From 4f2ebe00597c44f7dc6f88a052a2981ddcf6a0b6 Mon Sep 17 00:00:00 2001 From: Lucas Stach Date: Wed, 23 Jul 2014 19:52:38 +0200 Subject: PCI: designware: Parse bus-range property from devicetree This allows to explicitly specify the covered bus numbers in the devicetree, which will come in handy once we see a SoC with more than one PCIe host controller instance. Previously the driver relied on the behavior of pci_scan_root_bus() to fill in a range of 0x00-0xff if no valid range was found. We fall back to the same range if no valid DT entry was found to keep backwards compatibility, but now do it explicitly. [bhelgaas: use %pR in error message to avoid duplication] Signed-off-by: Lucas Stach Signed-off-by: Bjorn Helgaas Reviewed-by: Pratyush Anand Acked-by: Mohit Kumar --- Documentation/devicetree/bindings/pci/designware-pcie.txt | 3 +++ 1 file changed, 3 insertions(+) (limited to 'Documentation/devicetree/bindings/pci/designware-pcie.txt') diff --git a/Documentation/devicetree/bindings/pci/designware-pcie.txt b/Documentation/devicetree/bindings/pci/designware-pcie.txt index ed0d9b9fff2b..9f4faa8e8d00 100644 --- a/Documentation/devicetree/bindings/pci/designware-pcie.txt +++ b/Documentation/devicetree/bindings/pci/designware-pcie.txt @@ -23,3 +23,6 @@ Required properties: Optional properties: - reset-gpio: gpio pin number of power good signal +- bus-range: PCI bus numbers covered (it is recommended for new devicetrees to + specify this property, to keep backwards compatibility a range of 0x00-0xff + is assumed if not present) -- cgit v1.2.3-59-g8ed1b