| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
All routing debug messages are saved in a ring buffer that can be
read via the debugfs file "log".
Note that CONFIG_BATMAN_ADV_DEBUG must be activated to have the
debug logs compiled in.
Signed-off-by: Marek Lindner <lindner_marek@yahoo.de>
Signed-off-by: Sven Eckelmann <sven.eckelmann@gmx.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
|
|
This patch changes the sequence number range from 8 or 16 bit to 32 bit.
This should avoid problems with the sequence number sliding window algorithm
which we had seen in the past for broadcast floods or malicious packet
injections. We can not assure 100% security with this patch, but it is quite
an improvement over the old 16 bit sequence numbers:
* expected window size can be increased (4096 -> 65536)
* 64k packets in the right order would now be needed to cause a loop,
which seems practically impossible.
Furthermore, a TTL field has been added to the broadcast packet type, just to
make sure.
These changes required to increase the compatibility level once again.
Signed-off-by: Simon Wunderlich <siwu@hrz.tu-chemnitz.de>
[sven.eckelmann@gmx.de: Change atomic64_* back to atomic_*, Rework on
top of current version]
Signed-off-by: Sven Eckelmann <sven.eckelmann@gmx.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
|
|
This patch limits the queue lengths of batman and broadcast packets. BATMAN
packets are held back for aggregation and jittered to avoid interferences.
Broadcast packets are stored to be sent out multiple times to increase
the probability to be received by other nodes in lossy environments.
Especially in extreme cases like broadcast storms, the queues have been seen
to run full, eating up all the memory and triggering the infamous OOM killer.
With the queue length limits introduced in this patch, this problem is
avoided.
Each queue is limited to 256 entries for now, resulting in 1 MB of maximum
space available in total for typical setups (assuming one packet including
overhead does not require more than 2000 byte). This should also be reasonable
for smaller routers, otherwise the defines can be tweaked later.
This third version of the patch does not increase the local broadcast
sequence number when the queue is already full.
Signed-off-by: Simon Wunderlich <siwu@hrz.tu-chemnitz.de>
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
|
|
converted files:
vis_mode, vis_data
Signed-off-by: Marek Lindner <lindner_marek@yahoo.de>
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
|
|
This is the first patch in a series of patches which aim to convert
all batman-adv /proc files to sysfs. To keep the changes in a
digestable size it has been split up into smaller chunks. During
the transition period batman-adv will use /proc as well as sysfs.
As a first step the following files have been converted:
aggregate_ogm, originators, transtable_global, transtable_local
Signed-off-by: Marek Lindner <lindner_marek@yahoo.de>
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
|
|
Signed-off-by: Simon Wunderlich <siwu@hrz.tu-chemnitz.de>
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
|
|
So far, neighbour's secondary interface OGMs can involuntarily
piggyback on primary interface OGMs that arrived on the same secondary
interface before. Secondary interface OGMs should NEVER leave their
direct neighbour broadcast domain! This patch ensures that secondary
interface OGMs can only be aggregated to other secondary interface OGMs.
Signed-off-by: Linus Lüssing <linus.luessing@web.de>
Signed-off-by: Marek Lindner <lindner_marek@yahoo.de>
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
|
|
batman-adv aggregates routing packets to reduce the number of packets in
the air. Every outgoing packet is compared with other packets in the
buffer to determine whether it can be aggregated or not. Packets sent
at a lower interval can be held back longer to maximize the aggregation.
Due to insufficient checking batman-adv held back all packets for a
certain time depending on its own lowest interval rate which slowed
down all other nodes.
Reported-by: Linus Lüssing <linus.luessing@web.de>
Signed-off-by: Marek Lindner <lindner_marek@yahoo.de>
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
|
|
This patch removes the (ugly and racy) packet receiving thread and the
kernel socket usage. Instead, packets are received directly by registering
the ethernet type and handling skbs instead of self-allocated buffers.
Some consequences and comments:
* we don't copy the payload data when forwarding/sending/receiving data
anymore. This should boost performance.
* packets from/to different interfaces can be (theoretically) processed
simultaneously. Only the big originator hash lock might be in the way.
* no more polling or sleeping/wakeup/scheduling issues when receiving
packets
* this might introduce new race conditions.
* aggregation and vis code still use packet buffers and are not (yet)
converted.
* all spinlocks were converted to irqsave/restore versions to solve
some lifelock issues when preempted. This might be overkill, some
of these locks might be reverted later.
* skb copies are only done if neccesary to avoid overhead
performance differences:
* we made some "benchmarks" with intel laptops.
* bandwidth on Gigabit Ethernet increased from ~500 MBit/s to ~920 MBit/s
* ping latency decresed from ~2ms to ~0.2 ms
I did some tests on my 9 node qemu environment and could confirm that
usual sending/receiving, forwarding, vis, batctl ping etc works.
Signed-off-by: Simon Wunderlich <siwu@hrz.tu-chemnitz.de>
Acked-by: Sven Eckelmann <sven.eckelmann@gmx.de>
Acked-by: Marek Lindner <lindner_marek@yahoo.de>
Acked-by: Linus Lüssing <linus.luessing@web.de>
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
|
|
B.A.T.M.A.N. (better approach to mobile ad-hoc networking) is
a routing protocol for multi-hop ad-hoc mesh networks. The
networks may be wired or wireless. See
http://www.open-mesh.org/ for more information and user space
tools.
This is the first submission for inclusion in staging.
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
|
Marek Lindner
Simon Wunderlich
Linus Lüssing
Andrew Lunn