diff options
Diffstat (limited to 'include/linux/ethtool.h')
| -rw-r--r-- | include/linux/ethtool.h | 169 |
1 files changed, 86 insertions, 83 deletions
diff --git a/include/linux/ethtool.h b/include/linux/ethtool.h index 93535f093216..cf2abeca92a0 100644 --- a/include/linux/ethtool.h +++ b/include/linux/ethtool.h @@ -15,24 +15,24 @@ /* This should work for both 32 and 64 bit userland. */ struct ethtool_cmd { - u32 cmd; - u32 supported; /* Features this interface supports */ - u32 advertising; /* Features this interface advertises */ - u16 speed; /* The forced speed, 10Mb, 100Mb, gigabit */ - u8 duplex; /* Duplex, half or full */ - u8 port; /* Which connector port */ - u8 phy_address; - u8 transceiver; /* Which transceiver to use */ - u8 autoneg; /* Enable or disable autonegotiation */ - u32 maxtxpkt; /* Tx pkts before generating tx int */ - u32 maxrxpkt; /* Rx pkts before generating rx int */ - u32 reserved[4]; + __u32 cmd; + __u32 supported; /* Features this interface supports */ + __u32 advertising; /* Features this interface advertises */ + __u16 speed; /* The forced speed, 10Mb, 100Mb, gigabit */ + __u8 duplex; /* Duplex, half or full */ + __u8 port; /* Which connector port */ + __u8 phy_address; + __u8 transceiver; /* Which transceiver to use */ + __u8 autoneg; /* Enable or disable autonegotiation */ + __u32 maxtxpkt; /* Tx pkts before generating tx int */ + __u32 maxrxpkt; /* Rx pkts before generating rx int */ + __u32 reserved[4]; }; #define ETHTOOL_BUSINFO_LEN 32 /* these strings are set to whatever the driver author decides... */ struct ethtool_drvinfo { - u32 cmd; + __u32 cmd; char driver[32]; /* driver short name, "tulip", "eepro100" */ char version[32]; /* driver version string */ char fw_version[32]; /* firmware version string, if applicable */ @@ -40,53 +40,53 @@ struct ethtool_drvinfo { /* For PCI devices, use pci_name(pci_dev). */ char reserved1[32]; char reserved2[16]; - u32 n_stats; /* number of u64's from ETHTOOL_GSTATS */ - u32 testinfo_len; - u32 eedump_len; /* Size of data from ETHTOOL_GEEPROM (bytes) */ - u32 regdump_len; /* Size of data from ETHTOOL_GREGS (bytes) */ + __u32 n_stats; /* number of u64's from ETHTOOL_GSTATS */ + __u32 testinfo_len; + __u32 eedump_len; /* Size of data from ETHTOOL_GEEPROM (bytes) */ + __u32 regdump_len; /* Size of data from ETHTOOL_GREGS (bytes) */ }; #define SOPASS_MAX 6 /* wake-on-lan settings */ struct ethtool_wolinfo { - u32 cmd; - u32 supported; - u32 wolopts; - u8 sopass[SOPASS_MAX]; /* SecureOn(tm) password */ + __u32 cmd; + __u32 supported; + __u32 wolopts; + __u8 sopass[SOPASS_MAX]; /* SecureOn(tm) password */ }; /* for passing single values */ struct ethtool_value { - u32 cmd; - u32 data; + __u32 cmd; + __u32 data; }; /* for passing big chunks of data */ struct ethtool_regs { - u32 cmd; - u32 version; /* driver-specific, indicates different chips/revs */ - u32 len; /* bytes */ - u8 data[0]; + __u32 cmd; + __u32 version; /* driver-specific, indicates different chips/revs */ + __u32 len; /* bytes */ + __u8 data[0]; }; /* for passing EEPROM chunks */ struct ethtool_eeprom { - u32 cmd; - u32 magic; - u32 offset; /* in bytes */ - u32 len; /* in bytes */ - u8 data[0]; + __u32 cmd; + __u32 magic; + __u32 offset; /* in bytes */ + __u32 len; /* in bytes */ + __u8 