aboutsummaryrefslogtreecommitdiffstats
path: root/arch/i386/kernel/i8253.c (follow)
AgeCommit message (Collapse)AuthorFilesLines
2007-03-22[PATCH] i386: clockevents fix breakage on Geode/Cyrix PIT implementationsThomas Gleixner1-1/+9
The PIT has no dedicated mode for shut down. The only way to disable PIT is to put it into one shot mode. AMD implementations of PIT on Geode (also observed on Cyrix) are confused by an "empty" transition from CLOCK_EVT_MODE_UNUSED to CLOCK_EVT_MODE_SHUTDOWN, which puts the PIT into one shot mode momentarily. I realized after staring helpless at the bug report http://bugzilla.kernel.org/show_bug.cgi?id=8027 for quite a while, that the only change, which might influence the bogomips calibration, is the above transition during the PIT initialization. Avoiding the unnecessary switch to oneshot and later to periodic mode fixes the weird bogomips value and also the resulting slowness. The fix is confirmed on OLPC and another Geode based box. Note: this is unrelated to the Dual Core problem discussed here: http://lkml.org/lkml/2007/3/17/48 Signed-off-by: Thomas Gleixner <tglx@linutronix.de> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
2007-03-05[PATCH] clocksource init adjustments (fix bug #7426)john stultz1-1/+1
This patch resolves the issue found here: http://bugme.osdl.org/show_bug.cgi?id=7426 The basic summary is: Currently we register most of i386/x86_64 clocksources at module_init time. Then we enable clocksource selection at late_initcall time. This causes some problems for drivers that use gettimeofday for init calibration routines (specifically the es1968 driver in this case), where durring module_init, the only clocksource available is the low-res jiffies clocksource. This may cause slight calibration errors, due to the small sampling time used. It should be noted that drivers that require fine grained time may not function on architectures that do not have better then jiffies resolution timekeeping (there are a few). However, this does not discount the reasonable need for such fine-grained timekeeping at init time. Thus the solution here is to register clocksources earlier (ideally when the hardware is being initialized), and then we enable clocksource selection at fs_initcall (before device_initcall). This patch should probably get some testing time in -mm, since clocksource selection is one of the most important issues for correct timekeeping, and I've only been able to test this on a few of my own boxes. Signed-off-by: John Stultz <johnstul@us.ibm.com> Cc: Thomas Gleixner <tglx@linutronix.de> Cc: Ingo Molnar <mingo@elte.hu> Cc: "David S. Miller" <davem@davemloft.net> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
2007-02-16[PATCH] clockevents: i386 driversThomas Gleixner1-8/+88
Add clockevent drivers for i386: lapic (local) and PIT/HPET (global). Update the timer IRQ to call into the PIT/HPET driver's event handler and the lapic-timer IRQ to call into the lapic clockevent driver. The assignement of timer functionality is delegated to the core framework code and replaces the compile and runtime evalution in do_timer_interrupt_hook() Use the clockevents broadcast support and implement the lapic_broadcast function for ACPI. No changes to existing functionality. [ kdump fix from Vivek Goyal <vgoyal@in.ibm.com> ] [ fixes based on review feedback from Arjan van de Ven <arjan@infradead.org> ] Cleanups-from: Adrian Bunk <bunk@stusta.de> Build-fixes-from: Andrew Morton <akpm@osdl.org> Signed-off-by: Thomas Gleixner <tglx@linutronix.de> Signed-off-by: Ingo Molnar <mingo@elte.hu> Cc: john stultz <johnstul@us.ibm.com> Cc: Roman Zippel <zippel@linux-m68k.org> Cc: Andi Kleen <ak@suse.de> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
2006-10-17[PATCH] i386 Time: Avoid PIT SMP lockupsjohn stultz1-1/+1
Avoid possible PIT livelock issues seen on SMP systems (and reported by Andi), by not allowing it as a clocksource on SMP boxes. However, since the PIT may no longer be present, we have to properly handle the cases where SMP systems have TSC skew and fall back from the TSC. Since the PIT isn't there, it would "fall back" to the TSC again. So this changes the jiffies rating to 1, and the TSC-bad rating value to 0. Thus you will get the following behavior priority on i386 systems: tsc [if present & stable] hpet [if present] cyclone [if present] acpi_pm [if present] pit [if UP] jiffies Rather then the current more complicated: tsc [if present & stable] hpet [if present] cyclone [if present] acpi_pm [if present] pit [if cpus < 4] tsc [if present & unstable] jiffies Signed-off-by: John Stultz <johnstul@us.ibm.com> Cc: Andi Kleen <ak@suse.de> Cc: Ingo Molnar <mingo@elte.hu> Cc: Thomas Gleixner <tglx@linutronix.de> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2006-06-26[PATCH] time: fix time going backward w/ clock=pitjohn stultz1-6/+39
Here is the PIT fix against the TOD patches that Tim pointed out. Many thanks to Tim for hunting this down. Cc: Tim Mann <mann@vmware.com> Signed-off-by: John Stultz <johnstul@us.ibm.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2006-06-26[PATCH] generic-time: add macro to simplify/hide mask constantsJim Cromie1-1/+1
Add a CLOCKSOURCE_MASK macro to simplify initializing the mask for a struct clocksource, and use it to replace literal mask constants in the various clocksource drivers. Signed-off-by: Jim Cromie <jim.cromie@gmail.com> Acked-by: John Stultz <johnstul@us.ibm.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2006-06-26[PATCH] time: rename clocksource functionsjohn stultz1-1/+1
As suggested by Roman Zippel, change clocksource functions to use clocksource_xyz rather then xyz_clocksource to avoid polluting the namespace. Signed-off-by: John Stultz <johnstul@us.ibm.com> Cc: Roman Zippel <zippel@linux-m68k.org> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2006-06-26[PATCH] Time: i386 Clocksource Driversjohn stultz1-0/+53
Implement the time sources for i386 (acpi_pm, cyclone, hpet, pit, and tsc). With this patch, the conversion of the i386 arch to the generic timekeeping code should be complete. The patch should be fairly straight forward, only adding the new clocksources. [hirofumi@mail.parknet.co.jp: acpi_pm cleanup] Signed-off-by: John Stultz <johnstul@us.ibm.com> Signed-off-by: Adrian Bunk <bunk@stusta.de> Signed-off-by: Paul Mundt <lethal@linux-sh.org> Signed-off-by: John Stultz <johnstul@us.ibm.com> Signed-off-by: OGAWA Hirofumi <hirofumi@mail.parknet.co.jp> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2006-06-26[PATCH] Time: i386 Conversion - part 1: Move timer_pit.c to i8253.cjohn stultz1-0/+32
A simple cleanup for the i386 arch in preparation of moving to the generic timeofday infrastructure. It simply moves the PIT initialization code, locks, and other code we want to keep from some code from timer_pit.c (which will be removed) to i8253.c. Signed-off-by: John Stultz <johnstul@us.ibm.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>