Age | Commit message (Expand) | Author | Files | Lines |
---|---|---|---|---|
2009-07-05 | bnx2x: Disable HC coalescing when setting timeout to zero. | 1 | -2/+2 | |
2009-06-30 | bnx2x: Fix the behavior of ethtool when ONBOOT=no | 1 | -1/+9 | |
2009-05-29 | net: dont update dev->trans_start in 10GB drivers | 1 | -1/+0 | |
2009-05-08 | bnx2x: do not return negative number of received packages | 1 | -1/+1 | |
2009-05-08 | bnx2x: free workqueue when driver fail to register | 1 | -1/+8 | |
2009-04-27 | bnx2x: driver version 1.48.105-1 | 1 | -2/+2 | |
2009-04-27 | bnx2x: Separated FW from the source. | 1 | -62/+281 | |
2009-04-07 | dma-mapping: replace all DMA_32BIT_MASK macro with DMA_BIT_MASK(32) | 1 | -1/+1 | |
2009-04-07 | dma-mapping: replace all DMA_64BIT_MASK macro with DMA_BIT_MASK(64) | 1 | -2/+2 | |
2009-03-02 | bnx2x: Version update | 1 | -2/+2 | |
2009-03-02 | bnx2x: Register dump | 1 | -0/+81 | |
2009-03-02 | bnx2x: Debug prints | 1 | -19/+19 | |
2009-03-02 | bnx2x: Whitespace | 1 | -0/+1 | |
2009-03-02 | bnx2x: Calling tx disable unconditionally | 1 | -4/+2 | |
2009-03-02 | bnx2x: Using DMA engine | 1 | -39/+12 | |
2009-03-02 | bnx2x: Missing module parameter description | 1 | -0/+1 | |
2009-03-02 | bnx2x: napi_poll budget check | 1 | -4/+18 | |
2009-03-02 | bnx2x: Unlimited Tx interrupt work | 1 | -7/+4 | |
2009-03-02 | bnx2x: Add rmb to read status block indices on load | 1 | -0/+4 | |
2009-03-02 | bnx2x: Reduce the likelihood of smb_mb | 1 | -7/+8 | |
2009-03-02 | bnx2x: Remove redundant smb_mb on unload | 1 | -2/+0 | |
2009-02-15 | bnx2x: Version | 1 | -2/+2 | |
2009-02-15 | bnx2x: Clean-up | 1 | -12/+23 | |
2009-02-15 | bnx2x: Comments and prints | 1 | -21/+22 | |
2009-02-15 | bnx2x: Re-arrange module parameters | 1 | -7/+7 | |
2009-02-15 | bnx2x: Moving includes | 1 | -4/+1 | |
2009-02-15 | bnx2x: Driver dump | 1 | -38/+59 | |
2009-02-15 | bnx2x: Sparse endianity annotation | 1 | -31/+32 | |
2009-02-15 | bnx2x: Removing redundant macros | 1 | -26/+26 | |
2009-02-15 | bnx2x: Loopback in diag mode | 1 | -24/+33 | |
2009-02-15 | bnx2x: Using nvram default WoL config | 1 | -0/+6 | |
2009-02-15 | bnx2x: smp_mb and not just smp_rmb | 1 | -2/+2 | |
2009-02-15 | bnx2x: Increasing FW timeout | 1 | -2/+6 | |
2009-02-15 | bnx2x: Returning EBUSY in debug mode as well | 1 | -2/+1 | |
2009-02-15 | bnx2x: Manual setting for MRRS | 1 | -0/+6 | |
2009-02-15 | bnx2x: Pre emphasis configuration | 1 | -6/+25 | |
2009-02-15 | bnx2x: Supporting BCM8481 PHY | 1 | -0/+17 | |
2009-02-15 | bnx2x: PHY lock list | 1 | -10/+10 | |
2009-02-15 | bnx2x: Supporting BCM8726 PHY | 1 | -15/+75 | |
2009-02-15 | bnx2x: GPIO accessories | 1 | -2/+78 | |
2009-02-15 | bnx2x: Removing redundant device parameters | 1 | -10/+9 | |
2009-02-15 | bnx2x: Removing the board type | 1 | -13/+7 | |
2009-02-15 | bnx2x: Flow control enhancement | 1 | -9/+87 | |
2009-02-15 | bnx2x: BW shaper enhancements | 1 | -178/+136 | |
2009-02-15 | bnx2x: Moving skb_record_rx_queue | 1 | -1/+1 | |
2009-02-15 | bnx2x: Per queue statistics | 1 | -259/+545 | |
2009-02-15 | bnx2x: Removing microcode assertion check | 1 | -5/+1 | |
2009-02-15 | bnx2x: Disabling interrupts after iSCSI-boot | 1 | -2/+59 | |
2009-02-15 | bnx2x: System-page alignment | 1 | -7/+4 | |
2009-02-15 | bnx2x: MSI support | 1 | -47/+108 |