diff options
Diffstat (limited to 'include/net/mac80211.h')
| -rw-r--r-- | include/net/mac80211.h | 11 |
1 files changed, 5 insertions, 6 deletions
diff --git a/include/net/mac80211.h b/include/net/mac80211.h index 7f256e23c57f..20d372edec29 100644 --- a/include/net/mac80211.h +++ b/include/net/mac80211.h @@ -147,6 +147,8 @@ struct ieee80211_low_level_stats { * @BSS_CHANGED_CQM: Connection quality monitor config changed * @BSS_CHANGED_IBSS: IBSS join status changed * @BSS_CHANGED_ARP_FILTER: Hardware ARP filter address list or state changed. + * @BSS_CHANGED_QOS: QoS for this association was enabled/disabled. Note + * that it is only ever disabled for station mode. */ enum ieee80211_bss_change { BSS_CHANGED_ASSOC = 1<<0, @@ -162,6 +164,7 @@ enum ieee80211_bss_change { BSS_CHANGED_CQM = 1<<10, BSS_CHANGED_IBSS = 1<<11, BSS_CHANGED_ARP_FILTER = 1<<12, + BSS_CHANGED_QOS = 1<<13, /* when adding here, make sure to change ieee80211_reconfig */ }; @@ -217,6 +220,7 @@ enum ieee80211_bss_change { * filter ARP queries based on the @arp_addr_list, if disabled, the * hardware must not perform any ARP filtering. Note, that the filter will * be enabled also in promiscuous mode. + * @qos: This is a QoS-enabled BSS. */ struct ieee80211_bss_conf { const u8 *bssid; @@ -240,6 +244,7 @@ struct ieee80211_bss_conf { __be32 arp_addr_list[IEEE80211_BSS_ARP_ADDR_LIST_LEN]; u8 arp_addr_cnt; bool arp_filter_enabled; + bool qos; }; /** @@ -620,15 +625,11 @@ struct ieee80211_rx_status { * may turn the device off as much as possible. Typically, this flag will * be set when an interface is set UP but not associated or scanning, but * it can also be unset in that case when monitor interfaces are active. - * @IEEE80211_CONF_QOS: Enable 802.11e QoS also know as WMM (Wireless - * Multimedia). On some drivers (iwlwifi is one of know) we have - * to enable/disable QoS explicitly. */ enum ieee80211_conf_flags { IEEE80211_CONF_MONITOR = (1<<0), IEEE80211_CONF_PS = (1<<1), IEEE80211_CONF_IDLE = (1<<2), - IEEE80211_CONF_QOS = (1<<3), }; @@ -643,7 +644,6 @@ enum ieee80211_conf_flags { * @IEEE80211_CONF_CHANGE_RETRY_LIMITS: retry limits changed * @IEEE80211_CONF_CHANGE_IDLE: Idle flag changed * @IEEE80211_CONF_CHANGE_SMPS: Spatial multiplexing powersave mode changed - * @IEEE80211_CONF_CHANGE_QOS: Quality of service was enabled or disabled */ enum ieee80211_conf_changed { IEEE80211_CONF_CHANGE_SMPS = BIT(1), @@ -654,7 +654,6 @@ enum ieee80211_conf_changed { IEEE80211_CONF_CHANGE_CHANNEL = BIT(6), IEEE80211_CONF_CHANGE_RETRY_LIMITS = BIT(7), IEEE80211_CONF_CHANGE_IDLE = BIT(8), - IEEE80211_CONF_CHANGE_QOS = BIT(9), }; /** |