From 6b61f2497852b7d27e1c024d966c09defbf99948 Mon Sep 17 00:00:00 2001 From: Marcin Wojtas Date: Thu, 15 Oct 2015 18:25:44 +0200 Subject: ARM: mvebu: set SW polling as SDHCI card detection on A388-GP The newest revisions of A388-GP (v1.5 and higher) support only DAT3-based card detection. Revisions < v1.5 based on GPIO detection via I2C expander, but this solution is supposed to be deprecated on new boards. In order to satisfy all type of hardware this commit changes card detection to use software polling mechanism. Also a comment is added on possible card detection options in A388-GP DT board file. Signed-off-by: Marcin Wojtas Acked-by: Andrew Lunn Signed-off-by: Gregory CLEMENT --- arch/arm/boot/dts/armada-388-gp.dts | 15 ++++++++++++++- 1 file changed, 14 insertions(+), 1 deletion(-) (limited to 'arch/arm/boot/dts/armada-388-gp.dts') diff --git a/arch/arm/boot/dts/armada-388-gp.dts b/arch/arm/boot/dts/armada-388-gp.dts index 4baac9329f3d..a633be3defda 100644 --- a/arch/arm/boot/dts/armada-388-gp.dts +++ b/arch/arm/boot/dts/armada-388-gp.dts @@ -207,8 +207,21 @@ sdhci@d8000 { pinctrl-names = "default"; pinctrl-0 = <&sdhci_pins>; - cd-gpios = <&expander0 5 GPIO_ACTIVE_LOW>; no-1-8-v; + /* + * A388-GP board v1.5 and higher replace + * hitherto card detection method based on GPIO + * with the one using DAT3 pin. As they are + * incompatible, software-based polling is + * enabled with 'broken-cd' property. For boards + * older than v1.5 it can be replaced with: + * 'cd-gpios = <&expander0 5 GPIO_ACTIVE_LOW>;', + * whereas for the newer ones following can be + * used instead: + * 'dat3-cd;' + * 'cd-inverted;' + */ + broken-cd; wp-inverted; bus-width = <8>; status = "okay"; -- cgit v1.2.3-59-g8ed1b