| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
The ADL5240 is a high performance, digitally controlled variable gain
amplifier (VGA) operating from 100 MHz to 4000 MHz. The VGA integrates a
high performance, 20 dB gain, internally matched amplifier (AMP) with a
6-bit digital step attenuator (DSA) that has a gain control range of
31.5 dB in 0.5 dB steps with ±0.25 dB step accuracy.
Datasheet link:
https://www.analog.com/media/en/technical-documentation/data-sheets/adl5240.pdf
Signed-off-by: Alexandru Ardelean <alexandru.ardelean@analog.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
|
|
This change adds support for the ADA4961 BiCMOS RF Digital Gain Amplifier,
(DGA), which is optimized for driving heavy loads out 2.0 GHz and beyond.
The device typically achieves -90 dBc IMD3 performance at 500 MHz and
-85 dBc at 1.5 GHz.
Datasheet link:
http://www.analog.com/media/en/technical-documentation/data-sheets/ADA4961.pdf
This change re-uses the existing ad8366 driver, as most logic is similar.
Also, this chip has a reset pin which is initialized during probe.
Signed-off-by: Paul Cercueil <paul.cercueil@analog.com>
Signed-off-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Alexandru Ardelean <alexandru.ardelean@analog.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
|
|
The SPI gain amplifiers are simple devices, with 1 or 2 channels, to which
are read-from/written-to.
The gain computation in ad8366_write_raw() has been updated to compute gain
in dB for negative values.
This driver will be extended to support other chips as well.
To do that, this rework handles the AD8366 device as a special-case (via
switch-statements). This will make things easier when adding new chips.
Signed-off-by: Alexandru Ardelean <alexandru.ardelean@analog.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
|
|
This driver is still using iio_dev's mlock to guard against inconsistent
state. This has been discouraged for some time.
This change switches to using it's own mutex, defined on the state struct.
Signed-off-by: Alexandru Ardelean <alexandru.ardelean@analog.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
|
|
Use the new `SPDX-License-Identifier` tag to specify the license.
For ad8366, also update copyright years in the header part.
Signed-off-by: Alexandru Ardelean <alexandru.ardelean@analog.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
|
|
no functional changes
Signed-off-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
|
|
Otherwise a race condition can occur, where userspace can start operations
before the channels have been properly initialized.
Signed-off-by: Alexandru Ardelean <alexandru.ardelean@analog.com>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
|
|
The equivalent of both of these are now done via macro magic when
the relevant register calls are made. The actual structure
elements will shortly go away.
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Reviewed-by: Lars-Peter Clausen <lars@metafoo.de>
|
|
Pull spi updates from Mark Brown:
"Quite a lot of activity in SPI this cycle, almost all of it in drivers
with a few minor improvements and tweaks in the core.
- Updates to pxa2xx to support Intel Broxton and multiple chip selects.
- Support for big endian in the bcm63xx driver.
- Multiple slave support for the mt8173
- New driver for the auxiliary SPI controller in bcm2835 SoCs.
- Support for Layerscale SoCs in the Freescale DSPI driver"
* tag 'spi-v4.4' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi: (87 commits)
spi: pxa2xx: Rework self-initiated platform data creation for non-ACPI
spi: pxa2xx: Add support for Intel Broxton
spi: pxa2xx: Detect number of enabled Intel LPSS SPI chip select signals
spi: pxa2xx: Add output control for multiple Intel LPSS chip selects
spi: pxa2xx: Use LPSS prefix for defines that are Intel LPSS specific
spi: Add DSPI support for layerscape family
spi: ti-qspi: improve ->remove() callback
spi/spi-xilinx: Fix race condition on last word read
spi: Drop owner assignment from spi_drivers
spi: Add THIS_MODULE to spi_driver in SPI core
spi: Setup the master controller driver before setting the chipselect
spi: dw: replace magic constant by DW_SPI_DR
spi: mediatek: mt8173 spi multiple devices support
spi: mediatek: handle controller_data in mtk_spi_setup
spi: mediatek: remove mtk_spi_config
spi: mediatek: Update document devicetree bindings to support multiple devices
spi: fix kernel-doc warnings about missing return desc in spi.c
spi: fix kernel-doc warnings about missing return desc in spi.h
spi: pxa2xx: Align a few defines
spi: pxa2xx: Save other reg_cs_ctrl bits when configuring chip select
...
|
|
An spi_driver does not need to set an owner, it will be populated by the
driver core.
Signed-off-by: Andrew F. Davis <afd@ti.com>
Acked-by: Jonathan Cameron <jic23@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
The SPI core always reports the MODALIAS uevent as "spi:<modalias>"
regardless of the mechanism that was used to register the device
(i.e: OF or board code) and the table that is used later to match
the driver with the device (i.e: SPI id table or OF match table).
So drivers needs to export the SPI id table and this be built into
the module or udev won't have the necessary information to autoload
the needed driver module when the device is added.
Signed-off-by: Javier Martinez Canillas <javier@osg.samsung.com>
Acked-by: Lars-Peter Clausen <lars@metafoo.de>
Signed-off-by: Jonathan Cameron <jic23@kernel.org>
|
|
This patch fixes the following checkpatch.pl warning:
WARNING: type 'char unsigned' should be specified in [[un]signed]
[short|int|long|long long] order
Signed-off-by: Roberta Dobrescu <roberta.dobrescu@gmail.com>
Signed-off-by: Jonathan Cameron <jic23@kernel.org>
|
|
This patch fixes the following checkpatch.pl error:
ERROR: space prohibited before that ',' (ctx:WxW)
Signed-off-by: Roberta Dobrescu <roberta.dobrescu@gmail.com>
Signed-off-by: Jonathan Cameron <jic23@kernel.org>
|
|
Since devm_regulator_get is used, regulator_put should not be
used. Remove it.
Signed-off-by: Sachin Kamat <sachin.kamat@linaro.org>
Signed-off-by: Jonathan Cameron <jic23@kernel.org>
|
|
devm_* APIs are device managed and make code simpler.
Signed-off-by: Sachin Kamat <sachin.kamat@linaro.org>
Cc: Michael Hennerich <hennerich@blackfin.uclinux.org>
Signed-off-by: Jonathan Cameron <jic23@kernel.org>
|
|
The original info_mask is going away in favour of the broken out versions.
Signed-off-by: Jonathan Cameron <jic23@kernel.org>
Acked-by: Michael Hennerich <michael.hennerich@analog.com>
|
|
CONFIG_HOTPLUG is going away as an option. As a result, the __dev*
markings need to be removed.
This change removes the use of __devinit, __devexit_p, and __devexit
from these drivers.
Based on patches originally written by Bill Pemberton, but redone by me
in order to handle some of the coding style issues better, by hand.
Cc: Bill Pemberton <wfp5p@virginia.edu>
Cc: Jonathan Cameron <jic23@cam.ac.uk>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
|
|
Changes since V1:
Apply review feedback:
Introduce and use IIO_CHAN_INFO_HARDWAREGAIN
Introduce and use Use IIO_VAL_INT_PLUS_MICRO_DB
Modify out of staging include paths.
Convert to new iio core API naming.
Changes since V2:
more sanity checking in write_raw
Signed-off-by: Michael Hennerich <michael.hennerich@analog.com>
Acked-by: Jonathan Cameron <jic23@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
|
Alexandru Ardelean
Paul Cercueil
Michael Hennerich
Jonathan Cameron
Linus Torvalds
Andrew F. Davis
Javier Martinez Canillas
Roberta Dobrescu
Sachin Kamat
Greg Kroah-Hartman