data[0]; }; /* for configuring coalescing parameters of chip */ struct ethtool_coalesce { - u32 cmd; /* ETHTOOL_{G,S}COALESCE */ + __u32 cmd; /* ETHTOOL_{G,S}COALESCE */ /* How many usecs to delay an RX interrupt after * a packet arrives. If 0, only rx_max_coalesced_frames * is used. */ - u32 rx_coalesce_usecs; + __u32 rx_coalesce_usecs; /* How many packets to delay an RX interrupt after * a packet arrives. If 0, only rx_coalesce_usecs is @@ -94,21 +94,21 @@ struct ethtool_coalesce { * to zero as this would cause RX interrupts to never be * generated. */ - u32 rx_max_coalesced_frames; + __u32 rx_max_coalesced_frames; /* Same as above two parameters, except that these values * apply while an IRQ is being serviced by the host. Not * all cards support this feature and the values are ignored * in that case. */ - u32 rx_coalesce_usecs_irq; - u32 rx_max_coalesced_frames_irq; + __u32 rx_coalesce_usecs_irq; + __u32 rx_max_coalesced_frames_irq; /* How many usecs to delay a TX interrupt after * a packet is sent. If 0, only tx_max_coalesced_frames * is used. */ - u32 tx_coalesce_usecs; + __u32 tx_coalesce_usecs; /* How many packets to delay a TX interrupt after * a packet is sent. If 0, only tx_coalesce_usecs is @@ -116,22 +116,22 @@ struct ethtool_coalesce { * to zero as this would cause TX interrupts to never be * generated. */ - u32 tx_max_coalesced_frames; + __u32 tx_max_coalesced_frames; /* Same as above two parameters, except that these values * apply while an IRQ is being serviced by the host. Not * all cards support this feature and the values are ignored * in that case. */ - u32 tx_coalesce_usecs_irq; - u32 tx_max_coalesced_frames_irq; + __u32 tx_coalesce_usecs_irq; + __u32 tx_max_coalesced_frames_irq; /* How many usecs to delay in-memory statistics * block updates. Some drivers do not have an in-memory * statistic block, and in such cases this value is ignored. * This value must not be zero. */ - u32 stats_block_coalesce_usecs; + __u32 stats_block_coalesce_usecs; /* Adaptive RX/TX coalescing is an algorithm implemented by * some drivers to improve latency under low packet rates and @@ -140,18 +140,18 @@ struct ethtool_coalesce { * not implemented by the driver causes these values to be * silently ignored. */ - u32 use_adaptive_rx_coalesce; - u32 use_adaptive_tx_coalesce; + __u32 use_adaptive_rx_coalesce; + __u32 use_adaptive_tx_coalesce; /* When the packet rate (measured in packets per second) * is below pkt_rate_low, the {rx,tx}_*_low parameters are * used. */ - u32 pkt_rate_low; - u32 rx_coalesce_usecs_low; - u32 rx_max_coalesced_frames_low; - u32 tx_coalesce_usecs_low; - u32 tx_max_coalesced_frames_low; + __u32 pkt_rate_low; + __u32 rx_coalesce_usecs_low; + __u32 rx_max_coalesced_frames_low; + __u32 tx_coalesce_usecs_low; + __u32 tx_max_coalesced_frames_low; /* When the packet rate is below pkt_rate_high but above * pkt_rate_low (both measured in packets per second) the @@ -162,43 +162,43 @@ struct ethtool_coalesce { * is above pkt_rate_high, the {rx,tx}_*_high parameters are * used. */ - u32 pkt_rate_high; - u32 rx_coalesce_usecs_high; - u32 rx_max_coalesced_frames_high; - u32 tx_coalesce_usecs_high; - u32 tx_max_coalesced_frames_high; + __u32 pkt_rate_high; + __u32 rx_coalesce_usecs_high; + __u32 