aboutsummaryrefslogtreecommitdiffstats
path: root/arch/ia64/mm (follow)
AgeCommit message (Collapse)AuthorFilesLines
2005-06-23[PATCH] Kprobes/IA64: kdebug die notification mechanismAnil S Keshavamurthy1-0/+8
As many of you know that kprobes exist in the main line kernel for various architecture including i386, x86_64, ppc64 and sparc64. Attached patches following this mail are a port of Kprobes and Jprobes for IA64. I have tesed this patches for kprobes and Jprobes and this seems to work fine. I have tested this patch by inserting kprobes on various slots and various templates including various types of branch instructions. I have also tested this patch using the tool http://marc.theaimsgroup.com/?l=linux-kernel&m=111657358022586&w=2 and the kprobes for IA64 works great. Here is list of TODO things and pathes for the same will appear soon. 1) Support kprobes on "mov r1=ip" type of instruction 2) Support Kprobes and Jprobes to exist on the same address 3) Support Return probes 3) Architecture independent cleanup of kprobes This patch adds the kdebug die notification mechanism needed by Kprobes. For break instruction on Branch type slot, imm21 is ignored and value zero is placed in IIM register, hence we need to handle kprobes for switch case zero. Signed-off-by: Anil S Keshavamurthy <anil.s.keshavamurthy@intel.com> Signed-off-by: Rusty Lynch <Rusty.lynch@intel.com> From: Rusty Lynch <rusty.lynch@intel.com> At the point in traps.c where we recieve a break with a zero value, we can not say if the break was a result of a kprobe or some other debug facility. This simple patch changes the informational string to a more correct "break 0" value, and applies to the 2.6.12-rc2-mm2 tree with all the kprobes patches that were just recently included for the next mm cut. Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2005-06-23[PATCH] remove non-DISCONTIG use of pgdat->node_mem_mapDave Hansen1-4/+5
This patch effectively eliminates direct use of pgdat->node_mem_map outside of the DISCONTIG code. On a flat memory system, these fields aren't currently used, neither are they on a sparsemem system. There was also a node_mem_map(nid) macro on many architectures. Its use along with the use of ->node_mem_map itself was not consistent. It has been removed in favor of two new, more explicit, arch-independent macros: pgdat_page_nr(pgdat, pagenr) nid_page_nr(nid, pagenr) I called them "pgdat" and "nid" because we overload the term "node" to mean "NUMA node", "DISCONTIG node" or "pg_data_t" in very confusing ways. I believe the newer names are much clearer. These macros can be overridden in the sparsemem case with a theoretically slower operation using node_start_pfn and pfn_to_page(), instead. We could make this the only behavior if people want, but I don't want to change too much at once. One thing at a time. This patch removes more code than it adds. Compile tested on alpha, alpha discontig, arm, arm-discontig, i386, i386 generic, NUMAQ, Summit, ppc64, ppc64 discontig, and x86_64. Full list here: http://sr71.net/patches/2.6.12/2.6.12-rc1-mhp2/configs/ Boot tested on NUMAQ, x86 SMP and ppc64 power4/5 LPARs. Signed-off-by: Dave Hansen <haveblue@us.ibm.com> Signed-off-by: Martin J. Bligh <mbligh@aracnet.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2005-06-21[PATCH] Hugepage consolidationDavid Gibson1-156/+2
A lot of the code in arch/*/mm/hugetlbpage.c is quite similar. This patch attempts to consolidate a lot of the code across the arch's, putting the combined version in mm/hugetlb.c. There are a couple of uglyish hacks in order to covert all the hugepage archs, but the result is a very large reduction in the total amount of code. It also means things like hugepage lazy allocation could be implemented in one place, instead of six. Tested, at least a little, on ppc64, i386 and x86_64. Notes: - this patch changes the meaning of set_huge_pte() to be more analagous to set_pte() - does SH4 need s special huge_ptep_get_and_clear()?? Acked-by: William Lee Irwin <wli@holomorphy.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2005-06-08[IA64] Fill holes in FIXADDR_USER space with zero pages.David Mosberger-Tang1-2/+17
This fixes an oops reported by Jason Baron. Signed-off-by: David Mosberger-Tang <davidm@hpl.hp.com> Signed-off-by: Tony Luck <tony.luck@intel.com>
2005-04-25[IA64] Need to handle lfetch in "no_context" case.Tony Luck1-3/+6
Thanks to Mark for tracking down this one. Users of __copy_from_user_inatomic() will be sad if we don't handle lfetch faults for the "no_context" case. Signed-off-by: Tony Luck <tony.luck@intel.com>
2005-04-25[IA64] MAX_PGT_FREES_PER_PASS must be 'L' to avoid warningTony Luck1-1/+1
'min' is very picky about types of arguments, make it happy Signed-off-by: Tony Luck <tony.luck@intel.com>
2005-04-25[IA64] Percpu quicklist for combined allocator for pgd/pmd/pte.Robin Holt3-29/+51
