From a85b9e0b3ccf4a90cd42f41fdfff1fc91513720c Mon Sep 17 00:00:00 2001 From: "Andrew F. Davis" Date: Mon, 25 Jan 2016 09:50:10 -0600 Subject: Documentation: tps65086: Add DT bindings for the TPS65086 PMIC The TPS65086 PMIC contains several regulators and a GPO controller. Add bindings for the TPS65086 PMIC. Signed-off-by: Andrew F. Davis Acked-by: Rob Herring Signed-off-by: Lee Jones --- Documentation/devicetree/bindings/mfd/tps65086.txt | 55 ++++++++++++++++++++++ 1 file changed, 55 insertions(+) create mode 100644 Documentation/devicetree/bindings/mfd/tps65086.txt (limited to 'Documentation') diff --git a/Documentation/devicetree/bindings/mfd/tps65086.txt b/Documentation/devicetree/bindings/mfd/tps65086.txt new file mode 100644 index 000000000000..d3705612a846 --- /dev/null +++ b/Documentation/devicetree/bindings/mfd/tps65086.txt @@ -0,0 +1,55 @@ +* TPS65086 Power Management Integrated Circuit (PMIC) bindings + +Required properties: + - compatible : Should be "ti,tps65086". + - reg : I2C slave address. + - interrupt-parent : Phandle to the parent interrupt controller. + - interrupts : The interrupt line the device is connected to. + - interrupt-controller : Marks the device node as an interrupt controller. + - #interrupt-cells : The number of cells to describe an IRQ, should be 2. + The first cell is the IRQ number. + The second cell is the flags, encoded as trigger + masks from ../interrupt-controller/interrupts.txt. + - gpio-controller : Marks the device node as a GPIO Controller. + - #gpio-cells : Should be two. The first cell is the pin number and + the second cell is used to specify flags. + See ../gpio/gpio.txt for more information. + - regulators: : List of child nodes that specify the regulator + initialization data. Child nodes must be named + after their hardware counterparts: buck[1-6], + ldoa[1-3], swa1, swb[1-2], and vtt. Each child + node is defined using the standard binding for + regulators and the optional regulator properties + defined below. + +Optional regulator properties: + - ti,regulator-step-size-25mv : This is applicable for buck[1,2,6], set this + if the regulator is factory set with a 25mv + step voltage mapping. + - ti,regulator-decay : This is applicable for buck[1-6], set this if + the output needs to decay, default is for + the output to slew down. + +Example: + + pmic: tps65086@5e { + compatible = "ti,tps65086"; + reg = <0x5e>; + interrupt-parent = <&gpio1>; + interrupts = <28 IRQ_TYPE_LEVEL_LOW>; + interrupt-controller; + #interrupt-cells = <2>; + gpio-controller; + #gpio-cells = <2>; + + regulators { + buck1 { + regulator-name = "vcc1"; + regulator-min-microvolt = <1600000>; + regulator-max-microvolt = <1600000>; + regulator-boot-on; + ti,regulator-decay; + ti,regulator-step-size-25mv; + }; + }; + }; -- cgit v1.2.3-59-g8ed1b