(struct musb_hw_ep *hw_ep, u16 len, u8 *buf); + void (*write_fifo)(struct musb_hw_ep *hw_ep, u16 len, const u8 *buf); int (*set_mode)(struct musb *musb, u8 mode); void (*try_idle)(struct musb *musb, unsigned long timeout); int (*reset)(struct musb *musb); @@ -212,8 +216,7 @@ struct musb_hw_ep { void __iomem *fifo; void __iomem *regs; -#if defined(CONFIG_USB_MUSB_TUSB6010) || \ - defined(CONFIG_USB_MUSB_TUSB6010_MODULE) +#if IS_ENABLED(CONFIG_USB_MUSB_TUSB6010) void __iomem *conf; #endif @@ -230,8 +233,7 @@ struct musb_hw_ep { struct dma_channel *tx_channel; struct dma_channel *rx_channel; -#if defined(CONFIG_USB_MUSB_TUSB6010) || \ - defined(CONFIG_USB_MUSB_TUSB6010_MODULE) +#if IS_ENABLED(CONFIG_USB_MUSB_TUSB6010) /* TUSB has "asynchronous" and "synchronous" dma modes */ dma_addr_t fifo_async; dma_addr_t fifo_sync; @@ -292,6 +294,7 @@ struct musb { /* device lock */ spinlock_t lock; + struct musb_io io; const struct musb_platform_ops *ops; struct musb_context_registers context; @@ -334,8 +337,7 @@ struct musb { void __iomem *ctrl_base; void __iomem *mregs; -#if defined(CONFIG_USB_MUSB_TUSB6010) || \ - defined(CONFIG_USB_MUSB_TUSB6010_MODULE) +#if IS_ENABLED(CONFIG_USB_MUSB_TUSB6010) dma_addr_t async; dma_addr_t sync; void __iomem *sync_va; @@ -390,6 +392,7 @@ struct musb { /* is_suspended means USB B_PERIPHERAL suspend */ unsigned is_suspended:1; + unsigned need_finish_resume :1; /* may_wakeup means remote wakeup is enabled */ unsigned may_wakeup:1; @@ -474,7 +477,7 @@ static inline int musb_read_fifosize(struct musb *musb, u8 reg = 0; /* read from core using indexed model */ - reg = musb_readb(mbase, MUSB_EP_OFFSET(epnum, MUSB_FIFOSIZE)); + reg = musb_readb(mbase, musb->io.ep_offset(epnum, MUSB_FIFOSIZE)); /* 0's returned when no more endpoints */ if (!reg) return -ENODEV; |