rx_max_coalesced_frames_high; + __u32 tx_coalesce_usecs_high; + __u32 tx_max_coalesced_frames_high; /* How often to do adaptive coalescing packet rate sampling, * measured in seconds. Must not be zero. */ - u32 rate_sample_interval; + __u32 rate_sample_interval; }; /* for configuring RX/TX ring parameters */ struct ethtool_ringparam { - u32 cmd; /* ETHTOOL_{G,S}RINGPARAM */ + __u32 cmd; /* ETHTOOL_{G,S}RINGPARAM */ /* Read only attributes. These indicate the maximum number * of pending RX/TX ring entries the driver will allow the * user to set. */ - u32 rx_max_pending; - u32 rx_mini_max_pending; - u32 rx_jumbo_max_pending; - u32 tx_max_pending; + __u32 rx_max_pending; + __u32 rx_mini_max_pending; + __u32 rx_jumbo_max_pending; + __u32 tx_max_pending; /* Values changeable by the user. The valid values are * in the range 1 to the "*_max_pending" counterpart above. */ - u32 rx_pending; - u32 rx_mini_pending; - u32 rx_jumbo_pending; - u32 tx_pending; + __u32 rx_pending; + __u32 rx_mini_pending; + __u32 rx_jumbo_pending; + __u32 tx_pending; }; /* for configuring link flow control parameters */ struct ethtool_pauseparam { - u32 cmd; /* ETHTOOL_{G,S}PAUSEPARAM */ + __u32 cmd; /* ETHTOOL_{G,S}PAUSEPARAM */ /* If the link is being auto-negotiated (via ethtool_cmd.autoneg * being true) the user may set 'autonet' here non-zero to have the @@ -210,9 +210,9 @@ struct ethtool_pauseparam { * then {rx,tx}_pause force the driver to use/not-use pause * flow control. */ - u32 autoneg; - u32 rx_pause; - u32 tx_pause; + __u32 autoneg; + __u32 rx_pause; + __u32 tx_pause; }; #define ETH_GSTRING_LEN 32 @@ -223,10 +223,10 @@ enum ethtool_stringset { /* for passing string sets for data tagging */ struct ethtool_gstrings { - u32 cmd; /* ETHTOOL_GSTRINGS */ - u32 string_set; /* string set id e.c. ETH_SS_TEST, etc*/ - u32 len; /* number of strings in the string set */ - u8 data[0]; + __u32 cmd; /* ETHTOOL_GSTRINGS */ + __u32 string_set; /* string set id e.c. ETH_SS_TEST, etc*/ + __u32 len; /* number of strings in the string set */ + __u8 data[0]; }; enum ethtool_test_flags { @@ -236,26 +236,28 @@ enum ethtool_test_flags { /* for requesting NIC test and getting results*/ struct ethtool_test { - u32 cmd; /* ETHTOOL_TEST */ - u32 flags; /* ETH_TEST_FL_xxx */ - u32 reserved; - u32 len; /* result length, in number of u64 elements */ - u64 data[0]; + __u32 cmd; /* ETHTOOL_TEST */ + __u32 flags; /* ETH_TEST_FL_xxx */ + __u32 reserved; + __u32 len; /* result length, in number of u64 elements */ + __u64 data[0]; }; /* for dumping NIC-specific statistics */ struct ethtool_stats { - u32 cmd; /* ETHTOOL_GSTATS */ - u32 n_stats; /* number of u64's being returned */ - u64 data[0]; + __u32 cmd; /* ETHTOOL_GSTATS */ + __u32 n_stats; /* number of u64's being returned */ + __u64 data[0]; }; struct ethtool_perm_addr { - u32 cmd; /* ETHTOOL_GPERMADDR */ - u32 size; - u8 data[0]; + __u32 cmd; /* ETHTOOL_GPERMADDR */ + __u32 size; + __u8 data[0]; }; +#ifdef __KERNEL__ + struct net_device; /* Some generic methods drivers may use in their ethtool_ops */ @@ -371,6 +373,7 @@ struct ethtool_ops { u32 (*get_ufo)(struct net_device *); int (*set_ufo)(struct net_device *, u32); }; +#endif /* __KERNEL__ */ /* CMDs currently supported */ #define ETHTOOL_GSET 0x00000001 /* Get settings. */ |