From c374e00e17f1c10768d5af922a1ff33e43df2eb0 Mon Sep 17 00:00:00 2001 From: Scott Wood Date: Mon, 16 Jul 2007 11:43:43 -0500 Subject: [POWERPC] Add early debug console for CPM serial ports. This code assumes that the ports have been previously set up, with buffers in DPRAM. Signed-off-by: Scott Wood Acked-by: David Gibson Signed-off-by: Kumar Gala --- arch/powerpc/Kconfig.debug | 21 +++++++++++++++++++++ 1 file changed, 21 insertions(+) (limited to 'arch/powerpc/Kconfig.debug') diff --git a/arch/powerpc/Kconfig.debug b/arch/powerpc/Kconfig.debug index c38bc2237057..f4e5d22312a0 100644 --- a/arch/powerpc/Kconfig.debug +++ b/arch/powerpc/Kconfig.debug @@ -221,6 +221,15 @@ config PPC_EARLY_DEBUG_44x Select this to enable early debugging for IBM 44x chips via the inbuilt serial port. +config PPC_EARLY_DEBUG_CPM + bool "Early serial debugging for Freescale CPM-based serial ports" + depends on SERIAL_CPM + select PIN_TLB if PPC_8xx + help + Select this to enable early debugging for Freescale chips + using a CPM-based serial port. This assumes that the bootwrapper + has run, and set up the CPM in a particular way. + endchoice config PPC_EARLY_DEBUG_44x_PHYSLOW @@ -233,4 +242,16 @@ config PPC_EARLY_DEBUG_44x_PHYSHIGH depends PPC_EARLY_DEBUG_44x default "0x1" +config PPC_EARLY_DEBUG_CPM_ADDR + hex "CPM UART early debug transmit descriptor address" + depends on PPC_EARLY_DEBUG_CPM + default "0xfa202808" if PPC_EP88XC + default "0xf0000808" if CPM2 + default "0xff002808" if CPM1 + help + This specifies the address of the transmit descriptor + used for early debug output. Because it is needed before + platform probing is done, all platforms selected must + share the same address. + endmenu -- cgit v1.2.3-59-g8ed1b