From 87353d8ac39c52784da605ecbe965ecdfad609ad Mon Sep 17 00:00:00 2001 From: Ralf Baechle Date: Mon, 19 Nov 2007 12:23:51 +0000 Subject: [MIPS] SMP: Call platform methods via ops structure. Signed-off-by: Ralf Baechle --- arch/mips/kernel/smp-mt.c | 193 +++++++++++++++++++++++++--------------------- 1 file changed, 106 insertions(+), 87 deletions(-) (limited to 'arch/mips/kernel/smp-mt.c') diff --git a/arch/mips/kernel/smp-mt.c b/arch/mips/kernel/smp-mt.c index 2ab0b7eeaa7e..89e6f6aa5166 100644 --- a/arch/mips/kernel/smp-mt.c +++ b/arch/mips/kernel/smp-mt.c @@ -215,72 +215,67 @@ static void __init smp_tc_init(unsigned int tc, unsigned int mvpconf0) write_tc_c0_tchalt(TCHALT_H); } -/* - * Common setup before any secondaries are started - * Make sure all CPU's are in a sensible state before we boot any of the - * secondarys - */ -void __init plat_smp_setup(void) +static void vsmp_send_ipi_single(int cpu, unsigned int action) { - unsigned int mvpconf0, ntc, tc, ncpu = 0; - unsigned int nvpe; + int i; + unsigned long flags; + int vpflags; -#ifdef CONFIG_MIPS_MT_FPAFF - /* If we have an FPU, enroll ourselves in the FPU-full mask */ - if (cpu_has_fpu) - cpu_set(0, mt_fpu_cpumask); -#endif /* CONFIG_MIPS_MT_FPAFF */ - if (!cpu_has_mipsmt) - return; + local_irq_save(flags); - /* disable MT so we can configure */ - dvpe(); - dmt(); + vpflags = dvpe(); /* cant access the other CPU's registers whilst MVPE enabled */ - /* Put MVPE's into 'configuration state' */ - set_c0_mvpcontrol(MVPCONTROL_VPC); + switch (action) { + case SMP_CALL_FUNCTION: + i = C_SW1; + break; - mvpconf0 = read_c0_mvpconf0(); - ntc = (mvpconf0 & MVPCONF0_PTC) >> MVPCONF0_PTC_SHIFT; + case SMP_RESCHEDULE_YOURSELF: + default: + i = C_SW0; + break; + } - nvpe = ((mvpconf0 & MVPCONF0_PVPE) >> MVPCONF0_PVPE_SHIFT) + 1; - smp_num_siblings = nvpe; + /* 1:1 mapping of vpe and tc... */ + settc(cpu); + write_vpe_c0_cause(read_vpe_c0_cause() | i); + evpe(vpflags); - /* we'll always have more TC's than VPE's, so loop setting everything - to a sensible state */ - for (tc = 0; tc <= ntc; tc++) { - settc(tc); + local_irq_restore(flags); +} - smp_tc_init(tc, mvpconf0); - ncpu = smp_vpe_init(tc, mvpconf0, ncpu); - } +static void vsmp_send_ipi_mask(cpumask_t mask, unsigned int action) +{ + unsigned int i; - /* Release config state */ - clear_c0_mvpcontrol(MVPCONTROL_VPC); + for_each_cpu_mask(i, mask) + vsmp_send_ipi_single(i, action); +} - /* We'll wait until starting the secondaries before starting MVPE */ +static void __cpuinit vsmp_init_secondary(void) +{ + /* Enable per-cpu interrupts */ - printk(KERN_INFO "Detected %i available secondary CPU(s)\n", ncpu); + /* This is Malta specific: IPI,performance and timer inetrrupts */ + write_c0_status((read_c0_status() & ~ST0_IM ) | + (STATUSF_IP0 | STATUSF_IP1 | STATUSF_IP6 | STATUSF_IP7)); } -void __init plat_prepare_cpus(unsigned int max_cpus) +static void __cpuinit vsmp_smp_finish(void) { - mips_mt_set_cpuoptions(); - - /* set up ipi interrupts */ - if (cpu_has_vint) { - set_vi_handler(MIPS_CPU_IPI_RESCHED_IRQ, ipi_resched_dispatch); - set_vi_handler(MIPS_CPU_IPI_CALL_IRQ, ipi_call_dispatch); - } + write_c0_compare(read_c0_count() + (8* mips_hpt_frequency/HZ)); - cpu_ipi_resched_irq = MIPS_CPU_IRQ_BASE + MIPS_CPU_IPI_RESCHED_IRQ; - cpu_ipi_call_irq = MIPS_CPU_IRQ_BASE + MIPS_CPU_IPI_CALL_IRQ; +#ifdef CONFIG_MIPS_MT_FPAFF + /* If we have an FPU, enroll ourselves in the FPU-full mask */ + if (cpu_has_fpu) + cpu_set(smp_processor_id(), mt_fpu_cpumask); +#endif /* CONFIG_MIPS_MT_FPAFF */ - setup_irq(cpu_ipi_resched_irq, &irq_resched); - setup_irq(cpu_ipi_call_irq, &irq_call); + local_irq_enable(); +} - set_irq_handler(cpu_ipi_resched_irq, handle_percpu_irq); - set_irq_handler(cpu_ipi_call_irq, handle_percpu_irq); +static