From f3f587995c5af69b92693c2f5d40e3448ab6113d Mon Sep 17 00:00:00 2001 From: Bhagavathi Perumal S Date: Thu, 20 Dec 2018 14:25:43 +0200 Subject: dt-bindings: net: ath10k: add new dt entry to identify external FEM This adds new dt entry ext-fem-name, it is used by ath10k driver to select correct timing parameters and configure it in target wifi hardware. The Front End Module(FEM) normally includes tx power amplifier(PA) and rx low noise amplifier(LNA). The default timing parameters like tx end to PA off timing values were fine tuned for internal FEM used in reference design. And these timing values can not be same if ODM modifies hardware design with different external FEM. This DT entry helps to choose correct timing values in driver if different external FEM hardware used. Signed-off-by: Bhagavathi Perumal S Reviewed-by: Rob Herring Signed-off-by: Kalle Valo --- Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-) (limited to 'Documentation/devicetree/bindings') diff --git a/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt b/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt index bd6b276d078e..ae661e65354e 100644 --- a/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt +++ b/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt @@ -75,8 +75,14 @@ Optional properties: Usage: optional Value type: Definition: A list of phandle and IOMMU specifier pairs. +- ext-fem-name: + Usage: Optional + Value type: string + Definition: Name of external front end module used. Some valid FEM names + for example: "microsemi-lx5586", "sky85703-11" + and "sky85803" etc. -Example (to supply the calibration data alone): +Example (to supply PCI based wifi block details): In this example, the node is defined as child node of the PCI controller. @@ -91,6 +97,7 @@ pci { wifi@0,0 { reg = <0 0 0 0 0>; qcom,ath10k-calibration-data = [ 01 02 03 ... ]; + ext-fem-name = "microsemi-lx5586"; }; }; }; -- cgit v1.2.3-59-g8ed1b