From 38e2bfc94e95dd6005fdaf40dfec0157396741da Mon Sep 17 00:00:00 2001 From: Pete Zaitcev Date: Mon, 18 Sep 2006 22:49:02 -0700 Subject: USB: Dealias -110 code (more complete) The purpose of this patch is to split off the case when a device does not reply on the lower level (which is reported by HC hardware), and a case when the device accepted the request, but does not reply at upper level. This redefinition allows to diagnose issues easier, without asking the user if the -110 happened "immediately". The usbmon splits such cases already thanks to its timestamp, but it's not always available. I adjusted all drivers which I found affected (by searching for "urb"). Out of tree drivers may suffer a little bit, but I do not expect much breakage. At worst they may print a few messages. Signed-off-by: Pete Zaitcev Signed-off-by: Greg Kroah-Hartman --- Documentation/usb/error-codes.txt | 11 ++++------- 1 file changed, 4 insertions(+), 7 deletions(-) (limited to 'Documentation/usb') diff --git a/Documentation/usb/error-codes.txt b/Documentation/usb/error-codes.txt index 867f4c38f356..39c68f8c4e6c 100644 --- a/Documentation/usb/error-codes.txt +++ b/Documentation/usb/error-codes.txt @@ -98,13 +98,13 @@ one or more packets could finish before an error stops further endpoint I/O. error, a failure to respond (often caused by device disconnect), or some other fault. --ETIMEDOUT (**) No response packet received within the prescribed +-ETIME (**) No response packet received within the prescribed bus turn-around time. This error may instead be reported as -EPROTO or -EILSEQ. - Note that the synchronous USB message functions - also use this code to indicate timeout expired - before the transfer completed. +-ETIMEDOUT Synchronous USB message functions use this code + to indicate timeout expired before the transfer + completed, and no other error was reported by HC. -EPIPE (**) Endpoint stalled. For non-control endpoints, reset this status with usb_clear_halt(). @@ -163,6 +163,3 @@ usb_get_*/usb_set_*(): usb_control_msg(): usb_bulk_msg(): -ETIMEDOUT Timeout expired before the transfer completed. - In the future this code may change to -ETIME, - whose definition is a closer match to this sort - of error. -- cgit v1.2.3-59-g8ed1b