From 3d2ddfdcf05f5f816f829f81858c54827d7be5b4 Mon Sep 17 00:00:00 2001 From: Laxman Dewangan Date: Fri, 17 Feb 2012 20:26:20 +0530 Subject: Documentation: gpio: Add details of open-drain/source configuration Adding details of open drain(open collector) and open source (open emitter) configuration of the gpio so that client can set the pin as open drain at the time of gpio request. Signed-off-by: Laxman Dewangan Reviwed-by: Mark Brown Acked-by: Linus Walleij Signed-off-by: Grant Likely --- Documentation/gpio.txt | 17 +++++++++++++++-- 1 file changed, 15 insertions(+), 2 deletions(-) (limited to 'Documentation/gpio.txt') diff --git a/Documentation/gpio.txt b/Documentation/gpio.txt index 792faa3c06cf..f783e7fed764 100644 --- a/Documentation/gpio.txt +++ b/Documentation/gpio.txt @@ -302,6 +302,8 @@ where 'flags' is currently defined to specify the following properties: * GPIOF_INIT_LOW - as output, set initial level to LOW * GPIOF_INIT_HIGH - as output, set initial level to HIGH + * GPIOF_OPEN_DRAIN - gpio pin is open drain type. + * GPIOF_OPEN_SOURCE - gpio pin is open source type. since GPIOF_INIT_* are only valid when configured as output, so group valid combinations as: @@ -310,8 +312,19 @@ combinations as: * GPIOF_OUT_INIT_LOW - configured as output, initial level LOW * GPIOF_OUT_INIT_HIGH - configured as output, initial level HIGH -In the future, these flags can be extended to support more properties such -as open-drain status. +When setting the flag as GPIOF_OPEN_DRAIN then it will assume that pins is +open drain type. Such pins will not be driven to 1 in output mode. It is +require to connect pull-up on such pins. By enabling this flag, gpio lib will +make the direction to input when it is asked to set value of 1 in output mode +to make the pin HIGH. The pin is make to LOW by driving value 0 in output mode. + +When setting the flag as GPIOF_OPEN_SOURCE then it will assume that pins is +open source type. Such pins will not be driven to 0 in output mode. It is +require to connect pull-down on such pin. By enabling this flag, gpio lib will +make the direction to input when it is asked to set value of 0 in output mode +to make the pin LOW. The pin is make to HIGH by driving value 1 in output mode. + +In the future, these flags can be extended to support more properties. Further more, to ease the claim/release of multiple GPIOs, 'struct gpio' is introduced to encapsulate all three fields as: -- cgit v1.2.3-59-g8ed1b