From 17fd7a9d324fd3af613ddd76f0439481acaad23d Mon Sep 17 00:00:00 2001 From: Stefan Mavrodiev Date: Thu, 12 Jul 2018 11:21:53 +0300 Subject: drm/panel: Add support for Olimex LCD-OLinuXino panel This patch adds Olimex Ltd. LCD-OLinuXino bridge panel driver. The panel is used with different LCDs (currently from 480x272 to 1280x800). A small EEPROM chip is used for identification, which holds some factory data and timing requirements. Signed-off-by: Stefan Mavrodiev Reviewed-by: Rob Herring Signed-off-by: Thierry Reding Link: https://patchwork.freedesktop.org/patch/msgid/1531383729-13932-1-git-send-email-stefan@olimex.com --- .../display/panel/olimex,lcd-olinuxino.txt | 42 ++++++++++++++++++++++ 1 file changed, 42 insertions(+) create mode 100644 Documentation/devicetree/bindings/display/panel/olimex,lcd-olinuxino.txt (limited to 'Documentation/devicetree/bindings/display/panel/olimex,lcd-olinuxino.txt') diff --git a/Documentation/devicetree/bindings/display/panel/olimex,lcd-olinuxino.txt b/Documentation/devicetree/bindings/display/panel/olimex,lcd-olinuxino.txt new file mode 100644 index 000000000000..a89f9c830a85 --- /dev/null +++ b/Documentation/devicetree/bindings/display/panel/olimex,lcd-olinuxino.txt @@ -0,0 +1,42 @@ +Binding for Olimex Ltd. LCD-OLinuXino bridge panel. + +This device can be used as bridge between a host controller and LCD panels. +Currently supported LCDs are: + - LCD-OLinuXino-4.3TS + - LCD-OLinuXino-5 + - LCD-OLinuXino-7 + - LCD-OLinuXino-10 + +The panel itself contains: + - AT24C16C EEPROM holding panel identification and timing requirements + - AR1021 resistive touch screen controller (optional) + - FT5x6 capacitive touch screnn controller (optional) + - GT911/GT928 capacitive touch screen controller (optional) + +The above chips share same I2C bus. The EEPROM is factory preprogrammed with +device information (id, serial, etc.) and timing requirements. + +Touchscreen bingings can be found in these files: + - input/touchscreen/goodix.txt + - input/touchscreen/edt-ft5x06.txt + - input/touchscreen/ar1021.txt + +Required properties: + - compatible: should be "olimex,lcd-olinuxino" + - reg: address of the configuration EEPROM, should be <0x50> + - power-supply: phandle of the regulator that provides the supply voltage + +Optional properties: + - enable-gpios: GPIO pin to enable or disable the panel + - backlight: phandle of the backlight device attacked to the panel + +Example: +&i2c2 { + panel@50 { + compatible = "olimex,lcd-olinuxino"; + reg = <0x50>; + power-supply = <®_vcc5v0>; + enable-gpios = <&pio 7 8 GPIO_ACTIVE_HIGH>; + backlight = <&backlight>; + }; +}; -- cgit v1.2.3-59-g8ed1b