diff options
Diffstat (limited to 'include/drm/drm_connector.h')
| -rw-r--r-- | include/drm/drm_connector.h | 217 |
1 files changed, 196 insertions, 21 deletions
diff --git a/include/drm/drm_connector.h b/include/drm/drm_connector.h index 02a131202add..681cb590f952 100644 --- a/include/drm/drm_connector.h +++ b/include/drm/drm_connector.h @@ -41,6 +41,7 @@ struct drm_property; struct drm_property_blob; struct drm_printer; struct edid; +struct i2c_adapter; enum drm_connector_force { DRM_FORCE_UNSPECIFIED, @@ -323,6 +324,8 @@ enum drm_panel_orientation { * edge of the pixel clock * @DRM_BUS_FLAG_SYNC_SAMPLE_NEGEDGE: Sync signals are sampled on the falling * edge of the pixel clock + * @DRM_BUS_FLAG_SHARP_SIGNALS: Set if the Sharp-specific signals + * (SPL, CLS, PS, REV) must be used */ enum drm_bus_flags { DRM_BUS_FLAG_DE_LOW = BIT(0), @@ -341,6 +344,7 @@ enum drm_bus_flags { DRM_BUS_FLAG_SYNC_DRIVE_NEGEDGE = DRM_BUS_FLAG_SYNC_NEGEDGE, DRM_BUS_FLAG_SYNC_SAMPLE_POSEDGE = DRM_BUS_FLAG_SYNC_NEGEDGE, DRM_BUS_FLAG_SYNC_SAMPLE_NEGEDGE = DRM_BUS_FLAG_SYNC_POSEDGE, + DRM_BUS_FLAG_SHARP_SIGNALS = BIT(8), }; /** @@ -464,13 +468,37 @@ int drm_display_info_set_bus_formats(struct drm_display_info *info, unsigned int num_formats); /** + * struct drm_connector_tv_margins - TV connector related margins + * + * Describes the margins in pixels to put around the image on TV + * connectors to deal with overscan. + */ +struct drm_connector_tv_margins { + /** + * @bottom: Bottom margin in pixels. + */ + unsigned int bottom; + + /** + * @left: Left margin in pixels. + */ + unsigned int left; + + /** + * @right: Right margin in pixels. + */ + unsigned int right; + + /** + * @top: Top margin in pixels. + */ + unsigned int top; +}; + +/** * struct drm_tv_connector_state - TV connector related states * @subconnector: selected subconnector - * @margins: margins (all margins are expressed in pixels) - * @margins.left: left margin - * @margins.right: right margin - * @margins.top: top margin - * @margins.bottom: bottom margin + * @margins: TV margins * @mode: TV mode * @brightness: brightness in percent * @contrast: contrast in percent @@ -481,12 +509,7 @@ int drm_display_info_set_bus_formats(struct drm_display_info *info, */ struct drm_tv_connector_state { enum drm_mode_subconnector subconnector; - struct { - unsigned int left; - unsigned int right; - unsigned int top; - unsigned int bottom; - } margins; + struct drm_connector_tv_margins margins; unsigned int mode; unsigned int brightness; unsigned int contrast; @@ -517,6 +540,15 @@ struct drm_connector_state { * Used by the atomic helpers to select the encoder, through the * &drm_connector_helper_funcs.atomic_best_encoder or * &drm_connector_helper_funcs.best_encoder callbacks. + * + * This is also used in the atomic helpers to map encoders to their + * current and previous connectors, see + * drm_atomic_get_old_connector_for_encoder() and + * drm_atomic_get_new_connector_for_encoder(). + * + * NOTE: Atomic drivers must fill this out (either themselves or through + * helpers), for otherwise the GETCONNECTOR and GETENCODER IOCTLs will + * not return correct data to userspace. */ struct drm_encoder *best_encoder; @@ -540,6 +572,20 @@ struct drm_connector_state { struct drm_tv_connector_state tv; /** + * @self_refresh_aware: + * + * This tracks whether a connector is aware of the self refresh state. + * It should be set to true for those connector implementations which + * understand the self refresh state. This is needed since the crtc + * registers the self refresh helpers and it doesn't know if the + * connectors downstream have implemented self refresh entry/exit. + * + * Drivers should set this to true in atomic_check if they know how to + * handle self_refresh requests. + */ + bool self_refresh_aware; + + /** * @picture_aspect_ratio: Connector property to control the * HDMI infoframe aspect ratio setting. * @@ -557,6 +603,12 @@ struct drm_connector_state { unsigned int content_type; /** + * @hdcp_content_type: Connector property to pass the type of + * protected content. This is most commonly used for HDCP. + */ + unsigned int hdcp_content_type; + + /** * @scaling_mode: Connector property to control the * upscaling, mostly used for built-in panels. */ @@ -599,6 +651,12 @@ struct drm_connector_state { * and the connector bpc limitations obtained from edid. */ u8 max_bpc; + + /** + * @hdr_output_metadata: + * DRM blob property for HDR output metadata + */ + struct drm_property_blob *hdr_output_metadata; }; /** @@ -894,19 +952,123 @@ struct drm_connector_funcs { const struct drm_connector_state *state); }; -/* mode specified on the command line */ +/** + * struct drm_cmdline_mode - DRM Mode passed through the kernel command-line + * + * Each connector can have an