void vsmp_cpus_done(void) +{ } /* @@ -291,7 +286,7 @@ void __init plat_prepare_cpus(unsigned int max_cpus) * (unsigned long)idle->thread_info the gp * assumes a 1:1 mapping of TC => VPE */ -void __cpuinit prom_boot_secondary(int cpu, struct task_struct *idle) +static void __cpuinit vsmp_boot_secondary(int cpu, struct task_struct *idle) { struct thread_info *gp = task_thread_info(idle); dvpe(); @@ -325,57 +320,81 @@ void __cpuinit prom_boot_secondary(int cpu, struct task_struct *idle) evpe(EVPE_ENABLE); } -void __cpuinit prom_init_secondary(void) -{ - /* Enable per-cpu interrupts */ - - /* This is Malta specific: IPI,performance and timer inetrrupts */ - write_c0_status((read_c0_status() & ~ST0_IM ) | - (STATUSF_IP0 | STATUSF_IP1 | STATUSF_IP6 | STATUSF_IP7)); -} - -void __cpuinit prom_smp_finish(void) +/* + * Common setup before any secondaries are started + * Make sure all CPU's are in a sensible state before we boot any of the + * secondarys + */ +static void __init vsmp_smp_setup(void) { - write_c0_compare(read_c0_count() + (8* mips_hpt_frequency/HZ)); + unsigned int mvpconf0, ntc, tc, ncpu = 0; + unsigned int nvpe; #ifdef CONFIG_MIPS_MT_FPAFF /* If we have an FPU, enroll ourselves in the FPU-full mask */ if (cpu_has_fpu) - cpu_set(smp_processor_id(), mt_fpu_cpumask); + cpu_set(0, mt_fpu_cpumask); #endif /* CONFIG_MIPS_MT_FPAFF */ + if (!cpu_has_mipsmt) + return; - local_irq_enable(); -} + /* disable MT so we can configure */ + dvpe(); + dmt(); -void prom_cpus_done(void) -{ -} + /* Put MVPE's into 'configuration state' */ + set_c0_mvpcontrol(MVPCONTROL_VPC); -void core_send_ipi(int cpu, unsigned int action) -{ - int i; - unsigned long flags; - int vpflags; + mvpconf0 = read_c0_mvpconf0(); + ntc = (mvpconf0 & MVPCONF0_PTC) >> MVPCONF0_PTC_SHIFT; - local_irq_save(flags); + nvpe = ((mvpconf0 & MVPCONF0_PVPE) >> MVPCONF0_PVPE_SHIFT) + 1; + smp_num_siblings = nvpe; - vpflags = dvpe(); /* cant access the other CPU's registers whilst MVPE enabled */ + /* we'll always have more TC's than VPE's, so loop setting everything + to a sensible state */ + for (tc = 0; tc <= ntc; tc++) { + settc(tc); - switch (action) { - case SMP_CALL_FUNCTION: - i = C_SW1; - break; + smp_tc_init(tc, mvpconf0); + ncpu = smp_vpe_init(tc, mvpconf0, ncpu); + } - case SMP_RESCHEDULE_YOURSELF: - default: - i = C_SW0; - break; + /* Release config state */ + clear_c0_mvpcontrol(MVPCONTROL_VPC); + + /* We'll wait until starting the secondaries before starting MVPE */ + + printk(KERN_INFO "Detected %i available secondary CPU(s)\n", ncpu); +} + +static void __init vsmp_prepare_cpus(unsigned int max_cpus) +{ + mips_mt_set_cpuoptions(); + + /* set up ipi interrupts */ + if (cpu_has_vint) { + set_vi_handler(MIPS_CPU_IPI_RESCHED_IRQ, ipi_resched_dispatch); + set_vi_handler(MIPS_CPU_IPI_CALL_IRQ, ipi_call_dispatch); } - /* 1:1 mapping of vpe and tc... */ - settc(cpu); - write_vpe_c0_cause(read_vpe_c0_cause() | i); - evpe(vpflags); + cpu_ipi_resched_irq = MIPS_CPU_IRQ_BASE + MIPS_CPU_IPI_RESCHED_IRQ; + cpu_ipi_call_irq = MIPS_CPU_IRQ_BASE + MIPS_CPU_IPI_CALL_IRQ; - local_irq_restore(flags); + setup_irq(cpu_ipi_resched_irq, &irq_resched); + setup_irq(cpu_ipi_call_irq, &irq_call); + + set_irq_handler(cpu_ipi_resched_irq, handle_percpu_irq); + set_irq_handler(cpu_ipi_call_irq, handle_percpu_irq); } + +struct plat_smp_ops vsmp_smp_ops = { + .send_ipi_single = vsmp_send_ipi_single, + .send_ipi_mask = vsmp_send_ipi_mask, + .init_secondary = vsmp_init_secondary, + .smp_finish = vsmp_smp_finish, + .cpus_done = vsmp_cpus_done, + .boot_secondary = vsmp_boot_secondary, + .smp_setup = vsmp_smp_setup, + .prepare_cpus = vsmp_prepare_cpus, +}; -- cgit v1.2.3-59-g8ed1b