From 0a10e85b6c546c2f34ee257b955f33dbb4ece746 Mon Sep 17 00:00:00 2001 From: Jon Hunter Date: Wed, 24 Aug 2016 15:14:38 +0200 Subject: ARM: tegra: Correct polarity for Tegra114 PMIC interrupt The ARM GIC only supports interrupts with either level-high or rising-edge types for SPIs. The interrupt type for the Palmas PMIC used for Tegra114 boards is specified as level-low which is invalid for the GIC. This has gone undetected because until recently, failures to set the interrupt type when the interrupts are mapped via firmware (such as device-tree) have not been reported. Since commits 4b357daed698 ("genirq: Look-up trigger type if not specified by caller") and 1e2a7d78499e ("irqdomain: Don't set type when mapping an IRQ"), failure to set the interrupt type will cause the requesting of the interrupt to fail and exposing incorrectly configured interrupts. Please note that although the interrupt type was never being set for the Palmas PMIC, it was still working fine, because the default type setting for the interrupt, 'level-high', happen to match the correct type for the interrupt. Finally, it should be noted that the Palmas interrupt from the PMIC is actually 'level-low', however, this interrupt signal is inverted by the Tegra PMC and so the GIC actually sees a 'level-high' interrupt which is what should be specified in the device-tree interrupt specifier. Signed-off-by: Jon Hunter Signed-off-by: Thierry Reding Signed-off-by: Olof Johansson --- arch/arm/boot/dts/tegra114-roth.dts | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) (limited to 'arch/arm/boot/dts/tegra114-roth.dts') diff --git a/arch/arm/boot/dts/tegra114-roth.dts b/arch/arm/boot/dts/tegra114-roth.dts index 70cf40996c3f..966a7fc044af 100644 --- a/arch/arm/boot/dts/tegra114-roth.dts +++ b/arch/arm/boot/dts/tegra114-roth.dts @@ -802,7 +802,7 @@ palmas: pmic@58 { compatible = "ti,palmas"; reg = <0x58>; - interrupts = ; + interrupts = ; #interrupt-cells = <2>; interrupt-controller; -- cgit v1.2.3-59-g8ed1b