initial mode with additional options + * passed through the kernel command line. This structure allows to + * express those parameters and will be filled by the command-line + * parser. + */ struct drm_cmdline_mode { + /** + * @name: + * + * Name of the mode. + */ + char name[DRM_DISPLAY_MODE_LEN]; + + /** + * @specified: + * + * Has a mode been read from the command-line? + */ bool specified; + + /** + * @refresh_specified: + * + * Did the mode have a preferred refresh rate? + */ bool refresh_specified; + + /** + * @bpp_specified: + * + * Did the mode have a preferred BPP? + */ bool bpp_specified; - int xres, yres; + + /** + * @xres: + * + * Active resolution on the X axis, in pixels. + */ + int xres; + + /** + * @yres: + * + * Active resolution on the Y axis, in pixels. + */ + int yres; + + /** + * @bpp: + * + * Bits per pixels for the mode. + */ int bpp; + + /** + * @refresh: + * + * Refresh rate, in Hertz. + */ int refresh; + + /** + * @rb: + * + * Do we need to use reduced blanking? + */ bool rb; + + /** + * @interlace: + * + * The mode is interlaced. + */ bool interlace; + + /** + * @cvt: + * + * The timings will be calculated using the VESA Coordinated + * Video Timings instead of looking up the mode from a table. + */ bool cvt; + + /** + * @margins: + * + * Add margins to the mode calculation (1.8% of xres rounded + * down to 8 pixels and 1.8% of yres). + */ bool margins; + + /** + * @force: + * + * Ignore the hotplug state of the connector, and force its + * state to one of the DRM_FORCE_* values. + */ enum drm_connector_force force; + + /** + * @rotation_reflection: + * + * Initial rotation and reflection of the mode setup from the + * command line. See DRM_MODE_ROTATE_* and + * DRM_MODE_REFLECT_*. The only rotations supported are + * DRM_MODE_ROTATE_0 and DRM_MODE_ROTATE_180. + */ + unsigned int rotation_reflection; + + /** + * @tv_margins: TV margins to apply to the mode. + */ + struct drm_connector_tv_margins tv_margins; }; /** @@ -1062,12 +1224,6 @@ struct drm_connector { struct drm_property *vrr_capable_property; /** - * @content_protection_property: DRM ENUM property for content - * protection. See drm_connector_attach_content_protection_property(). - */ - struct drm_property *content_protection_property; - - /** * @colorspace_property: Connector property to set the suitable * colorspace supported by the sink. */ @@ -1162,6 +1318,18 @@ struct drm_connector { * [0]: progressive, [1]: interlaced */ int audio_latency[2]; + + /** + * @ddc: associated ddc adapter. + * A connector usually has its associated ddc adapter. If a driver uses + * this field, then an appropriate symbolic link is created in connector + * sysfs directory to make it easy for the user to tell which i2c + * adapter is for a particular display. + * + * The field should be set by calling drm_connector_init_with_ddc(). + */ + struct i2c_adapter *ddc; + /** * @null_edid_counter: track sinks that give us all zeros for the EDID. * Needed to workaround some HW bugs where we get all 0s @@ -1239,6 +1407,9 @@ struct drm_connector { * &drm_mode_config.connector_free_work. */ struct llist_node free_node; + + /** @hdr_sink_metadata: HDR Metadata Information read from sink */ + struct hdr_sink_metadata hdr_sink_metadata; }; #define obj_to_connector(x) container_of(x, struct drm_connector, base) @@ -1247,6 +1418,11 @@ int drm_connector_init(struct drm_device *dev, struct drm_connector *connector, const struct drm_connector_funcs *funcs, int connector_type); +int drm_connector_init_with_ddc(struct drm_device *dev, + struct drm_connector *connector, + const struct drm_connector_funcs *funcs, + int connector_type, + struct i2c_adapter *ddc); void drm_connector_attach_edid_property(struct drm_connector *connector); int drm_connector_register(struct drm_connector *connector); void drm_connector_unregister(struct drm_connector *connector); @@ -1332,6 +1508,7 @@ const char *drm_get_dvi_i_select_name(int val); const char *drm_get_tv_subconnector_name(int val); const char *drm_get_tv_select_name(int val); const char *drm_get_content_protection_name(int val); +const char *drm_get_hdcp_content_type_name(int val); int drm_mode_create_dvi_i_properties(struct drm_device *dev); int drm_mode_create_tv_margin_properties(struct drm_device *dev); @@ -1345,8 +1522,6 @@ int drm_connector_attach_scaling_mode_property(struct drm_connector *connector, u32 scaling_mode_mask); int drm_connector_attach_vrr_capable_property( struct drm_connector *connector); -int drm_connector_attach_content_protection_property( - struct drm_connector *connector); int drm_mode_create_aspect_ratio_property(struct drm_device *dev); int drm_mode_create_colorspace_property(struct drm_connector *connector); int drm_mode_create_content_type_property(struct drm_device *dev); |