This patch introduces using the quicklists for pgd, pmd, and pte levels by combining the alloc and free functions into a common set of routines. This greatly simplifies the reading of this header file. This patch is simple but necessary for large numa configurations. It simply ensures that only pages from the local node are added to a cpus quicklist. This prevents the trapping of pages on a remote nodes quicklist by starting a process, touching a large number of pages to fill pmd and pte entries, migrating to another node, and then unmapping or exiting. With those conditions, the pages get trapped and if the machine has more than 100 nodes of the same size, the calculation of the pgtable high water mark will be larger than any single node so page table cache flushing will never occur. I ran lmbench lat_proc fork and lat_proc exec on a zx1 with and without this patch and did not notice any change. On an sn2 machine, there was a slight improvement which is possibly due to pages from other nodes trapped on the test node before starting the run. I did not investigate further. This patch shrinks the quicklist based upon free memory on the node instead of the high/low water marks. I have written it to enable preemption periodically and recalculate the amount to shrink every time we have freed enough pages that the quicklist size should have grown. I rescan the nodes zones each pass because other processess may be draining node memory at the same time as we are adding. Signed-off-by: Robin Holt <holt@sgi.com> Signed-off-by: Tony Luck <tony.luck@intel.com>
2005-04-19[PATCH] freepgt: hugetlb_free_pgd_rangeHugh Dickins1-6/+23
ia64 and ppc64 had hugetlb_free_pgtables functions which were no longer being called, and it wasn't obvious what to do about them. The ppc64 case turns out to be easy: the associated tables are noted elsewhere and freed later, safe to either skip its hugetlb areas or go through the motions of freeing nothing. Since ia64 does need a special case, restore to ppc64 the special case of skipping them. The ia64 hugetlb case has been broken since pgd_addr_end went in, though it probably appeared to work okay if you just had one such area; in fact it's been broken much longer if you consider a long munmap spanning from another region into the hugetlb region. In the ia64 hugetlb region, more virtual address bits are available than in the other regions, yet the page tables are structured the same way: the page at the bottom is larger. Here we need to scale down each addr before passing it to the standard free_pgd_range. Was about to write a hugely_scaled_down macro, but found htlbpage_to_page already exists for just this purpose. Fixed off-by-one in ia64 is_hugepage_only_range. Uninline free_pgd_range to make it available to ia64. Make sure the vma-gathering loop in free_pgtables cannot join a hugepage_only_range to any other (safe to join huges? probably but don't bother). Signed-off-by: Hugh Dickins <hugh@veritas.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2005-04-19[PATCH] freepgt: free_pgtables use vma listHugh Dickins1-35/+2
Recent woes with some arches needing their own pgd_addr_end macro; and 4-level clear_page_range regression since 2.6.10's clear_page_tables; and its long-standing well-known inefficiency in searching throughout the higher-level page tables for those few entries to clear and free: all can be blamed on ignoring the list of vmas when we free page tables. Replace exit_mmap's clear_page_range of the total user address space by free_pgtables operating on the mm's vma list; unmap_region use it in the same way, giving floor and ceiling beyond which it may not free tables. This brings lmbench fork/exec/sh numbers back to 2.6.10 (unless preempt is enabled, in which case latency fixes spoil unmap_vmas throughput). Beware: the do_mmap_pgoff driver failure case must now use unmap_region instead of zap_page_range, since a page table might have been allocated, and can only be freed while it is touched by some vma. Move free_pgtables from mmap.c to memory.c, where its lower levels are adapted from the clear_page_range levels. (Most of free_pgtables' old code was actually for a non-existent case, prev not properly set up, dating from before hch gave us split_vma.) Pass mmu_gather** in the public interfaces, since we might want to add latency lockdrops later; but no attempt to do so yet, going by vma should itself reduce latency. But what if is_hugepage_only_range? Those ia64 and ppc64 cases need careful examination: put that off until a later patch of the series. What of x86_64's 32bit vdso page __map_syscall32 maps outside any vma? And the range to sparc64's flush_tlb_pgtables? It's less clear to me now that we need to do more than is done here - every PMD_SIZE ever occupied will be flushed, do we really have to flush every PGDIR_SIZE ever partially occupied? A shame to complicate it unnecessarily. Special thanks to David Miller for time spent repairing my ceilings. Signed-off-by: Hugh Dickins <hugh@veritas.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2005-04-16Linux-2.6.12-rc2Linus Torvalds9-0/+2592
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!